The focus of this research project is to establish what effect graphitization has on the static mechanical properties of service exposed ASTM A516 Grade 65 steam pipe material, which operated for prolonged periods above 425 ̊C. The research study was conducted on three graphitized service exposed steam pipe weldment samples and on a newly welded and post weld heat treated sample with graphitized service exposed steam pipe material. Macro samples were removed from each of the samples at two positions and these were evaluated with regard to graphite nodule size, nearest neighbour spacing and % planar graphitization in the parent pipe and HAZ regions on either side of the welds. It was found on all of the service exposed samples that the graphite nodules of the HAZ regions have a smaller median nodule size, smaller median nearest neighbour spacing and increased % planar graphitization in comparison to the parent pipe material. The service expose parent pipe material on either side of the weldments of the respective samples was chemically analyzed. This was done with the focus being on the deoxidizing element content (Si and Al) of the respective parent pipe regions and to what extent these elements influenced the development of planar graphitization in these regions. No correlation could be identified between the level of deoxidizing elements and the levels of % planar graphitization in the parent pipe material. Tensile and Charpy impact samples were removed from the respective service exposed samples parent material on either side of the weld and from the HAZ regions on the side with the highest levels of planar graphitization. These samples were tested and the yield and ultimate tensile strength and Charpy impact toughness of the respective samples were then evaluated to establish how these static mechanical properties were influenced by the % planar graphitization. The yield and ultimate tensile strength of the service exposed material did not show a statistically significant correlation with the % planar graphitization. The Charpy impact toughness results did however show a statistically significant negative correlation towards the % planar graphitization. This was clearly evident from the results of the HAZ regions of the service exposed weldments (Samples A-C) which had the highest levels of % planar graphitization and the lowest impact toughness, while the newly welded and post weld heat treated Sample D had no planar graphitization outside the HAZ and the highest impact toughness. This research project not only investigated how planar graphitization affects the static mechanical properties of service exposed pipe material, it also investigated on a microstructural basis, how planar graphitization nucleates and grows. The microstructural investigation showed that the free carbon required for the development of planar graphitization originated from the regions outside the HAZ, which were formed when the pearlite bands were dissolved during the welding of the steam pipe. The heat input from the welding sensitized this region for the development of planar graphitization, probably due to the formation of a “carbon-rich” matrix due to the partial dissolution of the cementite precipitates. All the carbide precipitates in this region consisted of M3C. aluminium-rich precipitates were found inside newly nucleated graphite nodules, indicating its role as a possible heterogeneous nucleation site. Growth of newly formed graphite nodules showed a preference towards high-angle grain boundaries and regions with dislocations for the initial growth stages of the graphite nodules. The microstructure of the region outside the HAZ of the newly introduced seam weld on the service exposed steam pipe material (with graphitization), was also investigated using advanced electron microscopy methods and it yielded no evidence of the development of planar graphitization.