Remediation of heavy metals from industrial effluents and ground water sources poses a significant challenge. Hexavalent chromium is one such heavy metal, prevalent in industrial wastewaters, which has been proven to be toxic to humans and other living organisms. Most of the conventional methods available for dealing with chromium are either cost prohibitive or generate secondary effluents which are difficult to deal with. The idea of bioremediation has gained much momentum over the last few decades because of its potential low cost and minimum impact on the environment. This study explored the potential for hexavalent chromium bioremediation using a synthetic cationic biopolymer alpha-poly-l-lysine (alpha-PLL) as a biosorbent. In the present research work, equilibrium batch studies were performed in a specially designed dialysis apparatus to obtain preliminary information about the adsorption capacity of the polymer. Metal uptake by the polymer was found to be maximum when the pH of chromium solution (pH 4.6) and that of poly-lysine (pH 5.7) was not changed at the beginning of the experiment. Applying the Langmuir adsorption isotherm model showed that alpha-PLL has a maximum uptake capacity of 42.2 microgram Cr/mg alpha-PLL, and a binding constant of 1.2 microgram/mL +/- 10%. The metal uptake performance of the polymer was also evaluated in a Polymer Enhanced Diafiltration (PEDF) system. The polymer-metal complex was retained and concentrated by the PEDF set up using a tangential flow filtration membrane, while the clean filtrate flowed through. When 3.4 L of 10 mg/L chromium solution in the Cr2O72- form was processed using 300 mL of 2 gm/L PLL, the concentration of chromium in the permeate reached a maximum of 0.79 mg/L. When 30 mg/L chromium solution was used, 2 L could be processed using 300 mL of 2gm/L PLL, and 7.8 mg/L chromium could be detected in the permeate in the end.

Discharge of metal containing effluents into water has been a cause of major concern. Traditional treatment methods are proving to be ineffective and expensive. Chitosan was studied as a potential biosorbent due to its positive charge and relatively low cost. The study involves evaluating the metal binding performance of chitosan in a polymer enhanced diafiltration (PEDF) system which uses an ultrafiltration membrane to retain the chitosan which, in turn, binds the metal, thereby preventing passage into the permeate stream. Conditions for binding such as pH, concentration of polymer and chromium were studied. Optimal performance was obtained when the system was operated at pH values lower then the pKa of chitosan i.e. 6.3. Using 6 g/L chitosan at pH 4.0, chromium concentration was reduced to less than 1mg/L from a feed concentration of 20 mg/L. Equilibrium dialysis experiments were done to study the kinetics of binding and the uptake of metal per gram of polymer. Rheological measurements demonstrated that in the presence of 1-100 mM chromate, chitosan was found to be slightly shear-thickening at low concentrations such as 4 g/L and 6 g/L whereas it was slightly shear-thinning at higher concentrations like 12 g/L and 20 g/L This suggests that neutralization of chromium anions is due to the interaction of multiple chitosan molecules. This result is consistent with the relatively stiff nature of the polysaccharide. Overall, this study suggests that some modification of the native polymer would be required to improve uptake and make it an industrially workable process.