The application of ionizing radiation as a preservation method for food is described and examined. The prospects and problems of introducing radiation technology for food preservation are discussed under the following aspects: (1) technical feasibilities; (2) irradiator design requirements; (3) facilities' cost analysis, and (4) legislation. Within the specified limits, ionizing radiation provides an efficacious food preservation treatment which will not lead to radioactivity induction or prejudice the safety and wholesomeness of the food. A brief introduction and description of the design approach of an industrial scale irradiator is given with an illustrative example. Assessments of the cost of radiation treatment of food of some commercially available irradiators are cited and analyzed. The international regulatory efforts and the present status of clearance, standardization and legislation of food irradiation is reviewed and discussed. It is concluded that food irradiation is ready for commercial applications and could be effectively regulated by pertinent health and safety authorities.

Thesis (M.S.)--West Virginia University, 2005. / Title from document title page. Document formatted into pages; contains vii, 59 p. : ill. Includes abstract. Includes bibliographical references (p. 56-58).

Thesis (Ph. D.)--Washington State University, August 2007. / Includes bibliographical references.

No description available.

The technical feasibility of ohmic heating was evaluated for viscous liquids in static ohmic heating cells in three stages. First, electrical conductivities and time/temperature profiles were measured and compared for selected hydrocolloids (carrageenan, gelatin, pectin, starch and xanthan) in water at various concentrations (1--6%). Of the thickening agents examined, carrageenan gave the highest value for electrical conductivity and the shortest time to raise the temperature from 20 to 100°C. It was followed by xanthan. Pectin and gelatin samples were found to exhibit lower, but similar electrical conductivities and heating profiles. Starch samples had the lowest electrical conductivity and the temperature of starch solutions never exceeded 62°C within the specified time limit of 10000 s. / In the second stage, the effect of salt and acid concentration was evaluated on electrical conductivities and time/temperature profiles of the above selected hydrocolloids in water solutions at a concentration necessary to achieve a similar apparent viscosity of 0.2 Pa.s at 300 s-1 and 20°C (carrageenan 1.7%, pectin 2.5%, starch 4.3% and xanthan 2%). / In the third stage, measurements of electrical conductivities, time/temperature and heating rate profiles were performed applying six voltage gradients (5.26, 7.14, 13.16, 17.86, 21.05 and 25 V/cm), with two electrode cross-sectional surface areas (19.84 and 37.95 cm2) and the electrodes separated at three specific distances (10.05, 14.33 and 20.01 cm) at 150 V. Applied voltage gradients had a major effect on temperature and heating rate profiles but no effect on electrical conductivities. / Rheological properties of carrageenan, pectin, starch and xanthan solutions were investigated at various temperatures (20--80°C) and concentrations (carrageenan 1.5, 1.7 and 1.9%; pectin 2.3, 2.5 and 2.7%; starch 3.8, 4 and 4.2%; xanthan 1.6, 1.8 and 2%) in the presence of 1% salt. Both temperature and concentration influenced the rheological properties of solutions. / Finally, electrical conductivity measurements and rheological properties of starch at 4% and 1% salt were used as input to evaluate a theoretical model for the electrical, thermal and flow behaviour in a continuous ohmic heating unit. (Abstract shortened by UMI.)

Thesis (Ph. D.)--Washington State University, May 2010. / Title from PDF title page (viewed on June 18, 2010). "Department of Biological Systems Engineering." Includes bibliographical references.

