Masters thesis deals with formation of diffusion barrier coatings by means of powder mixtures chemical vapor deposition. Its theoretical part is focused on the problems with diffusion barriers formation, where predominantly three most commonly used methods are introduced, i.e. CVD from powder mixtures, active gasses and slurries. The experimental part of master thesis deals with the formation of nickel-aluminide diffusion barriers on Inconel 713LC superalloy substrate, where was for aluminization used six different powder mixtures at the temperature of 800 °C and dwell of 0, 2 and 5 hours.

Diplomová práce Hodnocení krátkodobého efektu aplikace rázové vlny na MTrP Abstract This thesis concerns the application of radial extracorporeal shockwave therapy into muscular trigger points. It's location is derived from the descending part of trapezius muscle on the side of the dominant upper extremity. The performance analysis is based on using partially double-blind placebo-controlled, randomized clinical trial. The effects of the therapy were investigated in 28 subjects divided into experimental and control groups and objectively manifested by measuring the pressure pain threshold. Furthermore, the measuring of the active range of motion of the cervical spine, and the measuring of the maximal voluntary wrist and third finger flexion (measured before and after the therapy). After the therapy, the pressure pain threshold value of the trigger point located in trapezius muscle increased on average from 199 to 295 kPa (p = 0,025). The cervical spine lateral flexion increased on average by 3 degrees towards to the side of non-dominant upper extremity (p = 0,045). This study also investigates the pressure pain threshold value changes of 7 reference points placed remotely from the area of the application. After the shockwave therapy, the pressure pain threshold values of these reference points increased on...

Master´s thesis is focused on diagnostics of semiconductor materials by EBIC method (measuring of currents induced beam), determination of the lifetime of minority carriers, or their diffusion length. The theoretical part is aimed at the principle of scanning electron microscopy, the characteristic properties of the microscope and the signals generated by the interaction of the primary electron beam with the sample. The thesis describes a structure of semiconducting silicon, band models, types of lattice defects and doped of semiconductor structures. After that it is described the theory of calculation of the diffusion length of minority carriers in semiconductors of type N and P. The aim of the experiment part of the thesis is to measure the properties of the semiconductor structure by EBIC and determination of diffusion length and lifetime of minority charge carriers based on the measured data The aim of the experiment part of the thesis is to measure the properties of the semiconductor structure by EBIC and determination of diffusion length and lifetime of minority charge carriers on the basis of the measured data.

This work deals with method for characterization of photovoltaic solar cells based on evaluation of solar cell response to fast transients. The voltage of the cell in both forward and reverse polarisation was controlled by current pulse exciting. Real reverse breakdown voltage and exact value of serial resistance of the cell can be obtained easily by evaluation of the transient curves recorded by digital osciloscope. By negotiation of the time constants of the cell response to excitation in forward polarisation the lifetime of minority carriers in semiconductor bulk can be estimated.

Most acoustic measurements and parameters provided by a manufacturer of acoustic elements, which are offering additional solutions to room acoustics as well as acoustic construction works, are mainly limited to the parameters associated with absorption of individual elements. Until now, these diffusional elements have been neglected. Diffusi- onal panels are used to e.g. eliminate direct reflection of sound waves to the listener or reflection of sound waves concentrated at one point. Combination of absorptive acoustic panels and diffusion elements results in a space that is customised to the submitter’s needs.

In thesis is dealt with problematic of how the value of air permeability may be affected by properties for water vapour diffusion with regard to OSB material There were chosen two main brands of OSB at Czech trade market Two specimens of OSB with different thickness were chosen for each brand. As a first the specimens were tested for air tightness to work out a value of air permeability for each specimen. Afterwords, the testing was conducted for gaining properties of water vapour diffusion on each specimen. As a final assessment was analysed the impact of properties of water vapour diffusion on the air tightness for each specimen. The general meaning of gaining higher air tightness with higher water vapour resistance was proved . It was shown that with raising thickness is usually gotten higher value of water vapour diffusion resistance. However it could not mean getting high air tightness. The crucial parameter is the quality of the material for gaining higher resistance against water vapour diffusion as well as for higher airtightness.

