Sound propagation in a waveguide is greatly dependent on the acoustic properties of the boundaries. The effect of these properties can be described by a bottom reflection coefficient RB, and surface reflection coefficient RS. Two methods for estimating reflection coefficients are used in this research. The first, the ratio method, is based on the variations of the Green's function with depth utilizing the ratio of the wavenumber spectra at two depths. The second, the pole method, is based on the wavenumbers of the modal peaks in the spectrum at a particular depth. A method to invert for sound speed and density is also examined. Estimates of RB and RS based on synthetic data by the ratio method were very close to their predicted values, especially for higher frequencies and longer apertures. The pole method returned less precise estimates though with longer apertures, the estimates were better. Using experimental data, results of the pole method as well a geoacoustic inversion technique based on them were mixed. The ratio method was used to estimate RS based on the actual data and returned results close to the predicted phase of p. / by Alexander Conrad. / Vita. / Thesis (M.S.C.S.)--Florida Atlantic University, 2010. / Includes bibliography. / Electronic reproduction. Boca Raton, Fla., 2010. Mode of access: World Wide Web.

We formulate a model for acoustic excitations in a magnetorheological fluid. Constitutive equations are derived for Navier-Stokes flow coupled with Maxwell's Equations. The viscosity of the fluid is modified to reflect the dependence of waves propagating within the fluid itself and in the case where they propagate along the network of particles.

Thesis. 1977. Elec.E.--Massachusetts Institute of Technology. Dept. of Electrical Engineering and Computer Science. / MICROFICHE COPY AVAILABLE IN ARCHIVES AND ENGINEERING. / Includes bibliographical references. / Elec.E.

Thesis (M.S.)--Massachusetts Institute of Technology, Dept. of Electrical Engineering and Computer Science, 1979. / MICROFICHE COPY AVAILABLE IN ARCHIVES AND ENGINEERING. / Includes bibliographical references. / by André Antoine Merab. / M.S.

Thesis (Ph.D.)--Massachusetts Institute of Technology, Dept. of Electrical Engineering and Computer Science, 1981. / MICROFICHE COPY AVAILABLE IN ARCHIVES AND ENGINEERING. / Includes bibliographical references. / by Peter Vickers Wright. / Ph.D.

A36 steel is a commonly used material in civil engineering structures where fatigue damage can lead to catastrophic failure. In this research, nonlinear Rayleigh surface waves are used to characterize damage in A36 steel specimens caused by monotonic tension and low cycle fatigue. Fatigue damage produces the increased acoustic nonlinearity that leads to the generation of measurable higher harmonics in an initially monochromatic Rayleigh wave signal. One specimen is subjected to static tension and four specimens are used for low cycle fatigue tests in the tension-tension mode with a constant stress amplitude. The fatigue tests are interrupted at different numbers of cycles for the nonlinear ultrasonic measurements. Tone burst Rayleigh wave signals are generated and detected using a pair of oil coupled wedge transducers. The amplitudes of the first and second harmonic are measured at varying propagation distances to obtain the nonlinearity parameter for a given damage state. The experimental results show an increase of acoustic nonlinearity in the early stages of fatigue life. Furthermore, a close relationship between plastic deformation and the acoustic nonlinearity is found, which indicates that the acoustic nonlinearity is indeed a measure of microplasticity in this material.

Thesis (Ph. D.)--State University of New York at Binghamton, Mechanical Engineering Department, 2006. / Includes bibliographical references.

Thesis (Ph.D.)--Biomedical Engineering, Georgia Institute of Technology, 2008. / Committee Chair: William D Hunt; Committee Member: Bruno Frazier; Committee Member: Dale Edmondson; Committee Member: Marie Csete; Committee Member: Peter Edmonson; Committee Member: Ruth O'Regan

Thesis (Ph. D.)--Rutgers University, 2008. / "Graduate Program in Electrical and Computer Engineering." Includes bibliographical references (p. 150-157).

Thesis (Ph. D.)--Rutgers University, 2008. / "Graduate Program in Electrical and Computer Engineering." Includes bibliographical references (p. 142-149).