Charles University in Prague, Faculty of Pharmacy in Hradec Králové Department of: Pharmaceutical Technology Consultants: PharmDr. Ondřej Holas, Ph.D. Student: Simona Žemličková Title of thesis: Hybrid polymeric-lipid nanoparticles as drug carriers The work is focused on hybrid polymer-lipid nanoparticles, their advantages obtained from polymer and lipid part, purpose of surface modification, basic properties of nanoparticles, methods of preparation, modification of preparation conditions and use of nanoparticles in medicine. The aim of the experimental part was to prepare nanoparticles composed of polyester and lipid by emulsion evaporation method and nanoprecipitation. Two types of linear polymer poly (lactic-co-glycolic acid) and phosphatidylcholine were used in various ratios. The surfactant used for stabilization was poloxamer Pluronic® F127 and the organic solvents were ethyl acetate and acetone. Curcumin served as a model active substance. The effect of lipid and surfactant on the size and zeta potential of nanoparticles was evaluated. Modification of preparation conditions, which included many process parameters, also influenced the monitored parameters. Encapsulation effectivity and drug loading were also tested. Dissolution tests were performed. It was found that size of nanoparticles...

This thesis is focused on investigation of phospholipid-hyaluronan system. First, appropriate method for preparation of bulk solution of phospholipid/lipid and suitable fluorescence probe were chosen. Sonification was selected as a method for preparation of bulk solution and pyrene was chosen as a fluorescence probe. From the group of phospholipids lecithin was selected. Next to phospholipid, lipid with no phosphate group (DPTAP) was utilized for comparison, alternatively a mixture of lipid (DPTAP) and phospholipid (DPPC). Instead of hyaluronan another polyelectrolytes (sodium polystyrene sulfonate, sodium alginate) were used too. Measurements were performed in water environment and in phosphate buffer saline (PBS). All investigation was accomplished by fluorescence spectroscopy and dynamic light scattering.

This work deals with preparation of microbubble suspension from a mixture of phospholipids, palmitic acid and polyethylene glycol. Properties of prepared systems were studied using bubble tensiometry and dynamic light scattering method and were compared with commercial contrast agent SonoVue®. Suspensions were prepared in various conditions including different atmosphere and increased temperature in some steps of preparation and different solution. Effect of polyethylene glycol addition on surface activity of the system was studied. Surface activity of phospholipids was insignificant. Surface tension decreased with increasing concentration and molecular weight of polyethylene glycol in the system. Effect of different atmosphere and increased temperature showed no substantial trend. It emerged that dynamic light scattering is not suitable for this type of samples because of high polydispersity and phase separation of the system.

