1 |
LRFD evaluation of full-scale metal building rigid frame testsDavis, Douglas Bradley 22 August 2008 (has links)
Metal building companies commonly use rigid frames to meet the requirement of large, open spaces which are unobstructed by interior columns. These rigid frames are optimally designed and constructed using tapered columns and rafters, connected at the knees and ridge by moment end-plate connections.
The purpose of this research was to investigate the accuracy of standard analysis methods when applied to metal building rigid frames. To achieve this goal, the results of two full-scale metal building rigid frame tests were compared to predicted values obtained from typical analysis procedures. Upon completion of the tests, measured dimensions and material properties were used to perform linearly elastic frame analyses and 1993 AISC LRFD Specification strength checks. It was concluded that standard analysis procedures are very accurate when applied to rigid frames such as the ones in this study.
The provisions concerning lateral-torsional buckling of singly-tapered segments were found to inappropriately contain AISC ASD factors of safety. New provisions were developed and recommended to correct this problem. The suggested provisions were found to be slightly more conservative than the existing provisions for the frames in this study. / Master of Science
|
2 |
Dviračių rėmų bandymų statinėmis ir dinaminėmis apkrovomis stendas / Stand for bicycle frame tests using statics and dynamics loadsVilkas, Voldemaras 16 June 2004 (has links)
The theme of Master project of Energetics engineering is actual because in nowadays it is important not only design and functionality of bicycle, but also safety and technological tests of bycicle frame, fork and other part corresponding to international standarts. In Master project was created system for dynamic changing force applying on dynamic pedal and wheel strenght tests. Results of practical pedal pushing research and computations of modelated pedaling system were similar. Analysis of pneumatic cylinder and proportional pressure regulator (using Centaurus Plus modeling program) showed that it is necessary to reduce cylinder working cell volume to enable system to repeat 3 Hz set signals. Using algorithms models was created program for data input, processing and visualizing of testing stand. This program was kindly evaluated by specialists of Technological Test center of Faculty of Technology.
|
Page generated in 0.0501 seconds