Due to the continuous power supply reduction, Charge Pumps, also referred to as DC-DC converters, circuits are widely used in integrated circuits (ICs) to generate high voltages for many applications, such as EEP-ROMs, Flash memories for programming and erasing of the floating gate, switched capacitor circuits, operational amplifiers, voltage regulators, LCD drivers, piezoelectricactuators, etc. A charge pump is a kind of DC to DC converter that uses capacitors as energy storage elements to create either a higher or lower voltage power source. The development of the charge pumps is motivated by ever increasing the needs for the small form factor (i.e small size and low weight), high-conversion-efficiency and low costpower management system, which is the best candidate suitable to meet the needs of continuosly shrinking portable electronic devices like MP3 players, cellular phones, PDA's. / text

The objective of this research is to determine if it is possible to reduce the number of organic solar cells required to power a load using a DC to DC converter thereby reducing the cost of the organic solar array system. An organic solar power system designer may choose an organic implementation of a DC to DC converter to go along with the organic solar cell array. Common DC to DC converters include the buck converter, boost converter, buck/boost converter, and Cuk converter, all of which are not good candidates for organic implementation due to their use of inductors. Organic inductors are relatively more lossy than organic capacitors. So, an inductor-less DC to DC converter, such as the Dickson charge pump, would be a better candidate for organic implementation. Solar cells connected in an array configuration usually do not perform up to their full potential due to current and voltage mismatches between solar cells. These mismatches can be related to each solar cell's circuit model parameters such as the photon current density, diode ideality factor, diode reverse saturation current density, parallel resistance, and series resistance. This research varies these circuit model parameters as dependent variables, and observes the loads and power levels that make the Dickson charge pump a feasible option. The results show that current mismatch does produce an opportunity to use a DC to DC converter to save the use of a few solar cells. However, the Dickson charge pump was found to be infeasible due to an input voltage requirement that could not be met using the tested organic solar cells.

No description available.