The primary objective of this research was to investigate the relationship between core self evaluations and job insecurity of employees (N = 298) at a government organisation. A cross-sectional survey design was used. Constructs were measured by means of the Core Self-evaluations Scale (CSES), the Job Insecurity Survey Inventory (JISI), and a biographical questionnaire. Results indicated that a practically significant negative relationship exists between self evaluations and job insecurity. It further found that a self evaluation holds some predictive value with regard to job insecurity. / Thesis (M.A. (Industrial Psychology))--North-West University, Vaal Triangle Campus, 2005.

Based on previous testing and analysis, it is believed that North American concrete design codes yield conservative shear designs for precast/prestressed hollow-core slabs in the 203 to 305 mm depth range. The objective of this research program is to calibrate the Canadian code shear equations to precast/prestressed hollow-core slabs, through testing a series of full-scale slabs to failure in shear. A total of twelve hollow-core slabs from one slab producer, using two types of extruders were tested in shear. Test variables include the bearing length and the prestressing level. Results are presented in terms of experimental to predicted capacity using the Canadian and American concrete design codes, the failure mode, crack profiles, and the critical section location for shear. It was concluded that the Canadian code shear equations are inappropriate for use with hollow-core slabs with low prestressing levels in the 203 to 305 mm depth range.

Multi-core programming presents developers with a dramatic paradigm shift. Where the conceptual models of sequential programming largely supported the decoupling of source from underlying architecture, it is now unwise to develop new patterns, abstractions and parallel software in complete isolation from issues of modern hardware utilization. Challenging issues historically associated with complex systems code are now compounded within the parallel domain. These issues are manifested at all stages of software development including design, development, testing and maintenance. Programmers currently lack the essential tools to even partially automate reasoning techniques, resource utilization and system configuration management. Current trial and error strategies lack a systematic approach that will scale to growing multi-core and multi-processor environments. In fact, current algorithm and data layout conceptual models applied to design, implementation and pedagogy often conflict with effective parallelization strategies. This disertation calls for a rethinking, rebuilding and retooling of conceptual models, taking into account opportunities to introduce parallelism for multi-core architectures from the ground up. In order to establish new conceptual models, we must first 1) identify inherent complexities in multi-core development, 2) establish support strategies to make handling them more explicit and 3) evaluate the impact of these strategies in terms of proposed software development practices and tool support. / Graduate

MANE (MCNP ACE from NJOY & ENDF), a code for generating continuous energy cross sections at arbitrary temperatures, was created. Cross sections were evaluated using NJOY99 such that they would agree with the cross sections provided by MCNP5. The MANE cross sections were found to be in very good agreement with those provided by MCNP5 with some minor exceptions caused by round-off errors and some differences in the unresolved resonance region. Differences in the resonance region are caused by differences in the random number generator used to start the cross section calculations. The MANE cross sections were verified against the MCNP5 cross sections in five unique MCNP configurations: an 8.7% enriched MOX fuel pin cell, a UO₂ assembly (controlled and uncontrolled), a MOX assembly, and a whole core configuration containing the 3 assemblies. In each of these cases, eigenvalue and tally density results were found to be in very good agreement with one another.

No description available.

Cretaceous continental extension was accommodated by the development of the Paparoa Metamorphic Core Complex, resulting in the separation of New Zealand from Gondwana. High grade (Lower Plate) and low grade (Upper Plate) rocks are separated by the Ohika and Pike Detachment Faults. The two detachment faults have distinctly different histories, with greater exhumation along the Pike Detachment Fault. The onset of crustal extension is proposed to have commenced along the Pike Detachment Fault at 116.2 ± 5.9 Ma (Rb/Sr dating). Both geochemical and geochronological approaches are adopted for this thesis, through the in situ analysis of oxygen and hafnium isotope ratios, trace metals and U-Pb content. Chemical changes are tracked during the petrogenesis of the Buckland Granite, with mafic replenishment observed in the later stages of crystallisation. Crystallisation temperatures of the Buckland Granite are calculated using zircon saturation thermometry, with an average Ti-in-zircon temperature of 697℃ (upper-amphibolite facies). Inherited zircons in Lower Plate rocks show distinct age peaks at c. 1000, 600 and 300 Ma, illustrating the incorporation of heterogeneous local crust (Greenland Group and Karamea Batholith). Model ages (TDM) are calculated for inherited zircons of the Lower Plate rocks, which record the time at which magma bodies (zircon host rocks) were extracted from the mantle. Maximum and minimum model ages for the Buckland Granite average at 3410 Ma and 2969 Ma, with the maximum TDM value of 3410 Ma coinciding with the proposed major crustal formation event of the Gondwana supercontinent at c. 3.4-3.5 Ga. Two distinct U-Pb zircon age peaks are observed in the Buckland Granite at 102.4 ± 0.7 and 110.3 ± 0.9 Ma. The 110.3 ± 0.9 Ma age is interpreted as the crystallisation age of the pluton, while the 102.4 ± 0.7 is proposed to represent a younger thermal (magmatic?) event associated with the 101-102 Ma Stitts Tuff.

