Philosophiae Doctor - PhD / Nowadays, the pollution of surface waters with chemical contaminants is one of the most crucial environmental problems. These chemical contaminants enter rivers and streams resulting in tremendous amount of destruction, so the detection and monitoring of these chemical contaminants results in an ever-increasing demand. This thesis describes the search for a suitable method for the determination of platinum group metals (PGMs) in environmental samples due to the toxicity of mercury films and the limitations with methods other than electroanalytical methods. This study focuses on the development of a novel bismuth-silver bimetallic nanosensor for the determination of PGMs in roadside dust and soil samples. Firstly, individual silver, bismuth and novel bismuth-silver bimetallic nanoparticles were chemically synthesised. The synthesised nanoparticles was compared and characterised by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), ultraviolet-visible spectroscopy (UV-Vis), Fourier-transformed infrared spectroscopy (FT-IR), Raman spectroscopy, and transmission electron microscopy (TEM) analysis to interrogate the electrochemical, optical, structural, and morphological properties of the nanomaterials. The individual silver, bismuth, and bismuth-silver bimetallic nanoparticles in the high resolution transmission electron microscopy results exhibited an average particle size of 10-30 nm. The electrochemical results obtained have shown that the bismuth-silver bimetallic nanoparticles exhibit good electro-catalytic activity that can be harnessed for sensor construction and related applications. The ultraviolet-visible spectroscopy, Fourier-transformed infrared spectroscopy, and Raman spectroscopy results confirmed the structural properties of the novel bismuth-silver bimetallic nanoparticles. In addition the transmission electron microscopy and selected area electron diffraction morphological characterisation confirmed the nanoscale nature of the bismuth-silver bimetallic nanoparticles. Secondly, a sensitive adsorptive stripping voltammetric procedure for palladium, platinum and rhodium determination was developed in the presence of dimethylglyoxime (DMG) as the chelating agent at a glassy carbon electrode coated with a bismuth-silver bimetallic nanofilm. The nanosensor further allowed the adsorptive stripping voltammetric detection of PGMs without oxygen removal in solution. In this study the factors that influence the stripping performance such as composition of supporting electrolyte, DMG concentration, deposition potential and time studies, and pH have been investigated and optimised. The bismuth-silver bimetallic nanosensor was used as the working electrode with 0.2 M acetate buffer (pH = 4.7) solution as the supporting electrolyte. The differential pulse adsorptive stripping peak current signal was linear from 0.2 to 1.0 ng/L range (60 s deposition), with limit of detections for Pd (0.19 ng/L), Pt (0.20 ng/L), Rh (0.22 ng/L), respectively. Good precision for the sensor application was also obtained with a reproducibility of 4.61% for Pd(II), 5.16% for Pt(II) and 5.27% for Rh(III), for three measurements. Investigations of the possible interferences from co-existing ions with PGMs were also done in this study. The results obtained for the study of interferences have shown that Ni(II) and Co(II) interfere with Pd(II), Pt(II) and Rh(III) at high concentrations. The interference studies of Cd(II), Pb(II), Cu(II) and Fe(III) showed that these metal ions only interfere with Pd(II) and Pt(II) at high concentrations, with no interferences observed for Rh(III). Phosphate and sulphate only interfere at high concentrations with Pt(II) and Rh(III) in the presence of DMG with 0.2 M acetate buffer (pH = 4.7) solution as the supporting electrolyte. Based on the experimental results, this bismuth-silver bimetallic nanosensor can be considered as an alternative to common mercury electrodes, carbon paste and bismuth film electrodes for electrochemical detection of PGMs in environmental samples. Thirdly, this study dealt with the development of a bismuth-silver bimetallic nanosensor for differential pulse adsorptive stripping voltammetry (DPAdSV) of PGMs in environmental samples. The nanosensor was fabricated by drop coating a thin bismuth-silver bimetallic film onto the active area of the SPCEs. Optimisation parameters such as pH, DMG concentration, deposition potential and deposition time, stability test and interferences were also studied. In 0.2 M acetate buffer (pH = 4.7) solution and DMG as the chelating agent, the reduction signal for PGMs ranged from 0.2 to 1.0 ng/L. The detection limit for Pd(II), Pt(II) and Rh(III) was found to be 0.07 ng/L, 0.06 ng/L and 0.2 ng/L, respectively. Good precision for the sensor application was also obtained with a reproducibility of 7.58% for Pd(II), 6.31% for Pt(II) and 5.37% for Rh(III), for three measurements. In the study of possible interferences, the results have shown that Ni(II), Co(II), Fe(III), Na+, SO42- and PO43- does not interfere with Pd(II) in the presence of DMG with sodium acetate buffer as the supporting electrolyte solution. These possible interference ions only interfere with Pt(II) and Rh(III) in the presence of DMG with 0.2 M acetate buffer (pH = 4.7) as the supporting electrolyte solution.

