Thesis (M. S.)--Mechanical Engineering, Georgia Institute of Technology, 2009. / Committee Chair: Melkote, Shreyes; Committee Co-Chair: Danyluk, Steven; Committee Member: Graham, Samuel. Part of the SMARTech Electronic Thesis and Dissertation Collection.

No description available.

No description available.

No description available.

Tissue engineering (TE) integrates methods of cells, engineering and materials to improve or replace biological functions of native tissues or organs. 3D printing technologies have been used in TE to produce different kinds of tissues. Based on review of the exiting 3D printing technologies used in TE, special requirements of fabricating soft scaffolds are identified. Soft scaffolds provide a microenvironment with biocompatibility for living cells proliferation. This research focuses on 3D printer design and printing parameters investigation for fabrication of soft scaffolds. A 3D printer is proposed for producing artificial soft scaffolds, with components of a pneumatic dispenser, a temperature controller and a multi-nozzle changing system. Relations of 3D printing parameters are investigated to improve the printing quality of soft scaffolds. It provides guidance for printing customized bio-materials with improved efficiency and quality. In the research, printing parameters are identified and classified based on existing research solutions. A deposition model is established to analyze the parameters relations. Quantitative criteria of parameters are proposed to evaluate the printing quality. A series of experiments including factors experiments and comparison tests are conducted to find effects of parameters and their interactions. A case study is conducted to verify the analytic solution of proposed models. This research confirms that the hydrogel concentration and nozzle diameters have significant effects on the filament diameter. Factor interactions are mainly embodied in between the concentration of hydrogel solutions and dispensing pressures. Besides filament diameters, the nozzle height and space also affect the printing accuracy significantly. An appropriate nozzle height is considered to be 1.4 times than the nozzle diameter, and a reasonable nozzle space is suggested from 2.0 to 2.5 times of the nozzle diameter.

This thesis investigates inkjet printing of fully-integrated modules fabricated on organic substrates as a system-level solution for ultra-low-cost and eco-friendly mass production of wireless sensor modules. Prototypes are designed and implemented in both traditional FR-4 substrate and organic substrate. The prototype on organic substrate is referred to as a Smart Wireless Integrated Module (SWIM). Parallels are drawn between FR-4 manufacturing and inkjet printing technology, and recommendations are discussed to enable the potential of inkjet printing technology. Finally, this thesis presents novel applications of SWIM technology in the area of wearable and implantable electronics. Chapter 1 serves as an introduction to inkjet printing technology on organic substrates, wireless sensor networks (WSNs), and the requirements for low-power consumption, low-cost, and eco-friendly technology. Chapter 2 discusses the design of SWIM and its implementation using traditional manufacturing techniques on FR-4 substrate. Chapter 3 presents a benchmark prototype of SWIM on paper substrate. Challenges in the manufacturing process are addressed, and solutions are proposed which suggest future areas of research in inkjet printing technology. Chapter 4 presents novel applications of SWIM technology in the areas of implantable and wearable electronics. Chapter 5 concludes the thesis by discussing the importance of this work in creating a bridge between current inkjet printing technology and its future.

Typescript. / Thesis (Ph. D.)--University of Hawaii at Manoa, 1986. / Bibliography: leaves 370-375. / Photocopy. / xiv, 375 leaves bound maps 29 cm

Thesis (M.S.)--Rochester Institute of Technology, 1988. / Includes bibliographical references (leaves 53-54).

Thesis (M.S.)--Rochester Institute of Technology, 2007. / Typescript. Includes bibliographical references.

Licenciatavhandling Linköping : Linköpings universitet, 2005.