White Island and Ruapehu are currently the most active volcanoes in New Zealand. During non-eruptive periods, intense quiescent degassing through fumaroles can occur. The current project studies the quiescent degassing plumes, including aerosol sampling on White Island and dispersion modelling of SO₂ and PM₁₀ from White Island and Ruapehu volcanoes. Aerosol sampling from fumaroles at the crater floor on White Island volcano was carried out on 9 February and 6 April 2005. The exposed filters were analysed for various anions and cations and the particle mass concentration and molar concentration determined. Major elemental constituents were sodium and chlorine (Na⁺: 413 µg m⁻³, Cl⁻: 1520 µg m⁻³), which show best correlation at both sampling sessions. Other ions detected, with little correlation, are Ca²⁺, PO₄³⁻ and to a certain extent Mg²⁺. Other constituents found, which cannot correlate explicitly to other ions, are K⁺, NH₄⁺, NO₃⁻, and SO₄²⁻. SEM study of one exposed filter was performed and mainly NaCl particles could be distinguished due to their well-defined cubic shape. The Air Pollution Model (TAPM) was used for dispersion modelling of SO₂ (models 1-4) and PM₁₀ (models 5 and 6) from White Island and Ruapehu volcanoes. Annual modelling was performed using different parameters of emission rate, exit temperature and exit velocity. The resulting plume dispersions show relatively low concentrations at ground level ≤10 m), particularly for the models of PM₁₀ dispersion. TAPM calculated the highest SO₂ ground level concentrations with model 4, where the NES values of 350 and 570 µg m⁻³ were exceeded several times. The data was then used for detailed hazard assessment of urban population in the North Island. The meteorological data from annual modelling was used for model evaluation and compared with observation data from different weather stations by statistical calculations. Overall, TAPM performed well with most good and very good results. To evaluate SO₂ dispersion modelling, airborne plume measurements were carried out on 22 November 2006 by plume traverses at 3, 10 and 20 km. Although there is some variation, the calculated correlation coefficients indicate good model results for two plume traverses at 3 and 20 km and one plume traverse at 10 km. The meteorological data was also used for model evaluation, and the results indicate good model performance. TAPM is therefore suggested for future studies when more observation data are available to verify the calculated model data.

White Island is a highly active volcano with an acidic, S-rich hydrothermal system in the Bay of Plenty, North Island, New Zealand. In this acidic environment a series of subsurface Fe-rich layers are ubiquitous in the crater sediments at shallow depth and are capable of modifying the flow and gas flux dynamics in the system. The mineralogy of the subsurface Fe-rich layer(s) and the processes leading to their formation are unknown. Here the mineralogy and formation of the subsurface Fe-rich layers in relation to the surface and subsurface environment(s) within the Main Crater at White Island are assessed. Based on geochemical analyses, subsurface Fe-rich crusts are composed of a mix of jarosite and goethite, cementing crater fill sediments into cohesive layers. Saturation index (SI) and Eh/pH assessments identify that fluids evolved at White Island are undersaturated with respect to the mineral phases present in the Fe-rich subsurface layers. Formation of the Fe-rich subsurface layers is most likely related to the transition between atmospheric gases and/or meteoric water mixing with hydrothermal fluids. This transition zone creates an environment conducive to forming jarosite and goethite forming in the same layer. Additionally, subsurface sediments including the Fe-rich layers show a consistent organic carbon isotopic signature of -23 ‰. Microscopic investigations confirm diatoms and microbes are present in the subsurface Fe-rich layers. The full extent of microbial activity in relation to the Fe-rich layers at White Island still requires further investigation. Based on chemical extractions for isotopic analyses, Fe-rich layers are shown to preserve δ¹³C signatures indicative of microbial life. Interface zones such as those identified in the hydrothermal environment at White Island can create metal-rich deposits and habitable/preservative microbial environments as well as affecting the macroscopic dynamics of volcanic and epithermal systems.