Philosophiae Doctor - PhD / Fossil fuels are part of fuels that are formed from natural processes and they are called non-renewable sources of energy. These include natural gas, coal and oil. They have been used for decades to produce energy globally. However, there are some factors that related with the use of fossil fuels which results in an increase in the requirement of large amounts of energy. In addition, the use of fossil fuels as energy source has a negative impact on the environment and they cannot be reused. It is expected that at some point they will run out. Thus, a need for a renewable, clean and plentiful source of energy is urgent. Solar energy is one of the energy sources that may overcome fossil fuel drawbacks.

Owing to the importance of gold nanoparticles in catalysis, designing of them has become a major focus of the researchers. Most of the current methods available for the synthesis of gold nanoaprticles (GNPs) suffer from the challenges of polydispersity, stability and use of toxic and harmful chemicals. To overcome these limitations of conventional methods, in our present study, we made an attempt to design a method for the green synthesis of monodispersed and stable gold nanoparticles by sugars which act as reducing and stabilizing agent. Characterization of synthesized nanoparticles was done by using various analytical techniques such as transmission electron microscope (TEM), dynamic light scattering spectroscopy (DLS), UV-Vis spectroscopy, scanning electron microscopy and electron dispersion spectroscopy. The synthesized sugar GNPs (S-GNPs) were spherical in shape and in the size range of 10 ± 5 nm. p-Nitrophenol reduction assay was used as a model system to determine the catalytic reduction activity of various sugar capped GNPs, monosaccharides (fructose), disaccharide (sucrose) and trisaccharide (raffinose) GNPs. The effect of temperature and the size of ligand on catalytic activity was also evaluated at different temperature using UV-Vis spectrometer. Using the spectroscopic data, rate constant (k) for three sugar capped GNPs was determined followed by its activation energy (Ea) and exponential (A) factor.

No description available.

Functionalized nanoparticles provide a wide range of potential applications for Biological Mass Spectrometry (MS). Particularly, we have studied the effects of chromophore activity on the performance of gold nanoparticles (AuNPs) capped with substituted azo (-N=N-) dyes for analyte ion production in Laser Desorption Ionization Mass Spectrometry (LDI-MS) conditions. A series of aromatic thiol compounds were used as Self-Assembled Monolayers (SAM) to functionalize the surface of the AuNPs. Results indicate that AuNPs functionalized with molecules having an active azo chromophore provide enhanced analyte ion yields than the nanoparticles capped with the hydrazino analogs or simple substituted aromatic thiols. We have also conducted experiments using the azo SAM molecules on 2, 5, 20, 30, and 50 nm AuNPs exploring the changes of Relative Ion Yield (RIY) with increased AuNP diameters. Our results indicate that the role of the SAM to drive energy deposition decreases as the size of the AuNP increases. It was determined that 5 nm is the optimum size to exploit the benefits of the SAM on the ionization and selectivity of the AuNPs.

This diploma thesis deals with the optimization of processes for extraction of bioactive lipophilic compounds from fruits of sea buckthorn (Hippophae Rhamnoides) into various types of plant oil bases using simple maceration. The theoretical part of this thesis deals with the characterization of this herb, its botanical classification, traditional use, chemical composition and medicinal effects. Increased attention is also paid to the characterization of individual types of plant oils used, namely camellia, camellia organic, passionflower, kukui and kiwi oil. The experimental part of the thesis deals with application of theoretical knowledge. The profile of total and free fatty acids for individual plant oil bases was determined by GC/FID, furthet the basic fat numbers were also determined. When optimizing the extraction, emphasis was placed not only on the effect of the extraction agent used, but also on the extraction time (1, 3, 5, 7, 10, 14, 21 and 66 days). The macerates were continuously subjected to the determination of selected parameters (total amount of carotenoids, total amount of phytosterols, lutein, neoxanthin, astaxanthin, stigmasterol, -sitosterol and vitamin E) using UV-VIS spectroscopy and HPLC/PDA. Likewise, the peroxide number was monitored during maceration to assess the degree of oxidative degradation of macerates. The recovery of selected total parameters in individual oils did not differ significantly in most cases. On the contrary, the yield of individual monitored parameters differed significantly. At the same time, static maceration under our conditions was not very suitable for the extraction of vitamin E, stigmasterol and total phytosterols.