[pt] Para suportar os requisitos das redes móveis de 5a geração (5G), os sistemas de comunicação óptica serão usados nas redes de acesso. Isso ocorre porque a evolução das RAN (Radio Access Networks) incluem a centralização do equipamento mais crítico para implantar pontos de acesso móveis de baixa potência, como DAS (Distributed Antenna Systems) e Small Cells. Os serviços emergentes solicitam a implantação de tecnologias de rádio sobre fibra com ênfase na eficiência de largura de banda, eficiência energética e alta confiabilidade. Neste âmbito, um monitoramento eficiente da camada física é imperativo para a operação dessas redes. O sistema de monitoramento deve fornecer uma localização de falhas em serviço, econômico, centralizado e com impacto mínimo para a transmissão de dados. Esta tese propõe vários sistemas de monitoramento incorporado no transceptor utilizando reflectometria óptica no domínio do tempo. Os sistemas de monitoramento são testados em diferentes sistemas de transmissão de dados e arquiteturas de rede, onde é apresentada uma validação simulada e outras experimentais. / [en] In order to support the requirements for 5th generation mobile networks (5G), optical communication systems will be used in the access part of the network. This is because the evolution of radio access networks includes the centralization of the most critical equipment in order to deploy low power mobile access points, like distributed antenna systems and small cells. The emerging services call for the deployment of radio over fibre technologies with emphasis on bandwidth efficiency, energy efficiency and high reliability. Within this scope, an efficient monitoring of the physical layer would become essential for the operation of these networks. The monitoring system should provide in-service, cost efficient and centralized fault localization with minimum impact on data transmission. This thesis proposes several transceiver-embedded optical time domain reflectometry monitoring systems. The monitoring systems are tested over different data transmission systems and network architectures, where one architecture was simulated and several others experimentally validated.

The dissertation thesis deals with the investigation of the coexistence of GSM–EDGE and UMTS systems with focus on the physical layer of the systems. The aim is to provide a set of recommendations for practical cooperation while the systems operate in both the separated and the common radio bands. A detailed description of signal processing of both the systems on the physical layer is presented. On the basis of this description, models of both systems were created and implemented in the MATLAB environment. The simulations are focused on the physical layer quality parameters, especially the bit error ratio evaluation for various ratios of useful signal power to noise power during the transmission over the radio channel. Simulation is also used to examine the quality of received useful signal while it is interfered by signals from the same and adjacent channels. The purpose is to determine the isolation between these adjacent channels, when the bit error ratio of the useful signal does not exceed a certain reference value. The simulation results are subsequently subjected to comparison with the results of the experimental measurements in laboratory conditions. Before the measurements are carried out, a study of possible interference types is performed. Consequently, the crucial parameters of the measuring equipment used are verified. From the results of simulations and measurements, the proposal of a minimum and recommended carrier separation between both the systems is presented in order to efficiently utilize the assigned frequency spectrum. Furthermore, for the cooperation in both the separated and the common radio bands, the necessary precautions are given for reaching the required isolation and thereby inter-system interference minimization.