The problem of the forced film condensation heat transfer of pure steam and steam-air mixture flowing downward a tier of horizontal cylinders is investigated numerically and experimentally. Liquid and vapor-air mixture boundary layers were solved by an implicit finite difference scheme. The effects of the free stream non-condensable gas (air) concentration, free stream velocity (Reynolds number), cylinder diameter, temperature difference and angle of inclination on the condensation heat transfer are analyzed. Inline and staggered tubes arrangements are considered. The mathematical model takes into account the effect of staggering of the cylinders and how condensation is affected at the lower cylinders when condensate does not fall on to the center line of the cylinders. An experimental setup was also manufactured and mounted at METU workshop. A set of experiments were conducted to observe the condensation heat transfer phenomenon and to verify the theoretical results. Condensation heat transfer results are available in ranges from (U&amp / #61605 / = 1 - 30 m/s) for free stream velocity, (m1,&amp / #61605 / = 0.01 -0.8) for free stream air mass fraction, (d = 12.7 -50.8 mm) for cylinder diameter and (T&amp / #61605 / -Tw =10-40 K) for temperature difference. Results show that / a remarked reduction in the vapor side heat transfer coefficient is noticed when very small amounts of air mass fractions present in the vapor. In addition, it decreases by increasing in the cylinder diameter and the temperature difference. On the other hand, it increases by increasing the free stream velocity (Reynolds number). Average heat transfer coefficient at the middle and the bottom cylinders increases by increasing the angle of inclination, whereas, no significant change is observed for that of the upper cylinder. Although some discrepancies are noticed, the present study results are inline and in a reasonable agreement with the theory and experiment in the literature. Down the bank, a rapid decrease in the vapor side heat transfer coefficient is noticed. It may be resulted from the combined effects of inundation, decrease in the vapor velocity and increase in the non-condensable gas (air) at the bottom cylinders in the bank. Differences between the present study results and the theoretical and the experimental data may be resulted from the errors in the numerical schemes used. These errors include truncation and round off errors, approximations in the numerical differentiation for interfacial fluxes at the vapor-liquid interface, constant properties assumption and approximations in the initial profiles. Mixing and re-circulation in the steam-air mixture at the lower tubes may be the other reasons for these deviations.

Dropwise condensation, which collects the condensate liquid in the form of droplets, has attracted a growing interest due to much higher heat transfer coefficient. One important and challenging issue in dropwise condensation is the presence of non-condensable gas (NCG) which drastically reduces its heat transfer performance. Concerning the mechanism understanding, this thesis is aiming to investigate dropwise condensation in case of NCG by combing different methods. Firstly, convective dropwise condensation out of moist air is experimentally investigated under controllable conditions. In modeling, some crucial aspects are reasonably captured: the coupled heat and mass transfer during droplet growth by a multi-scale droplet growth model; the inter-droplet interaction defined by a distributed point sink method; the enhancement of the convective mass transfer using the droplet Sherwood number. Furthermore, a multi-component multi-phase thermal pseudopotential-based LB model is developed to advance the directly numerical simulation of dropwise condensation.