1 |
Estimation of Inertial Parameters of Rigid Body Links of ManipulatorsAn, Chae H., Atkeson, Christopher G., Hollerbach, John M. 01 February 1986 (has links)
A method of estimating the mass, the location of center of mass, and the moments of inertia of each rigid body link of a robot during general manipulator movement is presented. The algorithm is derived from the Newton-Euler equations, and uses measurements of the joint torques as well as the measurement and calculation of the kinematics of the manipulator while it is moving. The identification equations are linear in the desired unknown parameters, and a modified least squares algorithm is used to obtain estimates of these parameters. Some of the parameters, however, are not identifiable due to restricted motion of proximal links and the lack of full force/torque sensing. The algorithm was implemented on the MIT Serial Link Direct Drive Arm. A good match was obtained between joint torques predicted from the estimated parameters and the joint torques computed from motor currents.
|
2 |
Development of the Carpal Wrist; a Symmetric, Parallel-Architecture Robotic WristCanfield, Stephen L. 21 May 1997 (has links)
This dissertation summarizes the research effort to develop a novel, three degree-of-freedom device that is ideally suited as a robotic wrist or platform manipulator. Because of its similarity to the human wrist, this invention has been named the "Carpal Wrist." Much like its natural counterpart, the Carpal Wrist has eight primary links, corresponding to the eight carpal bones of the human wrist, a parallel actuation scheme, similar to the flexor and extensor carpi muscles along the forearm, and an open interior passage, which forms a protected tunnel for routing hoses and electrical cables, much like the well-known carpal tunnel. The Carpal Wrist also has the significant advantages of possessing closed-form forward and inverse kinematic solutions and a large, dexterous workspace that is free of interior singularities (either considered separately or as part of a manipulator arm). As a result of its symmetric parallel architecture, the Wrist can handle a large payload capacity and can easily be adapted to a variety of actuation schemes. While parallel-architecture manipulators have long been recognized for their high-rigidity and large payload-to-weight capacity, few have been developed for application, primarily because of complications in kinematic and dynamic modeling. The mathematical model of any manipulator must be developed in order to allow the necessary motion control of the device. The mathematical model provides a mapping from the input space (called joint space) to the output space (called tool space) of the manipulator. Given a desired task in terms of motion of the robot tool, the mathematical model determines the required motor input parameters. Advanced manipulator performance through automatic control becomes possible when the model includes inertial or dynamic effects of the manipulator and tool. The research leading to the development of the Carpal Wrist is significant because it presents a complete kinematic and dynamic model of a parallel-architecture manipulator, and thus will provide significant improvement over current serial robot technology. This research was funded in part by TRIAD Investors Corporation (University Partners), Baltimore MD. / Ph. D.
|
Page generated in 0.0575 seconds