With smaller electronic devices and higher transmission speeds, a digital circuit will cause potential electromagnetic interference (EMI) and signal integrity (SI) problems. Nowadays, the flexible printed circuit board (FPC) is widely used in electronic systems, especially in the video circuit. In this thesis, we used transmission line model to explain effect of the structure of the flexible printed circuit board transmission lines. Eye-diagram is a fast and convenient tool to analyze the quality of the high speed transmission, and we can use the equivalent model to substitute for the electromagnetic (EM) model to simulate the performance. We used differential circuit and the reflection gain to increase the height and width parameters of Eye-diagram, and make the quality of signal transmission higher. For video driver circuit, since the terminal resistance is different depending on whether the IC is on or off, the standard probe cannot measure mixed-mode S-parameter directly due to the connectors. Thus, we provided a de-embedding method to remove the effects of high speed interconnect line on the test board. Finally, we use a simple structure to verify the method, and it can be used to measure mixed-mode S-parameter on the standard of Mobile Industry Processor Interface (MIPI) for D-PHY, v0.90.00.

Energy efficiency is a vital key component when designing and miniaturizing self sustained microsystems. The smaller the system, the smaller is the possibility to store enough stored energy for a long and continuous operational time. To move such a system in an energy efficient way, a piezoelectrical locomotion module consisting of four resonating cantilevers has been designed, manufactured and evaluated in this work. The combination of a suitable substrate, a multilayered piezoelectric material to reduce the voltage, and a resonating drive mechanism resulted in a low power demand. A manufacturing process for multilayer cantilever actuators made of P(VDF-TrFE) with aluminum electrodes on a substrate of flexible printed circuit board (FPC), has been developed. An important step in this process was the development of an etch recipe for dry etching the multilayer actuators in an inductive plasma equipment. Formulas for the quasi static tip deflection and resonance frequency of a multilayered cantilever, have been derived. Through theses, it was found that the multilayered structures should be deposited on the polymer side of the FPC in order to maximize the tip deflection. Both a large and a miniaturized locomotion module were manufactured and connected by wires to verify that the three legged motion principal worked to move the structures forward and backward, and turn it right and left. By touching and adding load, to a fourth miniaturized cantilever, its ability to act as a contact sensor and carry object was verified. The presented locomotion module is part of a multifunctional microsystem, intended to be energy efficient and powered by a solar panel with a total volume of less than 25 mm3 and weight 65 mg. The whole system, consisting of a solar cell, an infra red communication module, an integrated circuit for control, three capacitors for power regulating, the locomotion module and an FPC connecting the different modules, was surface mounted using a state of the art industrial facility. Two fully assembled systems could be programmed both through a test connector and through optical sensors in the multifunctional solar cell. One of these was folded together to the final configuration of a robot. However, the entire system could not be tested under full autonomous operating conditions. On the other hand, using wires, the locomotion module could be operated and used to move the entire system from a peak-to-peak voltage of 3.0 V.