This thesis proposes a high efficiency driving circuit for multiple light emitting diode (LED) lamps with dimming feature. The driving circuit consists of essentially a high-frequency half-bridge series resonant inverter with multiple output transformers, on which primary windings are connected in series, while secondary sides are loaded by LED lamps rated at different powers with different turn ratios. By controlling the frequency of the inverter, the resonant current as well as the lamp current can be regulated simultaneously. On the other hand, the LED lamps can be dimmed individually by the associated dimming switches with integral cycle control. The tactful circuit ensures a high circuit efficiency owing to less conducting losses and zero-voltage switching (ZVS) operation of the active power switches of the inverter and zero current switching (ZCS) operation of the dimming switches. Two prototype circuits designed for 60 W three RGB LED lamps and 50 W five white light LED lamps have been built and tested to verify the analytical predictions. Experimental results demonstrate that the driving circuit can operate the LED lamps at a high efficiency with a wide dimming range. The lamp power can be dimmed to 10% with frequency control, while whole dimming range can be achieved with integral cycle control. The circuit efficiency with integral cycle control is relatively higher than that with frequency control. The measured efficiencies for the two designed circuit are 93% and 90%, respectively, under the rated powers.

A high-frequency half-bridge series resonant inverter with multiple output transformers is developed for driving multiple cold-cathode fluorescent lamps (CCFLs) with dimming feature. The primary sides of the transformers are connected in series with the resonant inverter to have an identical current, while the secondary sides are loaded by CCFLs with galvanic isolation to each other. To ensure a high circuit efficiency, the active power switches of the inverter are designed to be switched on at zero voltage. The resonant current of the inverter can be regulated by controlling the switching frequency of the inverter, so that all CCFLs can be dimmed simultaneously. On the other hand, the primary sides of the output transformers are associated with parallel switches to dim the CCFLs individually. These dimming switches are operated at a low frequency by integral cycle control with zero current switching (ZCS) to reduce the switching losses. The resonant circuit is tactfully designed to alleviate the variation of the resonant current caused by the switching of dimming switches. A laboratory circuit is built for driving 5 CCFLs. The intended circuit performances are confirmed by test results. The variation of the resonant current is less than 10% when the dimming switches are switching, and the measured efficiency for the circuit is 96.15% under the rated powers.