Thesis (M.S.)--University of Hawaii at Manoa, 2006. / Includes bibliographical references (leaves 36-38). / x, 38 leaves, bound ill., map 29 cm

Includes bibliographical references. / xxiv, 177 p. : ill. ; 30 cm. / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / The beneficial effects of tillage are often negated in Australian soils by poor aggregate structural stability. If irrigation or rain falls on exposed freshly tilled soil, crusting or hardsetting often develops on drying. Rainfall intensity, kinetic energy, rate of wetting, anticedent water contentand soil management history have been implicated in aggregate breakdown. / Thesis (Ph.D.)--University of Adelaide, Dept. of Soil Science, 1995

Copies of author's previously published articles in pocket inside back cover. / Bibliography: leaves 147-160. / xvi, 160 leaves, [6] leaves of plates : ill. ; 30 cm. / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / This thesis outlines the factors affecting soil strength and structural stability and their interrelationship in salt-affected soils. The objectives of this study are to investigate the influence of clay particles on soil densification and mellowing, the mellowing of compacted soils and soil aggregates as influenced by solution composition, the disaggregation of soils subjected to different sodicities and salinities and its relationship to soil strength and dispersible clay and the effect of organic matter and clay type on aggregation of salt-affected soils. / Thesis (Ph.D.)--University of Adelaide, Dept. of Soil Science, 1996

Bibliography: leaves 207-222 / xvi, 222 leaves : ill ; 30 cm. / Title page, contents and abstract only. The complete thesis in print form is available from the University Library. / Thesis (Ph.D.)--University of Adelaide, Dept. of Soil Science, 1987

Suction caissons are a foundation system for offshore structures which offer a number of advantages over traditional piled foundations. In particular, due to the method of installation used, they are well suited for deep-water applications. The suction caisson consists of an open ended cylindrical shell, which is installed below the seabed in a sequence which consists of two loading phases. The caisson is first installed part way under self weight, with the installation being completed by lowering the pressure within the cylinder and thus allowing the ambient water pressure to force the caisson into the ground. This thesis examines a number of structural issues which result from the form of the caisson — essentially a thin walled cylinder — and the interaction of the caisson with the surrounding soil during installation. To do this, variational analysis and nonlinear finite element analysis are employed to examine the buckling and collapse behaviour of these cylinders. In particular, two issues are considered; the influence of the open end, and the interaction between the cylinder and soil on the buckling and collapse loads. First, the behaviour of open ended cylinders is considered, where the boundary condition at the open end is allowed to vary continuously from completely free to pinned, by the use of a variable lateral spring. This lateral spring restraint may be considered to represent the intermediate restraint provided by a ring stiffener which is not fully effective. The effect of various combinations of boundary conditions is accounted for by the use of a multiplier on the lower bound to the buckling load of a cylinder with classical supports. The variable spring at the open end may also be considered to be an initial, simple representation of the effect of soil restraint on the buckling load. More complex representations of the soil restraint are also considered. A nondimensional factor is proposed to account for the influence of this spring on the buckling load. One combination of boundary conditions, where the upper end of the caisson is pinned, and the lower end free (referred to as a PF boundary condition), is found to have buckling and collapse behaviour which is unusual for cylindrical shells. Buckling loads for such shells are much lower than would be found for cylinders with more typical boundary conditions, and of similar dimensions. More unusually however, PF cylinders are shown to have positive postbuckling strength. The behaviour is found to be a result of the large flexibility which results from the low restraint provided by the PF boundary conditions. This is shown by continuously decreasing the flexibility of the cylinder, by increasing the axial restraint at the pinned end. It is shown that this results in a large increase in buckling load, and a return to more usual levels of imperfection sensitivity. In particular, with an intermediate level of axial restraint, buckling loads and imperfection sensitivity are intermediate between those of PF shells with no, and with full, axial restraint. Overall however, collapse loads for PF cylinders with no additional restraint are well below those of cylinders with stiffer boundary conditions, for equal geometries. Eigenvalue buckling of cylinders fully and partially embedded in an elastic material are examined, and two analytical solutions are proposed. One of these is an extension of a method previously proposed by Seide (1962), for core filled cylinders, to pin ended cylinders which have support from both a core and a surrounding material. The second method represents the elastic support as a two parameter foundation. While more approximate than the first method, this method allows for the examination of a wider range of boundary conditions, and of partial embedment. It is found that the buckling load of the shell/soil system decreases as the embedment ratio decreases. Collapse of fully and partially embedded cylinders is also examined, using nonlinear finite element analysis. The influence of plasticity in the soil is also considered. For cylinders with small imperfections, it is found that the collapse load shows a large increase over that of the same cylinder with no soil support. However, as the size of initial geometric imperfections increases, it is found that the collapse load rapidly approaches that of the unsupported cylinder. In particular, in weak soils the gain in strength over the unsupported shell may be minimal. The exception to this is again PF cylinders. As these have relatively low collapse loads, even very weak soils are able to offer an increase in collapse load over the unsupported case. Finally, a summary of these results is provided in the form of guidance for design of such structures.

Thesis (Ph. D.)--Oregon State University, 2009. / Printout. Includes bibliographical references (leaves 306-310). Also available on the World Wide Web.

Thesis (Ph. D.)--University of California, Riverside, 2009. / Includes abstract. Includes bibliographical references. Issued in print and online. Available via ProQuest Digital Dissertations.

Thesis (M. Phil.)--University of Hong Kong, 1994. / Some illustrations are mounted photos. Some illustrations accompanied by transparent guard sheets with outline drawings. Includes bibliographical references (leaves 234-244).

Thesis (M.S.)--Brigham Young University. Dept. of Civil and Environmental Engineering, 2007. / Includes bibliographical references (83-84).

Thesis (Ph.D)--Geosystems, Georgia Institute of Technology, 2010. / Committee Chair: Frost, J. David; Committee Member: Burns, Susan E.; Committee Member: Gokhale, Arun; Committee Member: Mayne, Paul W.; Committee Member: Rix, Glenn J. Part of the SMARTech Electronic Thesis and Dissertation Collection.