Spelling suggestions: "subject:"kaplan"" "subject:"kaplansky""
1 |
Utredning av frekvensregleringens påverkan på mekanisk utrustning i en kaplanturbin / Investigation of the impact of frequency controlled operation on the controlling mechanism in a Kaplan turbineForsström, William January 2015 (has links)
As a consequence of increasing wind power installations in the Nordic grid the last years, the need for regulating power has become larger. In the Nordic grid, regulating power is mainly provided by hydro power. One part of the regulating power is called frequency control, which ensures that the grid frequency is stable and close to 50 Hz. However, setting the turbine into frequency controlled operation may cause stress and wear of the components in the mechanical control system. Frequency controlling implies large and frequent servo forces and longer travelling distance of the sliding bearings in the Kaplan turbine. Based on one selected Kaplan turbine, Selsfors G1, measurements and MATLAB calculations have been performed in order to determine forces and movements of the linkage system. With these forces and movements as input, stresses and fatigue have been determined as well as sliding distances, bearing pressures and wear of bearings during a typical lifetime of 40 years. The results indicate that no severe wear exists on the bearings during 40 years of service. This is valid for Selsfors G1, where self-lubricating greaseless Orkot bearings are installed. The wear is much smaller than the largest allowed bearing clearance, as long as the bearings are mounted correctly and free from dirt and oil. For turbines with grease or oil lubricated bearings, the result might differ. The highest average stresses have been recorded in the links in the runner. A very simple Finite Element Analysis has been made for the links, to estimate risk of fatigue. The stresses are much lower compared to the fatigue limit, and thus the risk of fatigue is considered very small. In situations where wear and large load changes after all are problems, a change in the turbine regulator settings is recommended. A dead band reduces the sliding distances of the bearings and the amount of load changes remarkably, but causes on the other hand lower turbine efficiency and worse quality of the frequency control.
|
2 |
Vattennivåreglering i Avesta Lillfors : På uppdrag av Fortum Generation AB / Water Level Control in Avesta Lillfors : On behalf of Fortum Generation ABKarnik Macaya, Yohanna January 2014 (has links)
I denna rapport utreds olika metoder för att kunna reglera vattennivån i vattenkraftverket Avesta Lillfors i Dalarna. Två kraftverk ligger endast 900 m uppströms och detta gör att svarstiderna blir korta och regleringen blir lätt nervös. Att använda sig av vattennivåreglering i ett kraftverk för-enklar dess styrning då anpassning till inflödet sker automatiskt. En flödestabell har tagits fram genom mätningar i turbinen, med hjälp av Winter-Kennedy-metoden. Denna tabell används för att kunna fram-koppla regulatorn och därmed dämpa stora variationer i inflödet. Dessu-tom har en modell av älven skapats och testats med en återkopplad PID-regulator. Utefter dessa tester har lämpliga parametrar tagits fram, som ger önskad stabilitet, noggrannhet och snabbhet. Simuleringar har även gjorts med reglermetoden Fuzzy logic. / This report evaluates different methods to create a stable regulation of the water level in the hydro power plant Avesta Lillfors, in county Dalar-na. Another pair of plants are located just 900 m up the stream, which is why the regulation has to act fast. If the water level can be regulated and automatically adjust to the incoming flow, it facilitates the control of the plant. A flow chart is created from measurements in the turbine, using the Win-ter-Kennedy method. The results are used for feedforward control. A PID-regulator with feedback is also simulated in a model of the river. This helps finding the parameters that provide a stable, accurate and fast regu-lation. Fuzzy logic control has also been simulated.
|
3 |
Anpassning av småskaliga vattenkraftverk för ö-drift av lokalt elnät / Adapting small hydropower plants for frequency control of power grids in island modeFredriksson, Jonatan January 2019 (has links)
This master thesis examines technical requirements for small hydro power plants (HPP) to operate proximate parts of the power grid in island mode. The work examines how small hydropower can be modified and complemented with additional technologies to achieve sufficient frequency control capabilities. A case study was performed within the concession area of power grid operator Ålem Energy. One of the HPPs, located in Skälleryd, is owned by Ålem Energy and became the focal point of the study. Relevant parts of the concession area were surveyed for properties such as system inertia, electric load and available power. Furthermore, a model of Kaplan turbine 1 in Skälleryd HPP was created with the purpose of studying the benefits of bypassing regulation control from the wicket gates directly to the runner. The method was tested in an off-grid islanding test. Frequency control of the turbine was tested powering electric heaters and, using a new method, controlling a virtual power grid. Finally, a theory was developed to estimate the transient disturbance resilience (TDR) of a power grid. The theory was applied to the HPP in Skälleryd to suggest modifications for the plant to achieve sufficient islanding capabilities. The survey of the power system revealed a promising potential for the HPPs to operate in island mode, especially at later stages when the grid spans several HPPs for more system inertia. The available power from the HPPs was however strongly seasonal which imposes flexibility on a future plan of action for engaging the grid in island mode. The method of controlling the turbine power from the runner proved to have several difficulties. Firstly, the current hydraulics system was not able to freely control the runner as the hydrodynamic forces on the runner blades were too large. Secondly, the method was found to be unstable due to inherent amplification of speed deviations. Furthermore, the low inertia at Skälleryd is likely detrimental to the lone frequency control of the turbine. Therefore other methods for improving frequency control were suggested. The developed theory for TDR was used to create charts describing the TDR for various combinations of system inertia and regulation speed. By studying the proprieties of Skälleryd HPP in the charts the necessary modifications could be rationally chosen. A frequency regulating dummy load was found to be the simplest option. A control scheme was suggested with the dummy load performing primary frequency control and the turbines at Skälleryd performing secondary control, restoring the dummy load to its nominal state.
|
Page generated in 0.2577 seconds