In this work, SCWG of glucose, cellulose and pinewood was studied at different operating conditions with and without catalyst. Three parameters studied included temperature (400, 470, 500 and 550oC), water to biomass weight ratio (3:1 and 7:1) and catalyst (Ni/MgO, Ni/activated carbon, Ni/Al2O3, Ni/CeO2/Al2O3, dolomite, NaOH, KOH, activated carbon and olivine), which were varied for gasification of glucose, cellulose and pinewood. By comparing the results from model compound (glucose and cellulose) with that from real biomass (pinewood), the mechanism of how the individual compounds are gasified was explored. For catalytic runs with glucose, NaOH had the best activity for improving H2 formation. H2 yield increased by 135% using NaOH compared to that for run without catalyst at 500oC with a water to biomass weight ratio of 3:1. At the same operating conditions, the presence of Ni/activated carbon (Ni/AC) contributed to an 81% increase in H2 yield, followed by 62% with Ni/MgO, 60% with Ni/CeO2/Al2O3 and 52% with Ni/Al2O3. For catalytic runs with cellulose, the H2 yield increased by 194% with KOH compared to that for run without catalyst at 400oC with a water to biomass ratio of 3:1. At the same operating conditions, the presence of Ni/CeO2/Al2O3 contributed to a 31% increase in H2 yield followed by a 28% increase with dolomite. When the water to biomass ratio was increased from 3:1 to 7:1, H2 yield from glucose gasification was increased by 40% and 33% at 400 and 500oC, respectively, and the H2 yield of cellulose gasification was increased by 44%, 11% and 22% at 400, 470 and 550oC, respectively. The higher heating value of the oil products derived from SCWG of both glucose and cellulose incresed in the presence of catalysts. As real biomass, pinewood was gasified in supercritical water at the suitable operation conditions (550oC with water to biomass ratio of 7:1) obtained from previous experiments, using three kinds of catalyst: Ni/CeO2/Al2O3, dolomite and KOH. At the same operating conditions, the gasification of pinewood had smaller yields of H2 (20 to 41%) compared with that from cellulose. The effect of the catalyst on H2 production from SCW in the absence of biomass was studied. The results showed that a trace amount of H2 was formed with Ni based catalyst/dolomite only while some CO2 was formed with Ni/AC. Most of the runs presented in this report were repeated once, some of the runs had been triplicated, and the deviation of all results was in the range of ±5%.

Des nouveaux procédés éco-efficients basés sur une meilleure utilisation des ressources renouvelables sont nécessaires pour assurer la continuité du développement énergétique. La thèse étudie le procédé de gazéification en eau supercritique (T>374°C et P>22,1 MPa) de la biomasse très humide pour l’obtention de l’hydrogène, molécule ayant un potentiel énergétique très intéressant à valoriser avec un impact environnemental très favorable. L’étude porte sur l’application du procédé à la biomasse modèle (solutions de glucose, glycérol et leur mélange) ainsi qu’au bioglycérol, résidu de la fabrication du biodiesel. Les propriétés du solvant et les mécanismes prépondérants développés par l’eau en phase souset supercritique peuvent être contrôlés par les paramètres opératoires imposés au processus : température, pression, concentration en molécules organiques et catalyseur alcalin, temps de réaction... Les études paramétriques des systèmes réactionnels ont été menées dans des réacteurs batch à deux échelles différentes, les phases résultantes étant caractérisées par des protocoles analytiques élaborés et validés dans le cadre de l’étude. Le suivi du milieu réactionnel en batch lors de son déplacement vers l’état supercritique a mis en évidence une conversion avancée des molécules organiques et une identification de certains intermédiaires générés. Parmi les paramètres étudiés, la température et le temps de réaction influent le plus le rendement à l’obtention d’hydrogène en présence de catalyseur (K2CO3) dans les réacteurs batch, rendements de 1,5 et 2 mol d’H2 respectivement par mol de glycérol et de glucose introduites. Les gaz obtenus contiennent des proportions variables d’hydrocarbures légers et du CO2. Environ 75% du carbone est converti en phase gaz et liquide (sous forme de carbone organique et inorganique), le restant étant déposé sous forme solide ou huileuse. L’analyse du solide généré (plus de 90% de C) laisse apparaître différentes phases, y compris la formation de nanoparticules sphériques. Enfin, la gazéification en réacteur continu du glycérol préchauffé a montré de meilleurs rendements en hydrogène que le procédé batch, pendant que celle du bioglycérol demande une évolution du procédé à cause de la précipitation en phase supercritique des sels contenus dans le réactant. En conclusion, la gazéification en eau supercritique de la biomasse peut être considérée comme une alternative intéressante à d’autres procédés physico-chimiques de production de l’hydrogène. L’amélioration du procédé sera possible par son intensification menée en parallèle avec l’utilisation de matériaux plus performants et le contrôle de la salinité de la phase réactante. / Supercritical water (T > 374 ° C and P > 22.1 MPa) gasification of wet biomass for hydrogen production is investigated. This process converts a renewable resource into a gas, which is mainly composed of hydrogen and hydrocarbons with interesting energy potential, and which can be separated at high pressure. In addition, the greenhouse gas effect of the process is zero or negative. Model biomasses (glucose, glycerol and their mixture) and bio-glycerol, residue from bio-diesel production, have been gasified by different processes: two-scale batch reactors (5 mL and 500 mL) and a continuous gasification system. Supercritical water acts as a reactive solvent, its properties can be adjusted by the choice of the experimental (P, T) couple. The operating parameters, e.g. temperature, pressure, concentration of biomass and alkaline catalysts, reaction time… allow favoring certain reaction mechanisms. In order to characterize the processes, specific analytical protocols have been developed and validated. The intermediates, formed during the heating time in the batch reactors, have been identified. Among the investigated operating parameters, temperature and reaction time have the greatest influence on the hydrogen production in batch reactors. In the presence of catalyst (K2CO3), H2 yields of 1.5 mol/mol glucose and 2 mol/mol glycerol have been respectively observed. The obtained gas contains different proportions of light hydrocarbons and CO2. About 75% of the carbon is converted into gas and liquid (in form of organic and inorganic carbon). The conversion leads also to a solid or oily residue. In the generated solid phase (composed over 90% of C), spherical nanoparticles are observed via electronic microscopy. The hydrogen production from glycerol is improved in the continuous process compared to batch reactors, however, bio-glycerol supercritical water gasification requests process improvement due to the precipitation of the salt contained in the reactant. In conclusion, supercritical water gasification of biomass can be considered as an promising alternative process for hydrogen production. The process should be improved by more performing equipments and by the control of the salinity content of the crude biomass.