Call number: LD2668 .T4 1986 B62 / Master of Science / Biological and Agricultural Engineering

ITC/USA 2008 Conference Proceedings / The Forty-Fourth Annual International Telemetering Conference and Technical Exhibition / October 27-30, 2008 / Town and Country Resort & Convention Center, San Diego, California / As satellite ground systems migrate toward network-centric, distributed architectures, controlling remote ground equipment becomes a central issue. While many protocols and approaches exist that address remote control and status, there is little agreement on a common solution. Device vendors and system integrators commonly find themselves integrating multiple protocols to meet a wide range of requirements. Technologies change and new protocols evolve that result in yet more options to be considered. However, the fundamental aspects of device control remain constant. The Ground Equipment Monitoring Service (GEMS) seeks to define a standard model for device control independent of the underlying protocols and technologies. Using this approach, a wide range of protocols can be mapped to the GEMS model. Systems using different protocols can then rely on the common mapping and utilize translators to connect heterogeneous components with little integration costs. This paper describes the state of the specification and potential uses of the GEMS specification in Satellite Ground Systems. Interactions between the GEMS specification and other standards such as the CCSDS SLE Complex Management services are also presented.

ITC/USA 2015 Conference Proceedings / The Fifty-First Annual International Telemetering Conference and Technical Exhibition / October 26-29, 2015 / Bally's Hotel & Convention Center, Las Vegas, NV / Changing from L/S-Band to C-Band requires not only new equipment. Even the characteristics of the new frequencies just as the new frequency environment are a challenge for the operations in this bands when changing from a well-known frequency environment to a unknown new one. This paper describes the way used at Airbus Defense and Space Flight Test Ground Station to get experience with new equipment and to learn more about the new environment. Repeatable and comparable tests allowed training for the operators and the optimization of the equipment and procedures with the new environment. Although many of the problems or features observed during the tests where expected in advance, but even unexpected results could be identified.

published_or_final_version / Business Administration / Master / Master of Business Administration

published_or_final_version / Business Administration / Master / Master of Business Administration

published_or_final_version / Nursing Studies / Master / Master of Nursing

published_or_final_version / Nursing Studies / Master / Master of Nursing

Experiments were conducted with 180 m long T-tape and Agrifim emitter lateral lines in the laboratory and field to determine the effects of water temperature and sediment concentration on the hydraulics of drip irrigation laterals. The flow regime was laminar through the T-tape emitter and turbulent through the Agrifim emitter. Water temperature decreased along the lateral line in the laboratory where the inlet water temperature was higher than ambient air. In contrast, temperatures increased along a lateral line exposed to the sun in the field with an inlet temperature lower or slightly higher than that of air. The rate of increase or decrease was more pronounced towards the end of the line. The effect of temperature was highly significant on emitter flow rates obtained for a T-tape emitter as opposed to those recorded for the Agrifim emitter in the laboratory; however, the increase of emitter flow rates due to temperature was reduced by plugging in the field. Discharges of T-tape emitters were dominated by the hydraulic pressure for the first half of the line with the water temperature being more important for the second half of the line in both the laboratory and field. Measured discharges of Agrifim emitters were dominated by the hydraulic pressure for the entire lateral length especially in the laboratory. The Darcy-Weisbach friction factor, as opposed to the Blasius friction factor, is recommended for design because it accounts for the wall roughness of the pipe. The Hazen-Williams roughness coefficient was related to Reynolds number to improve the drip system design. Total friction losses, as a result of water viscosity changes and lateral discharge variations due to temperature, increased significantly for the T-tape emitter lateral in the laboratory and field for different inlet water temperatures and inlet-outlet temperature variations. In contrast, total friction losses decreased for the Agrifim emitter lateral primarily because of water viscosity changes with temperature. The sediment concentration along an Agrifim emitter lateral in the laboratory decreased sharply in the second half of the line when the flow velocity dropped below 0.29 ms⁻¹ . Also friction losses increased for an Agrifim emitter lateral in the laboratory as the inlet concentration increased from 200 to 650 mg/l.

This thesis describes a multi-channel millimeter wave radiometer control system that will be used for atmospheric water vapor and temperature profile retrievals. The system consists of four subsystems which provide a total of nine frequency channels, a steerable reflector to permit slant-path measurements at different zenith angles, and a host computer for analyzing the data. The nine channels span the water vapor and oxygen absorption lines in the 20 to 60 GHz range. A distributed processing architecture is implemented to control the system. Each of the subsystems employs a signal processor and a microcontroller, which are configurable from the host. The signal processor filters the receiver's output, while the microcontroller oversees the radiometer, accepts data from the signal processor and communicates with the host. The host executes a custom shell that allows it to concurrently accept data from the subsystems, position the reflector and execute user analysis programs.

No description available.