The degradation of bridge edge beam systems in Sweden entailed the study of new alternativedesigns, which may become more optimal from a life-cycle perspective than the currenttypical solution used (concrete integrated). Subsequently, a U-shaped steel edge beamproposed by the consulting engineering group Ramböll was considered by the SwedishTransport Administration for its use in a real bridge project. This thesis follows theimplementation of this alternative in a bridge project.The goals of the thesis are to study the development of the U-shaped steel edge beam solutionin the case study, and to identify the key factors behind it. The case study consists of a roadframe bridge where a heavily damaged bridge edge beam system is going to be replaced.For the structural design of the solution, a static linear analysis of a vehicle collision has beencarried out with the help of Finite Element Modelling and current codes. The report shows themodelling of the design solution throughout different development phases in the project. Thecommercial software used has been LUSAS.As an outcome of the project, four models have been designed and analysed, two of themdeveloped by the author as proposed solutions. The factors behind the different changes in thedesign have been identified as: (1) structural resistance, (2) constructability and (3) the use ofstainless steel. Moreover, the connection between the steel edge beam and the concrete slabhas been the main critical part for the structural resistance. Finally, the current preliminarymodel at the moment this thesis is written, which was proposed in the project meetings, meetsthe requirements from a structural point of view.

Bridge edge beam system is an increasing concern in Sweden. Because it is the mostvisible part of the structure which is subjected to harsh weather. The edge beamcontributes to the stiffness of overhang slab and helps to distribute the concentratedload. The design of edge beam is not only affected by the structural members, but it isalso affected by non-structural members.The aim of the thesis is to investigate the influence of edge beam on the structuralbehavior of reinforced concrete overhang slab. A three-dimensional (3D) non-linearfinite element model is developed by using the commercial software ABAQUS version6.1.14. The load displacement curves and failure modes were observed. The bendingmoment and shear capacity of the cantilever slab is studied.The validated model from non-linear analysis of reinforced concrete slab gives morestiffer result and leads to the high value of load capacity when comparing with theexperimental test. The presence of the edge beam in the overhang slab of length 2.4 mslightly increases the load capacity and shows ductile behavior due to the self-weightof the edge beam. The non-linear FE-analysis of overhang slab of length 10 m leads tomuch higher load capacity and gives stiffer response as compare to the overhang slabof 2.4 m. The presence of the edge beam in the overhang slab of length 10 m giveshigher load capacity and shows stiffer response when comparing with the overhangslab of length 10 m. This might be due to the self-weight of the edge beam and theoverhang slab is restrained at the right side of the slab.