1 |
Ultra-wide Band In Communications: Performance Analysis And EnhancementsBerksoy, Burak 01 January 2008 (has links)
Over the last ten years, Ultra-Wide Band (UWB) technology has attracted tremendous research attention. Frequency allocation of 3.1-10.6 GHz for UWB application by FCC made it apparent that UWB will be the technology for future wireless high speed communication applications. With the promise of high data rates (high channel capacity), UWB also offers advantages such as communication security, high multi-path resolution, good penetration capability, ability to coexist with other communication schemes in the same band, and finally, circuit simplicity. The theoretical advantages of UWB has made it a great candidate for short distance communications, however, UWB communications have many challenges, for example, sub-nanosecond pulse generation, timing sensitivity of modulation and synchronization, flat antenna performance over a wide bandwidth, effect of existing systems on UWB systems. In order to experiment with various UWB modulation schemes, and to study transmitter and receiver structures, an accurate channel model need be established. In this dissertation, our first contribution is to evaluate and implement two major statistical channel models. The first model is proposed by AT\&T Labs and is in the form of an autoregressive IIR filter. Although this is an accurate channel model to represent UWB behavior, it is proposed before the allocation of 3.1-10.6 GHz frequency band, hence, it could not simulate the correct frequency spectrum. The second model is proposed by Saleh and Valenzuela, which has been widely accepted by UWB community to be the most accurate channel model for UWB systems. Recently disbanded task group 802.15.3a which was assigned to standardize a UWB communication scheme has also accepted the latter model. Our second contribution is to derive optimal pulses for PPM signals. Using the accurate channel model in computer simulations, we experimented on various UWB communication schemes. We found that the traditional UWB pulses being used in pulse position modulated UWB systems did not perform optimally. A set of optimized UWB pulses and the methodology to calculate optimal pulses for any modulation index for PPM systems have been proposed in this dissertation. It is found that the optimal pulse can improve the performance of UWB systems by as much as 0.7 dB. With the PPM pulse optimization, the theoretical performance limits of PPM systems are derived. The third contribution from this dissertation is to design near optimal practical implementable receiver structures. Some of the results obtained from PPM pulse optimization are found to be theoretical and not practical. More practical approach to the receiver structures were needed for industrial interest. We proposed simple sub-optimal receiver structures that are able to perform only a few dB less than the optimal receivers are proposed. These simple, low-cost receiver structures are strong alternatives to the complex traditional optimal receivers.
|
2 |
An Energy-Efficient Impulse Radio Ultra Wideband (IR-UWB) Transceiver for High-Rate BiotelemetryEbrazeh, Ali 03 September 2015 (has links)
No description available.
|
Page generated in 0.0476 seconds