<p>Confocal microscopy has been used as a tool for studying adsorption of biomolecules to individual chromatographic adsorbent particles. By coupling a fluorescent dye to protein molecules, their penetration into single adsorbent particles could be observed visually at different times during batch uptake. By relating the relative fluorescence intensity obtained at different times to the value at equilibrium, the degree of saturation versus time could be constructed. The use of two different fluorescent dyes for protein labeling and two independent detectors, allowed direct observation of a two-component adsorption process. The confocal technique was also applied for visualization of nucleic acids. Plasmid DNA and RNA were visualized with fluorescent probes that binds to double stranded DNA and RNA respectively. Confocal measurements following single component adsorption to ion exchange particles, revealed an interesting phenomenon. Under certain experimental conditions, development of "inner radial concentration rings" (i.e. adsorbed phase concentrations that are higher at certain radial positions within the particle) were observed. Some examples are given that show how such concentration rings are formed within a particle.</p><p>Methods were also developed for measurement of the spatial distribution of immobilized functional groups. Confocal microscopy was used to investigate the immobilization of trypsin on porous glycidyl methacrylate beads. Artefacts relating to optical length differences could be reduced by use of "contrast matching". Confocal microscopy and confocal micro-Raman spectroscopy, were used to analyze the spatial distribution of IgG antibodies immobilized on BrCN-activated agarose beads. Both these measurement methods indicate an even ligand distribution. Finally, confocal Raman and fluorescence spectroscopy was applied for measurement of the spatial distribution of iminodiacetic- and sulphopropyl groups, using Nd3+ ions as fluorescent probes. Comparison of different microscope objectives showed that an immersion objective should be used for measurement of wet adsorbent particles.</p><p><i>Direct experimental information from the interior of individual adsorbent particles will increase the scientific understanding of intraparticle mass transport and adsorption mechanisms, and is an essential step towards the ultimate understanding of the behaviour of chromatographic adsorbents.</i></p>

Confocal microscopy has been used as a tool for studying adsorption of biomolecules to individual chromatographic adsorbent particles. By coupling a fluorescent dye to protein molecules, their penetration into single adsorbent particles could be observed visually at different times during batch uptake. By relating the relative fluorescence intensity obtained at different times to the value at equilibrium, the degree of saturation versus time could be constructed. The use of two different fluorescent dyes for protein labeling and two independent detectors, allowed direct observation of a two-component adsorption process. The confocal technique was also applied for visualization of nucleic acids. Plasmid DNA and RNA were visualized with fluorescent probes that binds to double stranded DNA and RNA respectively. Confocal measurements following single component adsorption to ion exchange particles, revealed an interesting phenomenon. Under certain experimental conditions, development of "inner radial concentration rings" (i.e. adsorbed phase concentrations that are higher at certain radial positions within the particle) were observed. Some examples are given that show how such concentration rings are formed within a particle. Methods were also developed for measurement of the spatial distribution of immobilized functional groups. Confocal microscopy was used to investigate the immobilization of trypsin on porous glycidyl methacrylate beads. Artefacts relating to optical length differences could be reduced by use of "contrast matching". Confocal microscopy and confocal micro-Raman spectroscopy, were used to analyze the spatial distribution of IgG antibodies immobilized on BrCN-activated agarose beads. Both these measurement methods indicate an even ligand distribution. Finally, confocal Raman and fluorescence spectroscopy was applied for measurement of the spatial distribution of iminodiacetic- and sulphopropyl groups, using Nd3+ ions as fluorescent probes. Comparison of different microscope objectives showed that an immersion objective should be used for measurement of wet adsorbent particles. Direct experimental information from the interior of individual adsorbent particles will increase the scientific understanding of intraparticle mass transport and adsorption mechanisms, and is an essential step towards the ultimate understanding of the behaviour of chromatographic adsorbents.

<p>Chromatography is a powerful technique, essential in chemical analyses and preparative separation in industry and research. Many different kinds of chromatographic material are needed, due to the large variety of applications. Detailed methods of characterisation are needed to design new chromatographic materials and understand their properties. In this thesis, confocal Raman spectroscopy and surface enhanced Raman spectroscopy (SERS) have been applied to micrometer-size chromatographic beads, for which these techniques have not been used earlier. New methodology, optimized for use with the chromatographic beads, has been developed and evaluated. </p><p>Confocal spectroscopy has been used to determine distributions of functional groups within single chromatographic beads. This distribution is of great importance in determining the chromatographic properties, since the material is porous and the solute molecules can diffuse inside the beads. Most of the confocal experiments have been performed with Raman spectroscopy; fluorescence spectroscopy, using Nd³⁺ ions or dye-labelled proteins as fluorescence probes, has been used for comparison. </p><p>The concentration of adsorbed analytes is very low within the beads. SERS was therefore used to enhance the Raman signal. SERS-active surfaces were prepared by incorporating gold nano-particles into the interior of the bead. TEM measurements showed that the gold nano-particles could be observed throughout, and it was possible to record analyte spectra from different positions within the bead. Enhanced spectra could be obtained both for small test molecules and for larger bio-molecules, although the spectra for the smaller analytes were much more intense.</p>

Chromatography is a powerful technique, essential in chemical analyses and preparative separation in industry and research. Many different kinds of chromatographic material are needed, due to the large variety of applications. Detailed methods of characterisation are needed to design new chromatographic materials and understand their properties. In this thesis, confocal Raman spectroscopy and surface enhanced Raman spectroscopy (SERS) have been applied to micrometer-size chromatographic beads, for which these techniques have not been used earlier. New methodology, optimized for use with the chromatographic beads, has been developed and evaluated. Confocal spectroscopy has been used to determine distributions of functional groups within single chromatographic beads. This distribution is of great importance in determining the chromatographic properties, since the material is porous and the solute molecules can diffuse inside the beads. Most of the confocal experiments have been performed with Raman spectroscopy; fluorescence spectroscopy, using Nd3+ ions or dye-labelled proteins as fluorescence probes, has been used for comparison. The concentration of adsorbed analytes is very low within the beads. SERS was therefore used to enhance the Raman signal. SERS-active surfaces were prepared by incorporating gold nano-particles into the interior of the bead. TEM measurements showed that the gold nano-particles could be observed throughout, and it was possible to record analyte spectra from different positions within the bead. Enhanced spectra could be obtained both for small test molecules and for larger bio-molecules, although the spectra for the smaller analytes were much more intense.