<p> A bench scale continuous settling unit was constructed and its operation compared to results of batch settling tests. The particulate solids used were polystyrene spheres with a mean diameter of 285 microns. The concentration profile within the slurry in both the batch and the continuous studies was observed using a light extinction technique.</p> <p> The results show that for the material used in this study, the solids flux limitation of the continuous settler could not be exceeded: the limiting condition in the operation was always the clarification capacity or upward velocity. The batch flux plot shows that this will be the case for any material which exhibits a flux plot that is essentially a single concave curve downwards.</p> / Thesis / Master of Engineering (MEngr)

Batch sedimentation is a method that enables us to understand the mechanism of compaction and compression of sedimenting slurry. However, batch settling behaviour is a very complex phenomenon that is not easily described fully by a mathematical model. This causes unrealistically large empirical calculations when the thickener size estimations are required. Channelling, reverse concentration gradients and the initial concentration of the slurry have large effects on batch settling. Existing procedures do not provide clear relationships involving these three significant variables. In this study, batch sedimentation phenomena are examined in detail and possible explanations are given to clarify the complex behaviour using recent theories. Modern research has shown that channelling is an unwanted formation because channels can change the concentration at the bottom and top of the bed by carrying a great amount of flocs upwards. Batch sedimentation tests were performed using flocculated slurry of Calcium Carbonate at various initial concentrations such as 250 g/l, 500 g/l, 750 g/l and 1000 g/l to observe channelling and reverse concentration gradients. Flux plots for the batch system reveal behaviour which can be attributed to the upward flow of solids. In addition, photographic methods were used to observe settling processes, channelling mechanisms and flocs in the channels. One of the purposes of this work was to examine the phenomenological solid-liquid separation theory of Buscall and White (1987), which employs the material properties of the local volume fraction, compressive yield stress Py ()ö and hindered settling function R()ö to identify the material behaviour in batch sedimentation. Stepped-pressure filtration and batch settling tests were used to measure the material characteristics for the flocculated CaCO3 suspension. Experimental data were demonstrated using Height versus Time and Height versus Concentration graphs and displayed the possible region of reverse concentration gradients and channelling in the settling bed. Mathematical predictions adopted from Usher (2002) were performed employing material characteristics of the material and graphical documentations were presented. The results of mathematical predictions were compared to the experimental results and the modes of sedimentation explained by Lester et al. (2005). Fundamental theoretical models and experimental observations highlight that the main driving force for channelling is the high-pressure gradient at the bottom of the bed and the most important factors that cause channelling are high initial concentration of slurry and settling time. The predictions also show that the material and flocculant used for the batch settling tests demonstrate important effect on the settling process. The knowledge and information gained from this study is valuable to maximize the thickening process.