The main objective of this thesis work was to gain understanding of the principles of biolubrication, focusing on synergistic effects between biolubricants. To this end surface force and friction measurements were carried out by means of Atomic Force Microscopy, using hydrophilic and hydrophobic model surfaces in salt solutions of high ionic strength (≈ 150 mM) in presence of different biolubricants. There was also a need to gain information on the adsorbed layers formed by the biolubricants. This was achieved by using a range of methods such as Atomic Force Microscopy PeakForce imaging, Quartz Crystal Microbalance with Dissipation, Dynamic Light Scattering and X-Ray Reflectometry. By combining data from these techniques, detailed information about the adsorbed layers could be obtained.The biolubricants that were chosen for investigation were a phospholipid, hyaluronan, lubricin, and cartilage oligomeric matrix protein (COMP) that all exist in the synovial joint area. First the lubrication ability of these components alone was investigated, and then focus was turned to two pairs that are known or assumed to associate in the synovial area. Of the biolubricants that were investigated, it was only the phospholipid 1,2-dipalmitoyl-sn-glycero-3-phosphocholine (DPPC) that was found to be an efficient lubricant on its own. Deposited DPPC bilayers on silica surfaces were found to be able to provide very low friction coefficients (≈ 0.01) up to high pressures, ≈ 50 MPa. A higher load bearing capacity was found for DPPC in the liquid crystalline state compared to in the gel state.The first synergy pair that was explored was DPPC and hyaluronan, that is known to associate on the cartilage surface, and we also noticed association between hyaluronan and DPPC vesicles as well as with adsorbed DPPC bilayers. By combining these two components a lubrication performance similar to that of DPPC alone could be achieved, even though the friction coefficient in presence of hyaluronan was found to be slightly higher. The synergy here is thus not in form of an increased performance, but rather that the presence of hyaluronan allows a large amount of the phospholipid lubricant to accumulate where it is needed, i.e. on the sliding surfaces.The other synergy pair was lubricin and COMP that recently has been shown to be co-localized on the cartilage surface, and thus suggested to associate with each other. Lubricin, as a single component, provided poor lubrication of PMMA surfaces, which we utilized as model hydrophobic surfaces. However, if COMP first was allowed to coat the surface, and then lubricin was added a low friction coefficient (≈ 0.03) was found. In this case the synergy arises from COMP facilitating strong anchoring of lubricin to the surface in conformations that provide good lubrication performance. / Huvudsyftet med det här avhandlingsarbetet var att öka förståelsen för den låga friktion som finns i vissa biologiska system, med fokus på synergistiska effekter mellan de smörjande molekylerna. För detta ändamål studerades ytkrafter och friktion med hjälp av atomkraftsmikroskopi. Mätningarna utfördes med hydrofila och hydrofoba modellytor i lösningar med hög salthalt (≈ 150 mM) i närvaro av smörjande biomolekyler. Det var också nödvändigt att få information om de adsorberade skikten av biomolekyler. Det åstadkoms med hjälp av en rad tekniker så som AFM PeakForce avbildning, kvartskristallmikrovåg, dynamisk ljusspridning och röntgen reflektometri. Genom att kombinera data från dessa tekniker erhölls detaljerad information om de smörjande skikten.De smörjande biomolekyler som valdes ut för studierna var en fosfolipid, hyaluronan, lubricin, and cartilage oligomeric matrix protein (COMP) vilka alla finns i synovialledsområdet. Först undersöktes den smörjande förmågan hos dessa komponenter var för sig, och sedan fokuserade vi på två par av biomolekyler som man vet eller antar bildar associationsstrukturer i synovialleder. Av de enskilda biomolekyler som undersöktes var det endast fosfolipiden 1,2-dipalmitoyl-sn-glycero-3-fosfokoline (DPPC) som visade sig vara en effektivt smörjande molekyl. Deponerade biskikt av DPPC på silikaytor gav upphov till mycket låga friktionskoefficienter (≈ 0.01) upp till höga pålagda tryck, ≈ 50 MPa. DPPC bilager i flytande kristallin fas visade sig ha högre lastbärande förmåga än DPPC bilager i geltillstånd.Det första synergistiska par som undersöktes var DPPC och hyaluronan vilka man vet associerar på broskytan, och vi visade att hyaluronan associerar med såväl DPPC vesiklar som med DPPC bilager. Genom att kombinera dessa två komponenter uppmättes en smörjande förmåga som var jämförbar med den som DPPC ensam uppvisar. Även om friktionskoefficienten var något högre i närvaro av hyaluronan. Synergieffekten här består inte av en bättre smörjande förmåga, utan istället gör närvaron av hyaluronan att de smörjande fosfolipiderna kan ansamlas i stora mängder där de behövs, dvs. på de glidande ytorna.Det andra synergiparet var lubricin och COMP vilka nyligen har visats vara lokaliserade på samma platser på broskytan, vilket tyder på att de associerar med varandra. På egen hand var lubricins smörjande förmåga av PMMA, våra hydrofoba modellytor, dålig. Emellertid, om COMP först adsorberades på PMMA och sedan lubricin tillsattes uppmättes en låg friktionskoefficient (≈ 0.03). I det här fallet består synergin av att COMP möjliggör en stark inbindning till ytan av lubricin i konformationer som ger god smörjande förmåga. / <p>QC 20141202</p> / Stiftelsen för strategisk forskning - SSF