1 |
The effect of blasting on the rockmass for designing the most effective preconditioning blasts in deep-level gold minesToper, Ali Zafer 18 April 2011 (has links)
PhD, Faculty of Engineering and the Built Environment, School of Mining Engineering, University of the Witwatersrand, 2003
|
2 |
Studies of electron irradiation induced deep level defects in p-type 6H-SICLuo, Jiaming, 羅佳明 January 2009 (has links)
published_or_final_version / Physics / Master / Master of Philosophy
|
3 |
Deep level transient spectroscopic study of nitrogen-implanted ZnO single crystalDing, Guangwei, 丁光炜 January 2010 (has links)
published_or_final_version / Physics / Master / Master of Philosophy
|
4 |
Deep level transient spectroscopic study of intrinsic defects in particle-irradiated ZnO single crystal materialsLu, Xiaohong, 吕小红 January 2012 (has links)
Zinc oxide (ZnO), as a Ⅱ-Ⅵ compound semiconductor with a wide direct band gap, has attracted great attention from the worldwide researchers for its potential application in the fields of spintronics and optoelectronics. At present research about the defects in ZnO and ZnO-based materials is still far from complete. The deep level defects in melted grown ZnO single crystal induced by helium ions implantation and electron irradiation, as well as their thermal evolution, were studied in this research using the technique of deep level transient spectroscopy (DLTS) and photoluminescence (PL).
DLTS results indicated that, besides E3 (????~0.28 ????) trap which was widely observed in the as-grown ZnO samples, the deep level with ????~0.92 ???? was also indentified in the helium-implanted ZnO samples, which was introduced by the ion implantation and tentatively assigned to be the oxygen vacancy (VO). This deep level was removed after 350 oC annealing in argon gas. Annealing at 350 oC also brought along a new deep level with ????~0.66???? into helium-implanted samples which could be annealed out by 650 oC annealing in argon gas. The electron irradiation induced a deep level with ????~0.59 ???? into ZnO, which was probably associated with the singly charged state of VO. This deep level also tended to be removed at 350 oC annealing in argon gas. The PL spectra revealed that both helium implantation and electron irradiation could improve the bound-exciton peak. Helium implantation also introduced defects emission at 1.90 eV , which was the red luminescence band, into the ZnO single crystal materials. This red luminescence band peak might be associated with DAP recombination. Electron irradiation might restrain the green luminescence in ZnO single crystal. The fine structures could disappear as the measurement temperature increased, leaving the green luminescence band only. / published_or_final_version / Physics / Doctoral / Doctor of Philosophy
|
5 |
The development of positron deep level transient spectroscopy using variable energy positron beam and conventional deep level transientspectroscopy using digital capacitance meter張敬東, Zhang, Jingdong. January 2002 (has links)
published_or_final_version / Physics / Master / Master of Philosophy
|
6 |
Studies of electron irradiation induced deep level defects in p-type 6H-SICLuo, Jiaming, January 2009 (has links)
Thesis (M. Phil.)--University of Hong Kong, 2009. / Includes bibliographical references. Also available in print.
|
7 |
The development of positron deep level transient spectroscopy using variable energy positron beam and conventional deep level transient spectroscopy using digital capacitance meter /Zhang, Jingdong. January 2002 (has links)
Thesis (M. Phil.)--University of Hong Kong, 2002. / Includes bibliographical references (leaves 117-121).
|
8 |
Carrier Lifetime Relevant Deep Levels in SiCBooker, Ian Don January 2015 (has links)
Silicon carbide (SiC) is currently under development for high power bipolar devices such as insulated gate bipolar transistors (IGBTs). A major issue for these devices is the charge carrier lifetime, which, in the absence of structural defects such as dislocations, is influenced by point defects and their associated deep levels. These defects provide energy levels within the bandgap and may act as either recombination or trapping centers, depending on whether they interact with both conduction and valence band or only one of the two bands. Of all deep levels know in 4H-SiC, the intrinsic carbon vacancy related Z1/2 is the most problematic since it is a very effective recombination center which is unavoidably formed during growth. Its concentration in the epilayer can be decreased for the production of high voltage devices by injecting interstitial carbon, for example by oxidation, which, however, results in the formation of other new deep levels. Apart from intrinsic crystal flaws, extrinsic defects such as transition metals may also produce deep levels within the bandgap, which in literature have so far only been shown to produce trapping effects. The focus of the thesis is the transient electrical and optical characterization of deep levels in SiC and their influence on the carrier lifetime. For this purpose, deep level transient spectroscopy (DLTS) and minority carrier transient spectroscopy (MCTS) variations were used in combination with time-resolved photoluminescence (TRPL). Paper 1 deals with a lifetime limiting deep level related to Fe-incorporation in n-type 4H-SiC during growth and papers 2 and 3 focus on identifying the main intrinsic recombination center in p-type 4H-SiC. In paper 4, the details of the charge carrier capture behavior of the deeper donor levels of the carbon vacancy, EH6/7, are investigated. Paper 5 deals with trapping effects created by unwanted incorporation of high amounts of boron during growth of n-type 