The seismic design maps on ASCE 7-05, International Building Code- 2006/2009, assumed uniform hazard ground motion with 2% probability of exceedance in 50 years for the entire conterminous U.S. But, Luco et al in 2007 pointed out that as uncertainties in collapse capacity exists in structures, an adjustment on uniform hazard ground motion was proposed to develop new seismic design maps. Thus, risk-targeted ground motion with 1% probability collapse in 50 years is adopted on ASCE 7-10. Even though these seismic design maps are developed for buildings, performance-based bridge design is done using same maps. Because significance difference lies on design procedure of buildings and bridges this thesis suggests some adjustment should be made on uncertainty in the collapse capacity(β) when using for bridge design. This research is done in 3 cities of U.S— San Francisco, New Madrid and New York. Hazard curve is drawn using 2008 version of USGS hazard maps and risk- targeted ground motion is calculated using equation given by Luco et al adjusting the uncertainty in collapse capacity(β) to be 0.9 for bridge design instead of 0.8 as used for buildings. The result is compared with existing result from ASCE 7-10, which uses β=0.6. The sample design response spectrum for site classes A, B, C and D is computed for all 3 cities using equations given in ASCE 7-10 for all β. The design response spectrum curves are analyzed to concluded that adjustment on uncertainty in collapse capacity should be done on ASCE 7-10 seismic design maps to be used for performance-based bridge design.

The Tubed Mega Frame is a new structure concept for high-rise buildings which is developed by Tyréns. In order to study the structural performance as well as the efficiency of this new concept, a global analysis of the Tubed Mega Frame structure is performed using finite element analysis software ETABS. Besides, the lateral loads that should be applied on the structure according to different codes are also studied. From the design code study for wind loads and seismic design response spectrums, it can be seen that the calculation philosophies are different from code to code. The wind loads are approximately the same while the design response spectrums vary a lot from different codes. In the ETABS program, a 3D finite element model is built and analyzed for linear static, geometric non-linearity (P-Delta) and linear dynamic cases. The results from the analysis in the given scope show that the Tubed Mega Frame structural system is potentially feasible and has relatively high lateral stiffness and global stability. For the service limit state, the maximum story drift ratio is within the limitation of 1/400 and the maximum story acceleration is 0.011m/sec 2 which fulfill the comfort criteria.

The influence of the recommended LRFD Guidelines for the seismic design of highway bridges in Virginia was investigated by analyzing two existing bridges. The first bridge has prestressed concrete girders and is located in the Richmond area. The second bridge has steel girders and is located in the Bristol area. The analysis procedure for both bridges is similar. First the material and section properties were calculated. Then the bridge was modeled in RISA 3D. Live and dead load were imposed on the bridge to calculate the cracked section properties of the bridge. The period of vibration of the bridge was also calculated. After the soil class of the bridge was determined, the design response spectrum curve of the bridge was drawn. The spectral acceleration obtained from the design spectrum curve was used to calculate the equivalent earthquake loads, which were applied to the superstructure of the bridge to obtain the earthquake load effects. Live and dead loads were also applied to get the live and dead load effects. The combined effects of the dead, live and earthquake loads were compared to the interaction diagram of the columns and moment strength of the columns. The details of the bridge design were also checked with the corresponding seismic design requirement.A parametric study was performed to explore the effects of different column heights and superstructure heights in different parts of Virginia. The column longitudinal reinforcing was increased to satisfy the bridge axial loads and moments that are not within the column interaction diagram. / Master of Science