White Island and Ruapehu are currently the most active volcanoes in New Zealand. During non-eruptive periods, intense quiescent degassing through fumaroles can occur. The current project studies the quiescent degassing plumes, including aerosol sampling on White Island and dispersion modelling of SO₂ and PM₁₀ from White Island and Ruapehu volcanoes. Aerosol sampling from fumaroles at the crater floor on White Island volcano was carried out on 9 February and 6 April 2005. The exposed filters were analysed for various anions and cations and the particle mass concentration and molar concentration determined. Major elemental constituents were sodium and chlorine (Na⁺: 413 µg m⁻³, Cl⁻: 1520 µg m⁻³), which show best correlation at both sampling sessions. Other ions detected, with little correlation, are Ca²⁺, PO₄³⁻ and to a certain extent Mg²⁺. Other constituents found, which cannot correlate explicitly to other ions, are K⁺, NH₄⁺, NO₃⁻, and SO₄²⁻. SEM study of one exposed filter was performed and mainly NaCl particles could be distinguished due to their well-defined cubic shape. The Air Pollution Model (TAPM) was used for dispersion modelling of SO₂ (models 1-4) and PM₁₀ (models 5 and 6) from White Island and Ruapehu volcanoes. Annual modelling was performed using different parameters of emission rate, exit temperature and exit velocity. The resulting plume dispersions show relatively low concentrations at ground level ≤10 m), particularly for the models of PM₁₀ dispersion. TAPM calculated the highest SO₂ ground level concentrations with model 4, where the NES values of 350 and 570 µg m⁻³ were exceeded several times. The data was then used for detailed hazard assessment of urban population in the North Island. The meteorological data from annual modelling was used for model evaluation and compared with observation data from different weather stations by statistical calculations. Overall, TAPM performed well with most good and very good results. To evaluate SO₂ dispersion modelling, airborne plume measurements were carried out on 22 November 2006 by plume traverses at 3, 10 and 20 km. Although there is some variation, the calculated correlation coefficients indicate good model results for two plume traverses at 3 and 20 km and one plume traverse at 10 km. The meteorological data was also used for model evaluation, and the results indicate good model performance. TAPM is therefore suggested for future studies when more observation data are available to verify the calculated model data.

White Island, New Zealand, is an active andesitic volcano that is located near the southern end of the Tonga-Kermadec Volcanic Arc at the convergent plate boundary where the Pacific Plate is being subducted beneath the Indian-Australian Plate. The plate tectonic setting, volcanic features and the petrology of White Island are thought to be characteristic of the environment associated with formation of porphyry copper deposits. White Island has only been active for about 10 Ka and, as such, is thought to be an ideal location to study early magmatic processes associated with formation of porphyry copper deposits. In this study, the geochemistry of the silicate melt at White Island has been characterized through detailed studies of silicate melt inclusions, phenocrysts, and matrix glass contained in recent ejecta (1977-1991). Most melt inclusions contained only glass, however, daughter minerals present in multiphase melt inclusions in the 1991 sample indicate a different P-T history compared to the other samples. Samples studied are vesicular porphyritic andesitic dacites containing phenocrysts of plagioclase, orthopyroxene, and clinopyroxene. A glassy matrix containing crystallites surrounds the phenocrysts. Both mineral and silicate melt inclusions occur in all three phenocryst phases. Inclusions of plagioclase occur in pyroxenes and inclusions of orthopyroxene and clinopyroxene occur in plagioclase. Compositions of minerals are independent of mode of occurrence - that is, plagioclase (and orthopyroxene and clinopyroxene) compositions are the same regardless of whether they occur as phenocrysts or as inclusions in another mineral. Moreover, compositions of mineral inclusions and phenocrysts show no systematic variation within individual samples or in samples representing different eruptive events, indicating that the magma chamber is chemically homogenous over the time-space scale being sampled. Various major, trace element and volatile compositional features of economic and non-economic (or barren) porphyry copper systems were compared to the White Island data. The Al2O3/(Na2O+K2O+CaO) ratio observed in economic porphyry copper deposits is always greater than or equal to 1.3, and glass in one phase melt inclusions, as well as glass in unhomogenized (1991) inclusions