Underground injection of acid gas has been studied for several decades for oil field applications, such as enhanced oil recovery (EOR), but is now being studied as a solution to climate change. This research aims to simulate underground conditions at injection sites, such as the pilot scale injection site located near the site of a coal fired power facility in the Black Warrior Basin of Alabama. This proposed carbon capture and sequestration (CCS) location would involve injection of liquid CO2 into a carbonaceous saline aquifer. The objective of this study was to investigate carbonate surface treatments that alter the kinetics and mechanism of mineral dissolution resulting from the injection of an acid gas (CO2) into a geologic formation. A variety of mineral coatings were tested in an attempt to preserve mineral integrity under acidic conditions. Surface active chemicals were first tested, including scale inhibitors, followed by a novel acid induced surface treatment that precipitates an inorganic layer on the calcite to preserve the acid soluble mineral. These experiments are the first to investigate the use of scale inhibitors for mineral preservation, although were found ultimately to have little impact on dissolution kinetics. However, anions of moderate to strong acids induced surface coatings that were determined to effectively inhibit dissolution. Additionally, a novel, high pressure flow-through experimental apparatus was developed to simulate pressure and temperature conditions relevant to injection sites. Similar mineralogical studies in the literature have used pressurized, unstirred, batch systems to simulate mineral interactions. Solids with an acid induced surface coating were tested in the high pressure column and no calcium was found to leave the column.

Underground injection of acid gas has been studied for several decades for oil field applications, such as enhanced oil recovery (EOR), but is now being studied as a solution to climate change. This research aims to simulate underground conditions at injection sites, such as the pilot scale injection site located near the site of a coal fired power facility in the Black Warrior Basin of Alabama. This proposed carbon capture and sequestration (CCS) location would involve injection of liquid CO2 into a carbonaceous saline aquifer. The objective of this study was to investigate carbonate surface treatments that alter the kinetics and mechanism of mineral dissolution resulting from the injection of an acid gas (CO2) into a geologic formation. A variety of mineral coatings were tested in an attempt to preserve mineral integrity under acidic conditions. Surface active chemicals were first tested, including scale inhibitors, followed by a novel acid induced surface treatment that precipitates an inorganic layer on the calcite to preserve the acid soluble mineral. These experiments are the first to investigate the use of scale inhibitors for mineral preservation, although were found ultimately to have little impact on dissolution kinetics. However, anions of moderate to strong acids induced surface coatings that were determined to effectively inhibit dissolution. Additionally, a novel, high pressure flow-through experimental apparatus was developed to simulate pressure and temperature conditions relevant to injection sites. Similar mineralogical studies in the literature have used pressurized, unstirred, batch systems to simulate mineral interactions. Solids with an acid induced surface coating were tested in the high pressure column and no calcium was found to leave the column.

Carbon dioxide from biogas production is currently considered to be without value and isbecause of this released into the atmosphere in the biogas upgrading process. The residualgas is a potential carbon source and can create value in the biogas manufacturing process.By finding a suitable value-creating process that utilizes carbon dioxide, it can be possibleto provide both economic and environmental incentives for companies to develop theiroperations. This project explored the possibility to create value from this CO2. Through anevaluation of the technical maturity of CCU technologies, a recommendation could be givenat the end of the project. An analysis of technical barriers, such as pollutants in the gas, aswell as barriers in the form of competence and corporate culture were examined in orderto provide a reasoned recommendation. The project mapped which value-creating systemswould be suitable for biogas producers in a Swedish context. This included established methaneand carbon dioxide upgrading techniques currently in use and suitable CCU techniquesthat can interact with the selected upgrading processes and serve as value creators. Based onthis survey, it was then possible to identify common, critical variables for these systems. Thereafter,a recommendation of an appropriate CCU technology could be given depending onthe CO2 composition produced. One conclusion from the study was that carbon dioxide concentrationsfrom the residual gas was often high (approx. 