Research on multiple antenna systems has been a hot topic in recent years due to the demands for higher transmission rate and more reliable link in rich scattering environment in wireless communications. Using multiple antennas at both the transmitter side and the receiver side increases the channel capacity without additional frequency spectrum and transmitted power. However, due to the limited space at the size-limited terminal devices, the most critical problem in designing multiple antennas is the severe mutual coupling among them. The aim of this thesis is to provide compact, decoupled and efficient multiple antenna designs for terminal devices. At the same time, we propose a simple and cost effective method in multiple antenna measurement. All these efforts contribute to the development of terminal devices for the fourth generation wireless communication. The background and theory of multiple antenna systems are introduced first, in which three operating schemes of multiple antenna systems are discussed. Critical factors influencing the performance of multiple antenna systems are also analyzed in details. To design efficient multiple antenna systems in compact terminals, several decoupling methods, including defected ground plane, current localization, orthogonal polarization and decoupling networks, are proposed. The working mechanism and design procedure of each method are introduced, and their effectiveness is compared. Those methods can be applied to most of the terminal antennas, reducing the mutual coupling by at least 6dB. In some special cases, especially for low frequency bands below 1GHz, the chassis of the device itself radiates like an antenna, which complicates the antenna decoupling. Thus, we extend the general decoupling methods to the cases when the chassis is excited. Based on the characteristic mode analysis, three different solutions are provided, i.e., optimizing antenna locations, localizing antenna currents and creating orthogonal modes. These methods are applied to mobile phones, providing a more reliable link and a higher transmission rate, which are evaluated by diversity gain and channel capacity, respectively. In order to measure the performance of multiple antenna systems, it is necessary to obtain the correlation coefficients. However, the traditional measurement technique, which requires the phase and polarization information of the radiation patterns, is very expensive and time consuming. In this thesis, a more practical and convenient method is proposed. Fairly good accuracy is achieved when it is applied to various kinds of antennas. To design a compact and efficient multiple antenna system, besides the reduction of mutual coupling, the performance of each single antenna is also important. The techniques for antenna reconfiguration are demonstrated. Frequency and pattern reconfigurable antennas are constructed, providing more flexibility to multiple antenna systems. / QC 20120604

In this thesis, a comparison of the body SAR value of five planar WLAN antennas including two coupled-fed shorted monopole antennas, a coupled-fed loop antenna, a monopole antenna, and a monopole slot antenna for tablet PC applications are presented. A required minimum distance between the antenna and the testing flat phantom to meet the 1-g body SAR requirement of 1.6 W/kg has been determined. Results show that the body SAR results of the coupled-fed loop antenna are lowest among the five tested antennas. Detailed results and discussion are presented in this thesis. Also, a comparison of the body SAR value of a planar antenna and an antenna with 3-D bent structure are presented.

In this dissertation, a series of multiband hybrid mobile phone antennas, incorporating the electric-current and equivalent magnetic-current excitation mechanisms are presented. The design concept of the hybrid antenna is that the multiband operation is achieved by incorporating the resonant modes generated by the two above-mentioned excitation mechanisms. In the first and the second antenna designs, they are obtained by stacking the antennas using the electric-current and equivalent magnetic-current excitations, and both can achieve multiband operations. For the last two antenna designs, the two different excitation mechanisms can be incorporated on a single metal plate or dielectric substrate. This kind of hybrid are promising for application in bar-type and folder-type mobile phones. Besides, in order to pass some required testing criterions and analyze the environmental effects, the hybrid penta-band mobile phone antenna applied in bar-type and folder-type mobile phones is analyzed. The main topics include the speaker¡¦s effects on the antenna¡¦s performances, the analysis of user¡¦s hand and head effects, and the analysis of the hearing aid compatibility.

No description available.

General Secretariat of Education and Scientific Research, Libya. / The only available copy is the print version kept in the J.B.Priestley Library for reference.