Spelling suggestions: "subject:"solid oxides"" "subject:"polid oxides""
1 |
High-pressure synthesis of electronic materialsPenny, George B. S. January 2010 (has links)
High-pressure techniques have become increasingly important in the synthesis of ceramic and metallic solids allowing the discovery of new materials with interesting properties. In this research dense solid oxides have been synthesised at high pressures, and structural investigations have been conducted using x-ray and neutron diffraction. The perovskite LaPdO3 has been synthesised at pressures of 6{10GPa. Neutron diffraction studies have been carried out from 7{260K to investigate any structural distortions, particularly related to the possibility of charge order at low temperatures. No reduction in symmetry associated with charge ordering has been observed; the material appears to remain metallic with only one unique Pd site down to 7K. LaPdO3 adopts the GdFeO3-type Pbnm structure. The PdO6 octahedra exhibit a tetragonal distortion throughout the temperature range with a shortening of the apical Pd{O bonds of 2:5% relative to the equatorial bonds. Attempts to prepare analogues of the perovskite containing smaller rare earths have resulted in multi-phase samples, and further RPdO3 perovskites remain inaccessible although there is evidence for a small amount of the perovskite phase in the products of synthesis attempts with neodymium. Three new oxypnictide superconductors, RFeAsO1 xFx (R = Tb, Dy and Ho) have been synthesised at 7{12GPa. The materials are isostructural with other recently discovered iron arsenide superconductors and have Tc's of 52:8 K, 48:5K and 36:2K respectively, demonstrating a downturn in Tc in the series for smaller R. Systematic studies on TbFeAsO0.9F0.1 and HoFeAsO0.9F0.1 show negative values of dTc=dV in contrast to those reported for early R containing materials. Low-temperature neutron diffraction measurements on both materials, and synchrotron studies on HoFeAsO0.9F0.1 reveal no tetragonal to orthorhombic transitions as observed in early R-containing materials with lower doping levels. Magnetic reflections are evident but they are shown to be from R2O3 and RAs impurities with TN's of 5:5K for Tb2O3, 6:5K for HoAs and 1:7K < TN < 4K for Ho2O3. The implications of these results for superconductivity in the iron arsenides are discussed.
|
2 |
Oxygen Transport Measured by Isotope Tracing through Solid OxidesWood, Thomas 31 May 2011 (has links)
The following thesis demonstrates two isotope tracing experiments that measure oxygen transport through electrochemically polarized solid oxides. Cathode-symmetric ‘button’ cells with yttria stabilized zirconia(YSZ) electrolytes and either strontium doped lanthanum manganate(LSM) or composite LSM/YSZ cathodes were studied. The first experiment measured the residence time distributions(RTD) of 34O2. The measured RTDs were compared at different temperatures(700-800°C) and applied potentials(-2 to -8V). Comparisons with simulated RTDs revealed that oxygen transport was laterally heterogeneous. Delamination of the counter electrode is likely the source of the heterogeneity. The second experiment measured a wave of 18O by exposing an interior cross section and applying ToF-SIMS analysis. A depth profile was produced that spans the cathode and electrolyte interface. The depth profile was compared with a variety of limiting oxygen activation scenarios predicted by a simple 1-D model. Comparisons demonstrated that oxygen activation is likely not restricted to the cathode and electrolyte interface.
|
3 |
Oxygen Transport Measured by Isotope Tracing through Solid OxidesWood, Thomas 31 May 2011 (has links)
The following thesis demonstrates two isotope tracing experiments that measure oxygen transport through electrochemically polarized solid oxides. Cathode-symmetric ‘button’ cells with yttria stabilized zirconia(YSZ) electrolytes and either strontium doped lanthanum manganate(LSM) or composite LSM/YSZ cathodes were studied. The first experiment measured the residence time distributions(RTD) of 34O2. The measured RTDs were compared at different temperatures(700-800°C) and applied potentials(-2 to -8V). Comparisons with simulated RTDs revealed that oxygen transport was laterally heterogeneous. Delamination of the counter electrode is likely the source of the heterogeneity. The second experiment measured a wave of 18O by exposing an interior cross section and applying ToF-SIMS analysis. A depth profile was produced that spans the cathode and electrolyte interface. The depth profile was compared with a variety of limiting oxygen activation scenarios predicted by a simple 1-D model. Comparisons demonstrated that oxygen activation is likely not restricted to the cathode and electrolyte interface.
|
4 |
Fyzikální analýza hlavních procesů v palivových článcích s pevnými oxidy a jejich matematická formulace / Physical analysis of the main processes in the solid oxide fuel cells and their mathematical descriptionVágner, Petr January 2014 (has links)
Solid oxide fuel cells (SOFC) are mainly used as large stationary elec- tricity sources, therefore an every little improvement in their performance leads to considerable savings. In order to understand the fundamentals of the SOFC operation, we have developed a new model describing the main physical processes. The thermodynamical model of SOFC, developed in this thesis, concerns the gas transport, the transport of the charged particles in- cluding the thermoelectric effect and the electrochemical reactions. Linear irreversible thermodynamics is the key modelling framework, in which the dusty gas model and the Butler-Volmer equations are used. A new relation between the electrochemical affinity and the overpotential is introduced into the Butler-Volmer equation. A weakly formulated statinonary system en- dowed with boundary conditions is solved with the finite element method in one dimensional approximation. 1
|
Page generated in 0.4653 seconds