Spelling suggestions: "subject:"isible infrared spin scan radiometer"" "subject:"faisible infrared spin scan radiometer""
1 |
An infrared radiometer for millimeter astronomySmith, Graeme John, University of Lethbridge. Faculty of Arts and Science January 2000 (has links)
The performance of existing and planned millimeter and submillimeter astronomical arrays is limited by fluctuations in the amount of atmosperic water vapor along the atenna's line of sight. Correcting the resulting phase distortion of the received signals is seen as a significant technological challenge.
Measurements of the variation in the line-of-sight water vapor abundance at the level of 1 micron precipitable water vapor on a time scale of 1 second and at arbitrary antenna positions are required. This thesis describes the design of, and preliminary results obtained with, a water vapor monior operating at abundance at the level 1 micron precipitable water vapor on a time scale of 1 second and at arbitrary antenna positions are required. This thesis describes the design of, and preliminary results obtained with, a water vapor monitor operating at infrared wavelengths which shows considerable promise for this application. Improvements in, and future plans for, the second generation water vapor monitor currently under development are also discussed. / xiii, 167 leaves : ill. ; 28 cm.
|
2 |
The IRMA III control and communication systemSchofield, Ian Sean, University of Lethbridge. Faculty of Arts and Science January 2005 (has links)
The IRMA III infrared radiometer is a passive atmospheric water vapor detector designed for use with interferometric submillimeter arrays as a method of phase correction. The IRMA III instrument employs a distributed, multi-tasking software control system permitting precise fine-grained control at remote locations over a low-bandwidth network connection. IRMA's software is divided among three processors tasked with performing three primary functions: command interpretation, data collection and motor control of IRMA's Alt-Az mount. IRMA's hardware control and communication functionality is based on compact, low cost, energy efficient Rabbit 2000 microcontroller modules, selected to meet IRMA's limited space and power requirements. IRMA accepts scripts defined in a custom, high level control language as its method of control, which the operator can write or dynamically generated by a separate GUI front-end program. / xi, 193 leaves : ill. ; 28 cm.
|
3 |
IRMA calibrations and data analysis for telescope site selectionQuerel, Richard Robert, University of Lethbridge. Faculty of Arts and Science January 2007 (has links)
Our group has developed a 20 μm passive atmospheric water vapour monitor.
The Infrared Radiometer for Millimetre Astronomy (IRMA) has been commissioned and
deployed for site testing for the Thirty Meter Telescope (TMT) and the Giant Magellan
Telescope (GMT). Measuring precipitable water vapour (PWV) requires both a sophisticated
atmospheric model (BTRAM) and an instrument (IRMA). Atmospheric models
depend on atmospheric profiles. Most profiles are generic in nature, representing only a
latitude in some cases. Site-specific atmospheric profiles are required to accurately simulate
the atmosphere above any location on Earth. These profiles can be created from publicly
available archives of radiosonde data, that offer nearly global coverage. Having created
a site-specific profile and model, it is necessary to determine the PWV sensitivity to the
input parameter uncertainties used in the model. The instrument must also be properly
calibrated. In this thesis, I describe the radiometric calibration of the IRMA instrument,
and the creation and analysis of site-specific atmospheric models for use with the IRMA
instrument in its capacity as an atmospheric water vapour monitor for site testing. / xii, 135 leaves : ill. ; 28 cm. --
|
4 |
Optimisation of the instrumental performance of IRMADahl, Regan Eugene, University of Lethbridge. Faculty of Arts and Science January 2008 (has links)
The Infrared Radiometer for Millimetre Astronomy (IRMA) is a passive atmospheric
water vapour monitor developed at the University of Lethbridge. It is a compact,
robust, and autonomous instrument, which is capable of being operated remotely. The
latest model is based on a PC/104 running an AMD 133 MHz SC520 processor, which
allows for more flexible control of the unit. The modifications and upgrades to the software required for the transition to this new platform are discussed in this thesis. In addition to software optimisation, a new calibration method has been developed as the unit has become better understood. This method has been verified through test campaigns carried out in Lethbridge and Chile. The results of these tests are included in this thesis. / xii, 141 leaves : ill. (some col.) ; 28 cm. --
|
Page generated in 0.1468 seconds