ITC/USA 2006 Conference Proceedings / The Forty-Second Annual International Telemetering Conference and Technical Exhibition / October 23-26, 2006 / Town and Country Resort & Convention Center, San Diego, California / A rocket launch, as high dynamics target, was used to demonstrate X-band tracking and also to verify high bit rate frequency planning while demonstrating significant bandwidth reduction with IRIG standard advanced modulation methods. X-band tracking by a modified 8-foot mobile telemetry antenna was excellent. Three separate S-band transmitters with three separate wraparound antennas were launched as a piggyback payload on an Enhanced Orion sounding rocket at White Sands Missile Range (WSMR) to compare the performance of 10 Mbs and 20 Mbs bit error rate (BER) pattern data transmission from CPFSK, FQPSK-JR and ARTM CPM modulation formats under high dynamic conditions. The test is more remarkable in that another S-band wideband spread spectrum signal was also transmitted with good success. These results show that all three modulation methods performed well during ignition and liftoff, low aspect angle (receiving through the rocket motor plume during ascent from a tracker near the launch pad), spin stabilization antenna lobe fades and payload tumbling. Spectrum pictures are provided to show the dramatic reduction in transmission bandwidth from CPFSK to FQPSK-JR to ARTM CPM. Confirmation of the preflight RF adjacent channel interference planning procedures from IRIG 106-05 is described by spectrum pictures and data quality measurements.

Due to its ability to deliver scalable and fault-tolerant solutions, applications based on the peer-to-peer (P2P) paradigm are used by millions of users on the internet. Recently, wireless mesh networks (WMNs) have attracted a lot of interest from both academia and industry, because of their potential to provide flexible and alternative broadband wireless internet connectivity. However, due to various reasons such as unstable wireless link characteristics and multi-hop forwarding operation, the performance of current P2P systems is rather low in WMNs. This dissertation studies the technological challenges involved while deploying P2P systems over WMNs. We study the benefits of location-awareness and resource replication to the P2P overlay while targeting efficient resource lookup in WMNs. We further propose a cross-layer information exchange between the P2P overlay and the WMN in order to reduce resource lookup delay by augmenting the overlay routing table with physical neighborhood and resource lookup history information. Aiming to achieve throughput maximization and fairness in P2P systems, we model the peer selection problem as a mathematical optimization problem by using a set of mixed integer linear equations. A study of the model reveals the relationship between peer selection, resource replication and channel assignment on the performance of P2P systems over WMNs. We extend the model by formulating the P2P download problem as chunk scheduling problem. As a novelty, we introduce constraints to model the capacity limitations of the network due to the given routing and channel assignment strategy. Based on the analysis of the model, we propose a new peer selection algorithm which incorporates network load information and multi-path routing capability. By conducting testbed experiments, we evaluate the achievable throughput in multi-channel multi-radio WMNs. We show that the adjacent channel interference (ACI) problem in multi-radio systems can be mitigated, making better use of the available spectrum. Important lessons learned are also outlined in order to design practical channel and channel bandwidth assignment algorithms in multi-channel multi-radio WMNs.

With National Telecommunications & Information Administration (NTIA) Advanced Wireless Services (AWS-3) auction of frequencies in the 1695-1710 MHz, 1755-1780MHz, and 2155- 2180MHz bands, users of the Aeronautical Mobile Telemetry (AMT) band from 1755- 1850MHz, known as Upper L-Band, could be greatly affected. This paper takes an initial look at how the 1755-1780MHz band will be used by the cellular carriers and presents some preliminary testing results of adjacent channel (band) interference that could be experienced by AMT users. This paper should be considered as the stepping off point for future interference discussions, required analysis, and further testing.

International Telemetering Conference Proceedings / October 23-26, 2000 / Town & Country Hotel and Conference Center, San Diego, California / Bit errors often occur in a wireless communications link when impairments alter the transmitted signal. It is advantageous to be able to predict how well a system will tolerate transmission problems. This paper details laboratory performance measurements and comparisons in terms of evaluating configurations of a digital receiver for Feher patented Quadrature Phase Shift Keying (FQPSK-B) demodulation. The transmitted signal is subjected to calibrated levels of impairments while the receiver performance is monitored in real-time.

The dissertation thesis deals with the investigation of the coexistence of GSM–EDGE and UMTS systems with focus on the physical layer of the systems. The aim is to provide a set of recommendations for practical cooperation while the systems operate in both the separated and the common radio bands. A detailed description of signal processing of both the systems on the physical layer is presented. On the basis of this description, models of both systems were created and implemented in the MATLAB environment. The simulations are focused on the physical layer quality parameters, especially the bit error ratio evaluation for various ratios of useful signal power to noise power during the transmission over the radio channel. Simulation is also used to examine the quality of received useful signal while it is interfered by signals from the same and adjacent channels. The purpose is to determine the isolation between these adjacent channels, when the bit error ratio of the useful signal does not exceed a certain reference value. The simulation results are subsequently subjected to comparison with the results of the experimental measurements in laboratory conditions. Before the measurements are carried out, a study of possible interference types is performed. Consequently, the crucial parameters of the measuring equipment used are verified. From the results of simulations and measurements, the proposal of a minimum and recommended carrier separation between both the systems is presented in order to efficiently utilize the assigned frequency spectrum. Furthermore, for the cooperation in both the separated and the common radio bands, the necessary precautions are given for reaching the required isolation and thereby inter-system interference minimization.