The blended-wing-body (BWB) configuration appears as a promising contender for the next generation of large transport aircraft. The idea of blending the wing with the fuselage and eliminating the tail is not new, it has long been known that tailless aircraft can suffer from stability and control problems that must be addressed early in the design. This thesis is concerned with identifying and then evaluating the flight dynamics, stability, flight controls and handling qualities of a generic BWB large transport aircraft concept. Longitudinal and lateral-directional static and dynamic stability analysis using aerodynamic data representative of different BWB configurations enabled a better understanding of the BWB aircraft characteristics and identification of the mechanisms that influence its behaviour. The static stability studies revealed that there is limited control power both for the longitudinal and lateral-directional motion. The solution for the longitudinal problem is to limit the static margins to small values around the neutral point, and even to use negative static margins. However, for the directional control problem the solution is to investigate alternative ways of generating directional control power. Additional investigation uncovered dynamic instability due to the low and negative longitudinal and directional static stability. Furthermore, adverse roll and yaw responses were found to aileron inputs. The implementation of a pitch rate command/attitude hold flight control system (FCS) improved the longitudinal basic BWB characteristics to satisfactory levels, or Level 1, flying and handling qualities (FHQ). Although the lateral-directional command and stability FCS also improved the BWB flying and handling qualities it was demonstrated that Level 1 was not achieved for all flight conditions due to limited directional control power. The possibility to use the conventional FHQs criteria and requirements for FCS design and FHQs assessment on BWB configurations was also investigated. Hence, a limited set of simulation trials were undertaken using an augmented BWB configuration. The longitudinal Bandwidth/Phase delay/Gibson dropback criteria, as suggested by the military standards, together with the Generic Control Anticipation Parameter (GCAP) proved possible to use to assess flying and handling qualities of BWB aircraft. For the lateral-directional motion the MIL-F-8785C criteria were used. Although it is possible to assess the FHQ of BWB configuartions using these criteria, more research is recommended specifically on the lateral-directional FHQs criteria and requirements of highly augmented large transport aircraft.

The blended-wing-body (BWB) configuration appears as a promising contender for the next generation of large transport aircraft. The idea of blending the wing with the fuselage and eliminating the tail is not new, it has long been known that tailless aircraft can suffer from stability and control problems that must be addressed early in the design. This thesis is concerned with identifying and then evaluating the flight dynamics, stability, flight controls and handling qualities of a generic BWB large transport aircraft concept. Longitudinal and lateral-directional static and dynamic stability analysis using aerodynamic data representative of different BWB configurations enabled a better understanding of the BWB aircraft characteristics and identification of the mechanisms that influence its behaviour. The static stability studies revealed that there is limited control power both for the longitudinal and lateral-directional motion. The solution for the longitudinal problem is to limit the static margins to small values around the neutral point, and even to use negative static margins. However, for the directional control problem the solution is to investigate alternative ways of generating directional control power. Additional investigation uncovered dynamic instability due to the low and negative longitudinal and directional static stability. Furthermore, adverse roll and yaw responses were found to aileron inputs. The implementation of a pitch rate command/attitude hold flight control system (FCS) improved the longitudinal basic BWB characteristics to satisfactory levels, or Level 1, flying and handling qualities (FHQ). Although the lateral-directional command and stability FCS also improved the BWB flying and handling qualities it was demonstrated that Level 1 was not achieved for all flight conditions due to limited directional control power. The possibility to use the conventional FHQs criteria and requirements for FCS design and FHQs assessment on BWB configurations was also investigated. Hence, a limited set of simulation trials were undertaken using an augmented BWB configuration. The longitudinal Bandwidth/Phase delay/Gibson dropback criteria, as suggested by the military standards, together with the Generic Control Anticipation Parameter (GCAP) proved possible to use to assess flying and handling qualities of BWB aircraft. For the lateral-directional motion the MIL-F-8785C criteria were used. Although it is possible to assess the FHQ of BWB configuartions using these criteria, more research is recommended specifically on the lateral-directional FHQs criteria and requirements of highly augmented large transport aircraft.

A handling quality investigation was performed on the swept gull-wing configuration. The swept gull-wing configuration is tailless and has a wing with a transition in the sweep and dihedral angle. An example of this type of aircraft is the Exulans. This aircraft is currently under development at the University of Pretoria. The handling quality study was focussed on pitch axis dynamics. The Exulans is a research testbed that will be used to investigate the swept gull-wing configuration and its special controls by means of full-scale flight testing. Variable wing sweep, twisting elevons and winglets will be investigated as means of control. These control devices are configured in such a way as to have minimum impact on the performance of the aircraft. The handling qualities of the swept gull-wing configuration have to be acceptable while using these different control strategies. The study was launched to investigate whether a gull-wing configuration aircraft will have satisfactory handling qualities at CG positions associated with the most favourable aerodynamic performance. There is an aerodynamic performance gain in designing an aircraft so that the CG falls on the so-called `E-point'. The E-point is the centre of pressure for an elliptical circulation distribution. An elliptical circulation distribution is associated with the highest Oswald efficiency for an aircraft. Time domain simulation techniques and frequency domain analysis techniques were used to analyse the handling qualities of the gull-wing configuration. The C-star criterion was used to analyse handling qualities with time domain simulation data as input. Comparative time domain simulations were performed between the Exulans and other aircraft to compare handling qualities. Eigenvalue analysis was used together with the thumbprint criterion to investigate inherent gull-wing airframe dynamics. The Shomber-Gertsen and Military Specification 8785 criteria were also used for the same purpose. The Neal-Smith method was used to investigate the effect of control authority on handling qualities and the effect of a pilot. The Monnich and Dalldorff criterion was used to evaluate gust handling qualities. An analysis chart by Fremaux and Vairo was used to evaluate the tumbling susceptibility of the gull-wing configuration. The pitch handling quality investigation shows sufficient promise that the swept gull-wing configuration will have acceptable handling qualities with the CG placed at positions associated with optimised aerodynamic performance. Analysis showed that the swept gull-wing configuration is potentially prone to tumbling. With low static margins, the configuration should exhibit improved handling qualities in gusty conditions when compared to existing tailless aircraft. It is recommended that a lateral handling quality study be performed before full scale flight testing commences on the Exulans. In addition, the possibility of wingtip stall must be investigated for the case of the swept gull-wing configuration. / Dissertation (MEng)--University of Pretoria, 2008. / Mechanical and Aeronautical Engineering / unrestricted