No / Results of a study of the influence of impeller speed on the strength, structure and morphology of granules produced in a type of high shear mixer granulators are reported. Calcium carbonate particles (Durcal 65) have been granulated in a Cyclomix with a capacity of 5 L. An aqueous solution of polyethylene glycol was used as the binder. The granules produced have been dried and their structure visualized using X-ray micro-tomography equipment, Nanotom, with a resolution of less than 1 μm. It is shown that the operation of the granulator at high impeller tip speeds produces granules with a higher strength and lower porosity than those produced at medium and low impeller speeds. Two different granule micro-structures and morphologies are produced at high and low impeller speeds. Structure descriptors such as phase volume fraction (as representative of porosity), chord length distribution and auto-correlation function (as indices of homogeneity of structure) are used to quantify the internal structure of granules in 3D, which in turn affects the granule strength.

No / Results of a study on the influence of process parameters such as impeller speed, granulation time and binder viscosity on granule strength and properties are reported. A high shear granulator (Cyclomix manufactured by Hosokawa Micron B.V., The Netherlands) has been used to produce granules. Calcium carbonate (Durcal) was used as feed powder and aqueous polyethylene glycol (PEG) as the binder. The dried granules have been analysed for their strength, density and size distribution. The results show that increasing the granulation time has a great affect on granules strength, until an optimum time has been reached. The underlying cause is an increase in granule density. Granules are consolidated more at higher impeller speeds. Moreover, the granule size distribution seems not to be affected significantly by an increase in impeller speed. Granules produced with high binder viscosity have a considerably lower strength, wide strength distribution due to poor dispersion of binder on the powder bed. Binder addition methods have showed no considerable effect on granule strength or on granule size distribution.