abstract: Rapid urban expansion and the associated landscape modifications have led to significant changes of surface processes in built environments. These changes further interact with the overlying atmospheric boundary layer and strongly modulate urban microclimate. To capture the impacts of urban land surface processes on urban boundary layer dynamics, a coupled urban land-atmospheric modeling framework has been developed. The urban land surface is parameterized by an advanced single-layer urban canopy model (SLUCM) with realistic representations of urban green infrastructures such as lawn, tree, and green roof, etc. The urban atmospheric boundary layer is simulated by a single column model (SCM) with both convective and stable schemes. This coupled SLUCM-SCM framework can simulate the time evolution and vertical profile of different meteorological variables such as virtual potential temperature, specific humidity and carbon dioxide concentration. The coupled framework has been calibrated and validated in the metropolitan Phoenix area, Arizona. To quantify the model sensitivity, an advanced stochastic approach based on Markov-Chain Monte Carlo procedure has been applied. It is found that the development of urban boundary layer is highly sensitive to surface characteristics of built terrains, including urban land use, geometry, roughness of momentum, and vegetation fraction. In particular, different types of urban vegetation (mesic/xeric) affect the boundary layer dynamics through different mechanisms. Furthermore, this framework can be implanted into large-scale models such as Weather Research and Forecasting model to assess the impact of urbanization on regional climate. / Dissertation/Thesis / Doctoral Dissertation Civil and Environmental Engineering 2016

abstract: The rapid rate of urbanization coupled with continued population growth and anthropogenic activities has resulted in a myriad of urban climate related impacts across different cities around the world. Hot-arid cities are more vulnerable to induced urban heat effects due to the intense solar radiation during most of the year, leading to increased ambient air temperature and outdoor/indoor discomfort in Phoenix, Arizona. With the fast growth of the capital city of Arizona, the automobile-dependent planning of the city contributed negatively to the outdoor thermal comfort and to the people's daily social lives. One of the biggest challenges for hot-arid cities is to mitigate against the induced urban heat increase and improve the outdoor thermal. The objective of this study is to propose a pragmatic and useful framework that would improve the outdoor thermal comfort, by being able to evaluate and select minimally invasive urban heat mitigation strategies that could be applied to the existing urban settings in the hot-arid area of Phoenix. The study started with an evaluation of existing microclimate conditions by means of multiple field observations cross a North-South oriented urban block of buildings within Arizona State University’s Downtown campus in Phoenix. The collected data was evaluated and analyzed for a better understanding of the different local climates within the study area, then used to evaluate and partially validate a computational fluid dynamics model, ENVI-Met. Furthermore, three mitigation strategies were analyzed to the Urban Canopy Layer (UCL) level, an increase in the fraction of permeable materials in the ground surface, adding different configurations of high/low Leaf Area Density (LAD) trees, and replacing the trees configurations with fabric shading. All the strategies were compared and analyzed to determine the most impactful and effective mitigation strategies. The evaluated strategies have shown a substantial cooling effect from the High LAD trees scenarios. Also, the fabric shading strategies have shown a higher cooling effect than the Low LAD trees. Integrating the trees scenarios with the fabric shading had close cooling effect results in the High LAD trees scenarios. Finally, how to integrate these successful strategies into practical situations was addressed. / Dissertation/Thesis / Masters Thesis Architecture 2020

abstract: The world has been continuously urbanized and is currently accommodating more than half of the human population. Despite that cities cover only less than 3% of the Earth’s land surface area, they emerged as hotspots of anthropogenic activities. The drastic land use changes, complex three-dimensional urban terrain, and anthropogenic heat emissions alter the transport of mass, heat, and momentum, especially within the urban canopy layer. As a result, cities are confronting numerous environmental challenges such as exacerbated heat stress, frequent air pollution episodes, degraded water quality, increased energy consumption and water use, etc. Green infrastructure, in particular, the use of trees, has been proved as an effective means to improve urban environmental quality in existing research. However, quantitative evaluations of the efficacy of urban trees in regulating air quality and thermal environment are impeded by the limited temporal and spatial scales in field measurements and the deficiency in numerical models. This dissertation aims to advance the simulation of realistic functions of urban trees in both microscale and mesoscale numerical models, and to systematically evaluate the cooling capacity of urban trees under thermal extremes. A coupled large-eddy simulation–Lagrangian stochastic modeling framework is developed for the complex urban environment and is used to evaluate the impact of urban trees on traffic-emitted pollutants. Results show that the model is robust for capturing the dispersion of urban air pollutants and how strategically implemented urban trees can reduce vehicle-emitted pollution. To evaluate the impact of urban trees on the thermal environment, the radiative shading effect of trees are incorporated into the integrated Weather Research and Forecasting model. The mesoscale model is used to simulate shade trees over the contiguous United States, suggesting how the efficacy of urban trees depends on geographical and climatic conditions. The cooling capacity of urban trees and its response to thermal extremes are then quantified for major metropolitans in the United States based on remotely sensed data. It is found the nonlinear temperature dependence of the cooling capacity remarkably resembles the thermodynamic liquid-water–vapor equilibrium. The findings in this dissertation are informative to evaluating and implementing urban trees, and green infrastructure in large, as an important urban planning strategy to cope with emergent global environmental changes. / Dissertation/Thesis / Doctoral Dissertation Civil, Environmental and Sustainable Engineering 2019