abstract: Dimensionality assessment is an important component of evaluating item response data. Existing approaches to evaluating common assumptions of unidimensionality, such as DIMTEST (Nandakumar & Stout, 1993; Stout, 1987; Stout, Froelich, & Gao, 2001), have been shown to work well under large-scale assessment conditions (e.g., large sample sizes and item pools; see e.g., Froelich & Habing, 2007). It remains to be seen how such procedures perform in the context of small-scale assessments characterized by relatively small sample sizes and/or short tests. The fact that some procedures come with minimum allowable values for characteristics of the data, such as the number of items, may even render them unusable for some small-scale assessments. Other measures designed to assess dimensionality do not come with such limitations and, as such, may perform better under conditions that do not lend themselves to evaluation via statistics that rely on asymptotic theory. The current work aimed to evaluate the performance of one such metric, the standardized generalized dimensionality discrepancy measure (SGDDM; Levy & Svetina, 2011; Levy, Xu, Yel, & Svetina, 2012), under both large- and small-scale testing conditions. A Monte Carlo study was conducted to compare the performance of DIMTEST and the SGDDM statistic in terms of evaluating assumptions of unidimensionality in item response data under a variety of conditions, with an emphasis on the examination of these procedures in small-scale assessments. Similar to previous research, increases in either test length or sample size resulted in increased power. The DIMTEST procedure appeared to be a conservative test of the null hypothesis of unidimensionality. The SGDDM statistic exhibited rejection rates near the nominal rate of .05 under unidimensional conditions, though the reliability of these results may have been less than optimal due to high sampling variability resulting from a relatively limited number of replications. Power values were at or near 1.0 for many of the multidimensional conditions. It was only when the sample size was reduced to N = 100 that the two approaches diverged in performance. Results suggested that both procedures may be appropriate for sample sizes as low as N = 250 and tests as short as J = 12 (SGDDM) or J = 19 (DIMTEST). When used as a diagnostic tool, SGDDM may be appropriate with as few as N = 100 cases combined with J = 12 items. The study was somewhat limited in that it did not include any complex factorial designs, nor were the strength of item discrimination parameters or correlation between factors manipulated. It is recommended that further research be conducted with the inclusion of these factors, as well as an increase in the number of replications when using the SGDDM procedure. / Dissertation/Thesis / M.A. Educational Psychology 2013

abstract: The purpose of this study was to investigate the effect of complex structure on dimensionality assessment in compensatory and noncompensatory multidimensional item response models (MIRT) of assessment data using dimensionality assessment procedures based on conditional covariances (i.e., DETECT) and a factor analytical approach (i.e., NOHARM). The DETECT-based methods typically outperformed the NOHARM-based methods in both two- (2D) and three-dimensional (3D) compensatory MIRT conditions. The DETECT-based methods yielded high proportion correct, especially when correlations were .60 or smaller, data exhibited 30% or less complexity, and larger sample size. As the complexity increased and the sample size decreased, the performance typically diminished. As the complexity increased, it also became more difficult to label the resulting sets of items from DETECT in terms of the dimensions. DETECT was consistent in classification of simple items, but less consistent in classification of complex items. Out of the three NOHARM-based methods, χ2G/D and ALR generally outperformed RMSR. χ2G/D was more accurate when N = 500 and complexity levels were 30% or lower. As the number of items increased, ALR performance improved at correlation of .60 and 30% or less complexity. When the data followed a noncompensatory MIRT model, the NOHARM-based methods, specifically χ2G/D and ALR, were the most accurate of all five methods. The marginal proportions for labeling sets of items as dimension-like were typically low, suggesting that the methods generally failed to label two (three) sets of items as dimension-like in 2D (3D) noncompensatory situations. The DETECT-based methods were more consistent in classifying simple items across complexity levels, sample sizes, and correlations. However, as complexity and correlation levels increased the classification rates for all methods decreased. In most conditions, the DETECT-based methods classified complex items equally or more consistent than the NOHARM-based methods. In particular, as complexity, the number of items, and the true dimensionality increased, the DETECT-based methods were notably more consistent than any NOHARM-based method. Despite DETECT's consistency, when data follow a noncompensatory MIRT model, the NOHARM-based method should be preferred over the DETECT-based methods to assess dimensionality due to poor performance of DETECT in identifying the true dimensionality. / Dissertation/Thesis / Ph.D. Educational Psychology 2011