4H-SiC which hinders the measurement of the carrier lifetime by room temperature TRPL. Finally, paper 6 is concerned with the characterization of oxidation-induced deep levels created in n- and p-type 4H- and 6H-SiC as a side-product of lifetime improvement by oxidation. In paper 1, the appearance of a new recombination center in n-type 4H-SiC, the RB1 level is discussed and the material is analyzed using room temperature TRPL, DLTS and pnjunction DLTS. The level appears to originate from a reactor contamination with Fe, a transition metal that generally leads to the formation of several trapping centers in the bandgap. Here it is found that under specific circumstances beneficial to the growth of high-quality material with a low Z1/2 concentration, the Fe incorporation also creates an additional recombination center capable of limiting the carrier lifetime. In paper 2, all deep levels found in p-type 4H-SiC grown at Linköping University which are accessible by DLTS and MCTS are investigated with regard to their efficiency as recombination centers. We find that none of the detectable levels is able to reduce carrier lifetime in p-type significantly, which points to the lifetime killer being located in the top half of the bandgap and having a large hole to electron capture cross section ratio (such as Z1/2, which is found in n-type material), making it undetectable by DLTS and MCTS. Paper 3 compares carrier lifetimes measured by temperature-dependent TRPL measurements in n- and p-type 4H-SiC and it is shown that the lifetime development over a large temperature range (77 - 1000 K) is similar in both types. This is interpreted as a further indication that the carbon vacancy related Z1/2 level is the main lifetime killer in p-type. In paper 4, the hole and electron capture cross sections of the near midgap deep levels EH6/7 are characterized. Both levels are capable of rapid electron capture but have only small hole capture rates, making them insignificant as recombination centers, despite their advantageous position near midgap. Minority carrier trapping by boron, which is both a p-type dopant and an unavoidable contaminant in 4H-SiC grown by CVD, is investigated in paper 5. Since even the shallow boron acceptor levels are relatively deep in the bandgap, minority trap and-release effects are detectable in room-temperature TRPL measurements. In case a high density of boron exists in n-type 4H-SiC, for example leached out from damaged graphite reactor parts during growth, we demonstrate that these trapping effects may be misinterpreted in room temperature TRPL measurements as a long free carrier lifetime. Paper 6 uses MCTS, DLTS, and room temperature TRPL to characterize the oxidation induced deep levels ON1 and ON2 in n- and p-type 4H- and their counterparts OS1-OS3 in 6H-SiC. The levels are found to all be positive-U, coupled two-levels defects which trap electrons efficiently but exhibit very inefficient hole capture once the defect is fully occupied by electrons. It is shown that these levels are incapable of significantly influencing carrier lifetime in epilayers which underwent high temperature lifetime enhancement oxidations. Due to their high density after oxidation and their high thermal stability they may, however, act to compensate n-type doping in low-doped material.
|
9 |
Photoconductivity Spectroscopy of Deep Level Defects of ZnO Thin Films Grown by Thermal EvaporationSteward, Ian 03 September 2010 (has links)
No description available.
|
10 |
Converting an ice storage facility to a chilled water system for energy efficiency on a deep level gold mine / Dirk Cornelius UysUys, Dirk Cornelius January 2015 (has links)
The South African gold mining sector consumes 47% of the mining industry’s electricity. On a deep level gold mine, 20% of the energy is consumed by the refrigeration system. The refrigeration system cools 67 ˚C virgin rock temperatures underground. Underground cooling demand increases significantly with deeper mining activities. Various cooling systems are available for underground cooling. This study focuses on the electricity usage of an ice storage system versus a chilled water system for underground cooling.
An energy-savings approach was developed to determine possible power savings on the surface refrigeration system of Mine M. The savings approach involved converting an ice storage system to a chilled water system and varying the water flow through the system. The water flow was varied by installing variable speed drives on the evaporator and condenser water pumps. The feasibility of the energy-efficiency approach was simulated with a verified simulation model.
Simulation results indicated the feasibility of converting the thermal ice storage to a chilled water system and implementing the energy-efficiency approach on Mine M. Simulated results indicated a 9% electricity saving when using a chilled water system. Various problems encountered by the mine were also a motivation to convert the thermal ice storage system.
Converting an ice storage facility to a chilled water system for energy efficiency on a deep level gold mine
Energy management is achieved through the monitoring, controlling and reporting of the implemented savings approach.
Converting the glycol plant and recommissioning the chilled water plant gave the mine an additional chiller as backup to sufficiently meet underground demand. An annual summer power saving of 1.5 MW was achieved through the conversion and control strategy. It is concluded that conversion of the thermal ice storage system on Mine M results in an energy- and cost saving. / MIng (Mechanical Engineering), North-West University, Potchefstroom Campus, 2015
|
Page generated in 0.083 seconds