<p> Experiments were performed to investigate the effect that a gap between a heated fin and a porous plate has on the heat transfer performance of a simulated capillary evaporator. The heat transfer performance was examined for two porous plates with average pore radii of 50 and 200 μm respectively. Tests were performed for gap distances between 0 and 900 μm and heat fluxes ranging from 17 to 260 kW/m^2. The heat transfer performance of the simulated capillary evaporator initially increased as the gap distance was increased. However, a further increase in the gap distance caused a decrease in performance. The maximum heat transfer performance occurred at a smaller gap distance for the plate with the smaller pore radius. For small gap distances, persistent high temperature regions were observed on the surface of the heated foil that grew and became more frequent at higher heat fluxes. For larger gap distances, saturated regions that appeared on the foil at moderate heat fluxes suggest that microlayer evaporation may be taking place within the gap. At high heat fluxes, these saturated regions are no longer present, but the temperature of the heated foil remained stable.</p> <p> The heat transfer process in the porous media was examined using thermocouples embedded within the porous plates. These temperature measurements indicate that a two phase region forms within the porous plate for a pore radius of 200 μm. Little evidence of vapour was observed within the plate with a pore radius of 50 μm. In that case, there was more evidence of vapour present at the surface of the porous plate. There was less evidence of vapour at the surface of the porous plate for the larger gap distances, suggesting that the vapour escapes more easily through the gap at larger gap distances.</p> / Thesis / Master of Applied Science (MASc)

Tidal power, or the use of tides for electricity production, exists in many forms including tidal barrages, which exploit tidal head differentials, and turbines placed directly in regions with large tidal current velocities. The latter is actively being investigated in many countries around the world as a means of providing renewable and wholly predictable electricity (cf. wind, solar and wave power). The expansion of the in-stream tidal industry is hindered however by several factors including: turbine durability, deployment and maintenance costs, and the lack of abundant locations which meet the necessary current velocities for turbine start-up and economic power production. A new novel type of augmentation device, entitled the ‘Tidal Acceleration Structure’ or TAS (Canadian patent pending 2644792), has been proposed as a solution to the limited number of coastal regions which exhibit fast tidal currents. In preliminary investigations, the TAS, a simple Venturi section consisting of walls extending from the seafloor to above the high water mark in an hourglass shape, was found as able to more than double current velocities entering the device. The results indicated a significant advantage over other current channeling technologies and thus the need for more in-depth investigations. The main objective of the present study was to optimise the design of the TAS and to predict the power that a turbine placed within it could extract from flow. To do this, two principal methods were employed. Firstly, a 1:50 scale model of the TAS was tested and its shape optimised in a 1.5 m wide flume. Secondly, a 3D numerical model (ANSYS Fluent) was used for comparison with the experimental results. During the tests, a TAS configuration was found that could accelerate upstream velocities by a factor of 2.12. In separate tests, turbines were simulated using Actuator Disc Theory and porous plates. The TAS-plate combination was found to be able to extract up to 4.2 times more power from flow than the stand-alone plate, demonstrating that the TAS could provide turbines with a significant advantage in slower currents. Though further research is needed, including the testing of a larger TAS model in conjunction with a small in-stream turbine, the results of this thesis clearly demonstrate the potential of the TAS concept to unlock vast new areas for tidal energy development.