The research on Determination of Residual Gas Saturation and Gas-Water Relative Permeability in Water-Driven Gas Reservoirs is divided into four stages: literature research, core-flooding experiments, development and application of a new technique for reservoir simulation. Overall, all stages have been completed successfully with several breakthroughs in the areas of Special Core Analysis (SCAL), reservoir engineering and reservoir simulation technology.Initially, a literature research was conducted to survey all available core analysis techniques and their individual characteristics. The survey revealed that there are several core analysis techniques for measuring residual gas saturation (Sgr) and hence, the lack of a commonly agreed method for measuring Sgr. The often-used core analysis techniques are steady-state displacement, co-current imbibition, centrifuge and counter-current imbibition. In this research, all centrifuge tests were performed with a decane-brine system to investigate the possibility of replacing gas with a 'model fluid' to minimise errors due to gas compressibility. Furthermore, Sgr is a function of testing temperature and pressure, types of fluid, wettability, viscosity, flow rate and overburden pressure. Consequently, large uncertainties are associated with measured Sgr and the recoverable gas reserves for water-driven gas reservoirs.Due to the lack of a common method for measuring Sgr, the first important step is to clarify which is the most representative core analysis technique for measuring Sgr. In Stage 2 of the research, core analysis experiments were performed with uniform fluids and ambient temperature. In the core flooding experiments, four different sets of core plugs from various gas reservoirs were selected to cover a wide range of permeability and porosity. Finally, all measured Sgr from the various common core analysis techniques ++ / were compared.The evidence suggested that steady-state displacement and co-current imbibition tests are the most representative techniques for reservoir application. Steady-state displacement also yields the complete relative permeability (RP) data but it requires long stabilisation times and is costly.In the third stage, a new technique was successfully developed for determining both Sgr and gas-water RP data. The new method consists of an initial co-current imbibition experiment followed by the newly developed correlation (Mulyadi, Amin and Kennaird correlation). Co-current imbibition is used to measure the end-point data, for example, initial water saturation (Swi) and Sgr. The MAK correlation was developed to extend the co-current imbibition test by generating gas-water relative permeability data. Unlike previous correlations, MAK correlation is unique because it incorporates and exhibits the formation properties, reservoir conditions and fluid properties (for example, permeability, porosity, interfacial tension and gas density) to generate the RP curves. The accuracy and applicability of MAK correlations were investigated with several sets of gas-water RP data measured by steady-state displacement tests for various gas reservoirs in Australia, New Zealand, South-East Asia and U.S.A. The MAK correlation proved superior to previously developed correlations to demonstrate its robustness.The purpose of the final stage was to aggressively pursue the possibility of advancing the application of the new technique beyond special core analysis (SCAL). As MAK correlation is successful in describing gas water RP in a core plug scale, it is possible to extend its application to describe the overall reservoir flow behaviour. This investigation was achieved by implementing MAK correlation into a 3-D reservoir simulator (MoReS) and performing simulations on a producing ++ / field.The simulation studies were divided into two categories: pre and post upscaled application.The case studies were performed on two X gas-condensate fields: X1 (post upscaled) and X2 (pre upscaled) fields. Since MAK correlation was developed for gas-water systems, several modifications were required to account for the effect of the additional phase (oil) on gas and water RP in gas-condensate systems. In this case, oil RP data was generated by Corey's equations. Five different case studies were performed to investigate the individual and combination effect of implementing MAK correlation, alternative Swi and Sgr correlations and refining porosity and permeability clustering. Moreover, MAK correlation has proven to be effective as an approximation technique for cell by cell simulation to advance reservoir simulation technology.

Lic.-avh. (sammanfattning) Stockholm : Kungliga Tekniska högskolan, 2007. / Härtill 3 uppsatser.

Thesis (Ph. D.)--Massachusetts Institute of Technology and Woods Hole Oceanographic Institution, 2007. / "Joint Program in Oceanography/Applied Ocean Science and Engineering"--Cover. Title from Web page (viewed on Mar. 24, 2008). "September 2007." Includes bibliographical references.

Diss. Växjö : Växjö uniersitet, 2007.