No description available.

Lignin can be converted into monomeric products with the aid of molten salt media. Molten zinc chloride (ZnCl₂)/potassium chloride (KCl) mixtures are suitable for this purpose. The application of an eutectic mixture with low melting points leads to similar main products as are obtained by pyrolysis. The hydrogenolysis of an organosolv lignin in molten salts of ZnCl₂/KCl was investigated as a function of reaction temperature, residence time, and lignin concentration, and the composition of liquid products and monophenols was analyzed by gas chromatography-mass spectrometry (GC-MS). The yields can be optimized by the proper selection of the reaction temperature. A longer residence time and higher lignin concentrations lead to increased formation of solid residues and gaseous products. The liquid products mainly consist of substituted phenols derived from lignins. Polymeric products are the result of condensation reactions (i.e., the formation of new C-C linkages in the course of secondary reactions).

The effect of annealing on the tribological and corrosion properties of Al–12Si samples produced by selective laser melting (SLM) is evaluated via sliding and fretting wear tests and weight loss experiments and compared to the corresponding material processed by conventional casting. Sliding wear shows that the as-prepared SLM material has the least wear rate compared to the cast and heat-treated SLM samples with abrasive wear as the major wear mechanism along with oxidation. Similar trend has also been observed for the fretting wear experiments, where the as-prepared SLM sample displays the minimum wear loss. On the other hand, the acidic corrosion behavior of the as-prepared SLM material as well as of the cast samples is similar and the corrosion rate is accelerated by increasing the heat treatment temperature. This behavior is due to the microstructural changes induced by the heat treatment, where the continuous network of Si characterizing the as-prepared SLM sample transforms to isolated Si particles in the heat-treated SLM specimens. This shows that both the wear and corrosion behaviors are strongly associated with the change in microstructure of the SLM samples due to the heat-treatment process, where the size of the hard Si particles increases, and their density decreases with increasing annealing temperature.

Der Autor Rainer Gilles beschäftigt sich seit fast 30 Jahren intensiv mit der bekannten Firma aus der Elbmetropole. Es fiel ihm nicht leicht, der Firmengeschichte oder gar ihrem Begründer Bruno Naumann auf knappem Raum gerecht zu werden. Aus einer unglaublichen Fülle von Abbildungen, Plakaten und Objekten stellte die Redaktion ein paar Bildseiten zusammen, um den Leserinnen und Lesern einen Überblick über das Wirken dieser renommierten Fahrrad- und Nähmaschinenfabrik zu geben.

No description available.

No description available.

No description available.

No description available.

No description available.

No description available.