Thesis (D. Tech. Engineering : Electrical ; Dept. Applied Electronics and Electronic Communications) -- Vaal University of Technology / Two methods to convert an AC current source to an AC voltage source are presented. Both methods make use of a current transformer to provide energy extraction from the main system while maintaining galvanic isolation between the main system and the output system. Control is via a pulse width modulation scheme in both instances. The ftrst method uses a storage element to provide a DC voltage, which feeds an inverter that supplies the AC load with a voltage source. The second method does not use a storage element but is a direct AC current source to AC voltage source converter employing a current transformer. This has not been done before. A possible application of this study is in the extraction of power from high voltage transmission lines without the conventional substation and rural grid to supply small users such as the telecommunication industry.

The demand for higher efficiency and cleaner power sources increases daily. The Direct Methanol Fuel Cells (DMFC) is one of those power sources that produces reliable electrical energy at high efficiencies and very low pollution levels. Remote telecommunication sites need power sources that can deliver reliable power. This dissertation informs the reader about the working principles of the DMFC and the materials it consists of. A good amount of theoretical background is also given on the DMFC, especially on the Membrane Electrode Assembly (MEA). Different membranes as well as their properties are discussed. Results from other researchers on DMFCs are also captured. A DMFC stack including a test rig, was built. The DMFC stack consisted of five single DMFC cells. Each cell contained an MEA, Gas Diffusion Layers (GDLS), highly corrosive resistant metal support grids, bipolar flow field plates and end plates. The DMFC stack was operated and tested in a test rig. The test rig held the air blower which supplied the cathode with the required oxidant (air), and the methanol solution tank plus its liquid pump. The liquid pump circulated the methanol solution through the anode side of the stack. It was observed that the DMFC is very susceptible to corrosion, especially if the methanol solution becomes conductive owing to solubility of C02 in it. Methanol itself is a corrosive substance. However the results obtained from the experiments clearly indicate that the DMFC can be implemented as an electrical power source for telecommunications.