The aim of this thesis is to realize analysis of problematics of aerodynamic calculations of steam boilers on the part of combustion air. On the basis of project documentation realize evaluations of sectional dissipation factors of each component of inlet tract. Realize calculation of summary pressure (draft) loss. Specify components with highest loss and propose options of their optimization.

This thesis deals with road loads, coastdown tests and evaluation of measured data. Thesis consists of two main parts: theoretical and computational. The first part describes road loads with focus on aerodynamic drag and lift force. In the second part, a software tool for processing the measurement per ISO 10521-1 is designed and lift force measured with running resistance method is calculated.

The master's thesis deals with the aerodynamic interaction od two vehicles, modelling in CFD software, how the vehicle behaves in leeward.

The master’sthesis deals with numerical modelling of aerodynamic noisewhich arisesinside of the carcabin. In the first part ofthe thesis simplified model of geometry of the car and of the inside acoustic pressure arecreated. After that numerical analysis of created models of geometry are doneandvarious models of turbulenceare discussed. The results of these CFD simulationswhere then used for changing the model of geometry of the wing mirror. Outputs of these simulations were used for solving the numerical analysis of noise in the car cabin.

This diploma thesis is focused on CFD simulation of two platooning DrivAer cars with varying bodyworks. CFD models are made for bodywork variants Estateback, Fastback and Notchback, which are solved by k-epsilon turbulent model. Influence of rear body design on platooning and aerodynamics characteristics is analyzed.

The subject of this diploma thesis is a design of rudder aerodynamic balance and its optimization with regard to control forces and vertical tail and fuselage loading in critical flight modes – critical engine failure.

The diploma thesis deal with CFD based a to the aerodynamic optimalization of a fuselage and a wing fuselage junction of LSA category aircraft EV 007. Software Fluent is used.

The Diploma thesis is concerned with aerodynamic designi of the ducted fan. The aim of this thesis is to compile the metod of the calculation for the effect of ducted fan. The thesis includes the statistical analysis of compare Rotorcraft, which is used to support the proposal of the basic design parameters. The next part of the thesis contains practical utilization, view of the possible pay load, view of the suitable engines and conrol units. The main part is concerned whit aerodynamic calculation of the stream and fan parameters. In the last part of the thesis, basic parameters of flight performances are calculated.

The vehicle body was measured by using ATOS 3D scanner. Measured data from the ATOS 3D scanner were applied to make a 3D model of vehicle body and to make a 3D model of whole vehicle by using computer program Pro/ENGINEER. The model of vehicle was made with a view for future use of CAD model. Surface of the vehicle model was used for computation of vehicle aerodynamics – aerodynamic static pressure distribution by using CFD software Star-CCM+.

The master's thesis deals with the aerodynamic interaction od two vehicles, modelling in CFD software, how the vehicle behaves in leeward.