The thesis deals with the evaluation of the influence of foam rolling on selected parameters of somatosensory perception (pressure-algic threshold, vibrotactile sensation). The theoretical part discusses fascial tissue, summarizes the current knowledge of foam rolling and focuses on the mechanisms of pain and vibrotactile sensation. The research part consists of a randomized blind study on a group of 15 healthy probands (11 women, 4 men), which evaluates the effect of foam rolling. The effect is objectivized by pressure algometry and vibrametry on the m. rectus femoris and m. biceps femoris of both lower limbs (measured before and after therapy). The value of the pressure pain threshold (PPT) increased after foam rolling. Vibrotactile threshold (VT) was lower after foam rolling than before its use, which means that vibrotactile sensitivity was increased. The results show that these changes do not occur only in the interventioned m. rectus femoris, but some changes in parameters can be found in other muscles as well. Keywords fascial tissues, foam rolling, pressure algometry, pressure pain treshold, PPT, vibrametry, somatosensory system, nociception, diffuse noxious inhibitory control, DNIC

Diploma thesis "Diffusion of innovations in medical setting: A Meta-analysis of case studies" deals with contemporary shape of empirical diffusion research in public health and medical sociology field. By means of meta-analysis based on 23 case studies that was targeted on chosen aspects of investigation within the diffusion of innovations topic, on whole design of the research and on particular methodological procedures we arrived to wide thematic scope of these studies and their significant heterogeneity regarding methodological aspects. This fact testifies the large amount of possibilities that diffusion studies provide, even in such narrowed research area. Meta-analytical findings and studies divided into several typologies were then compared with an older study, where a pragmatic orientation of newer studies on a specific aspect of the whole process and practical task that needs to be solved, turned up. The sociological micro-theories making is then overshadowed by dealing with the actual field problems acute even more in the field of medicine. The communication processes at the level of interpersonal communication (that are, according to the generally accepted definition of diffusion of innovation, principal for the diffusive mechanism) as a dominant object of examination almost faded out....

Diffuse large B-cell lymphoma (DLBCL) is the most common type of non-Hodgkin lymphoma. It is a molecular and prognostic heterogeneous disease. Three main genetic subtypes are called germinal center-like DLBCL (GC-like DLBCL), non-germinal center-like DLBCL (nonGC-like DLBCL) and primary mediastinal B-cell lymphoma (PMBL). These subtypes can be reliably distinguished only with usage of gene expression profiling (GEP). The GEP method can be applied only when fresh frozen tissue is available. The method is technically difficult and expensive. Thus, it is not used routinely. Since the DLBCL subtypes differ in prognosis, it is extremely important to be able to distinguish them. The presented thesis is focused on distinguishing of PMBL diagnosis in the group of DLBCL. Easily stored formalin-fixed, paraffin-embedded tissue (FFPE) and gene expression analysis using real-time quantitative polymerase chain reaction (RTqPCR) are used. In the first step, PMBL and DLBCL cases were distinguished with an internationally accepted clinical-pathological method. The agreement between clinical-pathological diagnosis and GEP is only 76%. In the presented text a genetic algorithm for PMBL/DLBCL distinguishing is suggested. It uses three carefully chosen genes and their expression is measured with RTqPCR. Both, the...

Ultrasound investigation is one of meaningful imaging at present. Advantages of ultrasound are, that it hasn´t side effects as a rtg radiation and it is noninvasive. Ultrasound diagnostic is exploited in all branch of medicine (urology, cardiology, orthopeadist, gynecology etc.) to display organs, tissues and cavities of the human body. We use display in 2D, 3D and most modern display in 4D. We can encounter with many kinds of artifact. Artifacts are described more closely at 3rd chapter. Speckle noise deteriorates informative yiled of ultrasound picture. We try to remove speckle noise by simpler methods or more complex methods of filtration. These methods are described at 5th chapter. Programme for speckle filtering from pictures is part of this master´s thesis.