97-98 %) and did not contain anycorrosive or toxic components, and that this largely depends on how the digestion reactor ishandled in the production process. Thus, questions were raised about what the actual limitationsof the CCU are, as they did not seem to be technical. CCU techniques that proved to beof particular interest were pH regulation of sewage plants, CO2 as a nutrient substrate for thecultivation of microalgae, and manufacturing of dry-ice for refrigerated transports. All of thesetechnologies currently have a sufficiently high degree of technical maturity to be installedalready today. Other CCU techniques, such as "’Power to gas”, require a high CO2 concentrationand were discarded as the literature review did not suggest the economic potential forthem as they require additional CO2 upgrading steps. Instead, CCU techniques were chosenthat could be implemented directly with the existing CO2 quality. Furthermore, it was concludedthat one reason why CCU technologies have not been widely implemented is internalbarriers between distributors and manufacturers (or users) of CCU technologies. Thus, theuse of carbon dioxide from biogas production and implementation of CCU technologies canbe promoted by eliminating barriers in companies, such as a lack of both knowledge andfinancial incentives. / Koldioxid från biogasproduktion betraktas i dagsläget som utan värde och släpps ut i atmosfärenvid uppgradering av biogas. Restgasen är en potentiell kolkälla och kan vara värdeskapandeför biogasprocessen. Genom att finna en lämplig värdeskapande process som utnyttjarkoldioxid går det att ge både ekonomiska och miljömässiga incitament till företag att utvecklasin verksamhet. I detta projekt undersöktes möjligheten att skapa värde av denna CO2.Genom en utvärdering av den tekniska mognadsgraden hos CCU-tekniker kunde en rekommendationges vid projektets slut. En analys av tekniska hinder, såsom föroreningar i gassammansättningen,såväl som hinder i form av kompetens och företagskultur undersöktes för attkunna ge en motiverad rekommendation. I projektet kartlades vilka värdeskapande systemsom skulle passa för biogasproducenter i en svensk kontext. Detta inkluderade etableradeuppgraderingstekniker för metan- och koldioxid som används i dagsläget. I projektet undersöktesäven lämpliga CCU-tekniker som kan samverka med de valda uppgraderingsprocessernaoch och agera värdeskapande. Utifrån denna kartläggning kunde det sedan anges vilkagemensamma, kritiska variabler som finns för dessa system. Därefter kunde en rekommendationav lämplig CCU-teknik ges beroende på den producerade CO2 sammansättningen. Enslutsats i projektet var att koldioxid från restgasen ofta var av hög koncentration (ca. 97-98 %)och ej innehöll några korrosiva eller toxiska komponenter, och att detta till stor del beror påhur rötkammaren är hanterad i produktionsprocessen. Således väcktes frågor kring vilka defaktiska begränsningarna för CCU är, då de inte torde vara tekniska. CCU-tekniker som visadesig vara av särskilt intresse var pH-reglering av avloppsverk, CO2 som näringssubstratför odling av mikroalger, samt tillverkning av kolsyreis för kyltransporter. Samtliga dessatekniker har tillräckligt hög teknisk mognadsgrad för att kunna installeras i dagsläget. AndraCCU-tekniker, såsom ”Power to gas”, kräver en hög CO2-koncentration och avfärdades dålitteraturstudien inte talade för den ekonomiska potentialen i dessa eftersom de kräver ytterligareuppgraderingssteg för CO2. Således valdes istället CCU-tekniker som skulle gå attimplementera direkt med den befintliga CO2 kvalitén. Vidare drogs slutsatsen att en anledningtill att CCU-tekniker inte har blivit vida implementerade till stor del är interna hindermellan distributörer och tillverkare (eller utnyttjare) av CCU-tekniker. Således kan användandetav koldioxid från biogasproduktion och implementering av CCU-tekniker främjasgenom att eliminera hinder hos företag. I projektet yttrade sig detta som bristande ekonomiskaincitament och okunskap. Ett ökat användande av CCU-tekniker kan också uppnås genomatt införa lagar och regler som begränsar användandet av föråldrade tekniker som drivs avfossila bränslen, och som kan ersättas av klimatvänliga CCU-tekniker.