<p>Additive manufacturing of gun propellants is an emerging and promising field which addresses the limitations of conventional manufacturing techniques. Gun propellants are manufactured using wetted extrusion, which uses volatile solvents and dies of limited and constant geometries. On the other hand, additive techniques are faced with the challenges of maintaining the gun propellant’s energetic content as well as its structural integrity during high pressure combustion. The work presented in this thesis demonstrates the feasibility of producing functioning gun propellant grains using vibration-assisted 3D printing, a novel method which has been shown to extrude extremely viscous materials such as clays and propellant pastes. At first, the technique is compared to screw-driven additive methods which have been used in printing gun propellant pastes with slightly lower energetic content. In chapter two, diethylene glycol dinitrate (DEGDN), a highly energetic plasticizer, was investigated due to its potential to replace nitroglycerin in double base propellants with high nitroglycerin content. A novel isoconversional method was applied to analyze its decomposition kinetics. The ignition and lifetime values of diethylene glycol dinitrate were obtained using the new isoconversional method, in order to assess the safety of using the plasticizer in a modified double base propellant. In chapter three, a modified double base propellant (M8D) containing DEGDN was additively manufactured using VAP. The printed strands had little to no porosity, and their density was nearly equal to the theoretical maximum density of the mixture. The strands were burned at high pressures in a Crawford bomb and the burning was visualized using high speed cameras. The burning rate equation as a function of the M8D propellant as a function of pressure was obtained. Overall, this work shows that VAP is capable of printing highly energetic gun propellants with low solvent content, low porosity, with high printing speeds, and which have consistent burning characteristics at high pressures. </p>

<p dir="ltr">Burning rate as a function of pressure is one of the primary evaluation metrics of solid propellants. Most solid propellant burning rate measurements are made at a nearly constant pressure using a variety of measurement approaches. This type of burning rate data is highly discretized and requires many tests to accurately determine the burning rate response to pressure. It would be moreefficient to measure burning rate dynamically as pressures are varied. Techniques used to make transient burning rate measurements are reviewed briefly and initial results using a microwave interferometry (MI) technique are presented. The MI method used in tandem with a closed bomb enables nearly continuous measurement of burning rates for self-pressurizing burns, capturing burning rate data over a wide range of pressures. This approach is especially useful for characterization of propellants with complex burning behaviors (e.g., slope breaks or mesa burning). The burning rates of three research propellants were characterized over a pressure range of 0.101-24.14 MPa (14-3500 psi). One research propellant exhibited a slope break at a pressure of 6.63 MPa (960 psi). Using MI in a closed pressure vessel, 14 propellant strand burns resulted in a nearly continuous burning rate curve over a pressure range of 0.41-24.13MPa (60-3500psi) that reasonably matched conventional burning rate measurements. The development of this technique provides an opportunity to quickly characterize the burning rate curve of solid propellants with greater fidelity and efficiency than traditional quasi-static pressure testing techniques.</p>