from White Island equal or exceed this value. The glass in the unhomogenized 1991 melt inclusions is corundum normative, with Si/(Si+Ca+Mg+Fet)>0.91, and K/(K+Ca+Mg+Fet)>0.36, all of which are characteristic of productive systems. Melt inclusions from White Island also show a positive Eu anomaly similar to that found in productive porphyry deposits, whereas non-productive systems show a negative Eu anomaly. Copper concentrations (170-230 ppm) in melt inclusions from White Island are sufficiently high to generate an economic porphyry copper deposit based on theoretical models. High Cl/H2O ratios (0.15) in melt inclusions furthermore indicate that copper will be efficiently partitioned from the melt into the magmatic aqueous phase. The inferred pressure in the magma chamber at depth (1 kbar) is ideal for extracting copper from the melt, and mineral phases (pyrrhotite, biotite or amphibole) which could scavenge copper before it could be partitioned into the magmatic vapor phase are absent. Concentrations of S in the melt are also low, which would prevent pyrrhotite from crystallizing. The tectonic setting and geochemical characteristics of the magma body at White Island are similar to features observed in economic porphyry systems elsewhere. These data suggest that development of economic porphyry copper mineralization at White Island is likely. / Master of Science

"June, 2008". / Thesis (PhD)--Macquarie University, Division of Environmental & Life Sciences, Dept. of Chemistry & Biomolecular Sciences, 2009. / Bibliography: p. 227-259. / Literature review -- Materials and methods -- Sampling sites and sampling material -- Enrichment cultures and molecular analyses -- Optical and binding characterisation of the QDs -- Applications of the QDs -- Concluding remarks. / White island, the most active volcano in New Zealand, is a poorly studied environment that represents an ideal site for the investigation of acidophilic thermophiles. The microorganisms present on here are continually exposed to extreme environmental conditions as they are surrounded by steamy sulphurous fumaroles and acidic streams. The sediment temperature ranges from 38°C to 104°C whilst maintaining pH values below 3. A survey of the volcanic hydrothermal system of White Island was undertaken in order to gain insights onto the microbial diversity using culture-dependant techniques and molecular and phylogenetic analyses. A novel liquid medium based on "soil-extract" was designed which supported growth of bacterial and archaeal mixed cultures. Molecular analyses revealed that the dominant culturable bacterial species belong to the Bacteroidetes, Firmicutes and α-Proteobacteria groups. Several previously uncultured archaeal species were also present in the mixed cultures. The knowledge gained from these studies was intended to help in the development of a novel microbial detection technique suitable for community analysis. -- Conventional molecular techniques used to study microbial biodiversity in environmental samples are both time-consuming and expensive. A novel bead-based assay employing Quantum dots (QDs) was considered to have many advantages over standard molecular techniques. These include high detection speeds, sensitivity, specificity, flexibility and the capability for multiplexed analysis. QDs are inorganic semiconductor nanoparticles made up of crystals about the size of proteins. It has been claimed that the physical and chemical properties of the QDs have significant advantages compared to organic dyes, including brighter fluorescence and resistance to photo-bleaching. Their optical properties facilitate the simultaneous imaging of multiple colours due to their flexible excitation and narrow band emission. Functionalised QDs are able to bind to different biological targets such as DNA, allowing high-throughput analysis for rapid detection and quantification of genes and cells. -- The optical and physical characteristics of the QDs as well their interaction with biomolecules are shown to be suitable for the development of a novel bead-based technique able to target the key microbial species and identify them by flow cytometric measurements (FCM). The broad absorption and narrow emission spectra of the QDs, as well as their fluorescence intensity and specify to target biomolecules, was compared to other organic fluorophores. The potential advantages and limitations of QDs as a fluorophores for biological applications are discussed. -- The data acquired during this study provides a broad overview of the microbial diversity and ecology of the volcanically-active hydrothermal systems of White Island and constitutes the baseline for the development of a novel bead-based technique based on QDs. / Mode of access: World Wide Web. / xvii, 259 p. ill. (some col.)