Ph.D. (Chemistry) / Please refer to full text to view abstract

Although radio-frequency (RF) methods have been used for decades in many heating and drying processes, there is still a need for more engineering design data related to the design of the applicators and the performance of these systems before costly prototypes are built. Energy, temperature, and the effect produced by the high frequency field parameters on biological materials need to be examined with regard to their effects on the resulting processing requirements. / Wheat-seed infection by a fungus such as Fusarium graminearum can considerably lower the seed germination and the quality of the harvest. A study was thus conducted to determine the combined effect of different levels of RF power, temperature, and moisture content on the quality of seed-grade wheat and fungus inactivation. Similar treatment combinations were studied with seed-grade soybean in view on improving germination. With higher power, higher temperature (90°C) and higher moisture content (14%), the fungus mortality significantly increased, with a fungal vigour of less than 0.1, and the germination quality of the seeds decreased to a germination vigour below 0.3. For soybean seeds, only treatments of low RF intensity (60°C) were successful in improving germination vigour especially at lowest moisture content typically found in stored seeds. / RF treated wheat was studied to identify the relationship between heating conditions and grain quality categorized in terms of kernel viability and structural damage. / The potential of an RF thermal treatment to improve and extend the storability of vacuum packaged carrot sticks was investigated. The results have shown that it is possible to treat carrot sticks to 60°C in less than 2 min to reduce the initial microbial load. The RF-treatments maintained colour, the vacuum of the packages, and the excellent taste of the carrot sticks. / RF heating was studied for the pasteurization of prepared samples of ham. The ham samples were brought to internal temperatures of 75 and 85°C, by RF heating with a 10 min residence time. The study indicates that radio-frequency heating can improve the storability of re-packed hams by reducing the bacterial load, reducing moisture loss during storage and maintaining an overall greater product quality. (Abstract shortened by UMI.)

Listeria monocytogenes is a common post-processing contaminant in ready-to-eat vacuum packaged (VP) cold smoked salmon. Since this psychrotrophic pathogen can grow at refrigerated temperatures (~4°C), other safety barriers in addition to temperature are needed to ensure the continued safety of VP cold smoked salmon. One such novel barrier could be the pulsed light (PL) treatment of the product prior to packaging or treating the product through a transparent package. / Pulsed light destruction kinetics of L. monocytogenes were evaluated while dispensed into a liquid media, on the surface of a general purpose agar and on the surface of cold smoked salmon. Results showed that PL technology was an effective surface sanitation method (a decimal reduction time or D-value of 0.91, 1.37 and 2.25 s exposure of PL at 800, 700 and 600 V, respectively, and a resulting z value of 500 V) on the agar plate. However, it had only a limited success when applied to liquid samples as well as directly on the surface of cold smoked salmon (D-value ranged from 93 s to 24 min). / Sensory quality of VP cold smoked salmon subjected to selected PL treatments was monitored during storage for 14 days at 4°C. Both color and odor scores remained within acceptable limits over the 14 day storage period. Subsequent challenge studies were carried out with L. monocytogenes applied on VP cold smoked salmon. An overall reduction in counts was observed in samples stored at 4°C over 28 days; however, after PL treatment (day 0), there was no significant reduction in counts. Color and odor scores maintained acceptable values over 14 days. Additional experiments were carried out to determine the effects of (1) 1.5% salt, (2) 6% oil, (3) a representative salmon media and (4) background microflora (lactic acid bacteria) on the PL inactivation of L. monocytogenes. All of these factors significantly affected the destruction of L. monocytogenes by increasing the D-value (adding resistance to pulsed light destruction). / Overall, these studies have shown that PL treatment in combination with low temperature storage (4°C) has the potential to extend the shelf-life of VP cold smoked salmon products without compromising sensory quality. However further investigation into higher treatment voltages is necessary in order to achieve a higher target kill of L. monocytogenes.

Ohmic heating is an electrical resistance heating resulting from the passage of electrical current through an electrically conductive material offering some resistance. Most food products possess sufficient electrical conductivity to be able to take advantage of ohmic heating. This research was undertaken to evaluate the quality changes associated with fine ham emulsions prepared under ohmic heating conditions as compared to those produced by conventional heating. / In the first part of the study, kinetics of quality changes (color, texture, water holding capacity, cooking loss and water activity) associated with fine ham emulsion subjected to conventional heating conditions were evaluated. The second part of the study was to standardize ohmic heating conditions for achieving target time-temperature combinations. It was desired to achieve cooking conditions (temperature come-up and hold times) both similar to and faster than conventional heating so that meaningful quality comparisons could be made between the two. / The final part of the study was to compare the quality changes of fine ham emulsion subjected to ohmic heating under different rates, and to compare them with conventional heating. (Abstract shortened by UMI.)