Reach truck masts are subjected to oscillations, which have significant impacts on the dynamics of the entire vehicle. Mast oscillations can cause undesirable outcomes in extreme situations and therefore it is desirable to be able to predict these outcomes before they occur. A forklift manufacturer in Mjölby initiated a thesis with the intention to obtain a model that can simulate mast sway for situations where oscillations occur. The objective of the thesis was to create a model of Triplex masts and find dependencies between model parameters and variables such as fork height and load. The thesis was conducted modelling the mast with a rigid multibody approach where torsion springs and dampers were used between mast parts to simulate mast elasticity. Clearance at the connections were considered and included in the model. The obtained model constitutes of 8 parameters that could be tuned to attain different oscillation characteristics. Parametric optimisation was carried out to find optimal sets of parameters for compliance with sway measurement tests with different load and fork height cases.  The thesis has resulted in a model that is able to simulate mast sway with different oscillation characteristics depending on model parameters. Performed parametric optimisation resulted in parameters that reveal useful information about how model parameters depend on load and fork height. The method used for obtaining optimal parameters can likewise be applied to other mast models in order to gain insight into model parameters as functions of load and fork height.

The implementation of an energy recovery system for retreiving otherways wasted energy is an effective method for reducing the overall energy consumption of a mobile machine. In a fork lift, there are two subsystems that can be effectively modified for recovering energy. These are the driveline and the lift/lower function of the mast. This study focuses on the latter by studying a recovery system whose main component is a hydraulic transformer consisting of a hydraulic motor, a variable displacement pump and an induction motor. Since the flow rate/pressure - ratio can be modified, the utilization of the hydraulic transformer enables downsizing of the accumulator volume. However, the decrease of the gas volume leads to an increase in the compression ratio of the accumulator, which in terms leads to higher gas temperatures after charging and consequently to higher thermal losses during holding phase. In order to reduce these losses, a thermally regenerative unit was implemented to the gas volume of an accumulator to reduce the temperature build up during charging. In this study, the effect of improving the thermal characteristics of the accumulator to the efficiency of the whole energy recovery system is investigated by means of measurements.

The implementation of an energy recovery system for retreiving otherways wasted energy is an effective method for reducing the overall energy consumption of a mobile machine. In a fork lift, there are two subsystems that can be effectively modified for recovering energy. These are the driveline and the lift/lower function of the mast. This study focuses on the latter by studying a recovery system whose main component is a hydraulic transformer consisting of a hydraulic motor, a variable displacement pump and an induction motor. Since the flow rate/pressure - ratio can be modified, the utilization of the hydraulic transformer enables downsizing of the accumulator volume. However, the decrease of the gas volume leads to an increase in the compression ratio of the accumulator, which in terms leads to higher gas temperatures after charging and consequently to higher thermal losses during holding phase. In order to reduce these losses, a thermally regenerative unit was implemented to the gas volume of an accumulator to reduce the temperature build up during charging. In this study, the effect of improving the thermal characteristics of the accumulator to the efficiency of the whole energy recovery system is investigated by means of measurements.