abstract: Animals have evolved a diversity of signaling traits, and in some species, they co-occur and are used simultaneously to communicate. Although much work has been done to understand why animals possess multiple signals, studies do not typically address the role of inter-signal interactions, which may vary intra- and inter-specifically and help drive the evolutionary diversity in signals. For my dissertation, I tested how angle-dependent structural coloration, courtship displays, and the display environment interact and co-evolved in hummingbird species from the “bee” tribe (Mellisugini). Most “bee” hummingbird species possess an angle-dependent structurally colored throat patch and stereotyped courtship (shuttle) display. For 6 U.S. “bee” hummingbird species, I filmed male shuttle displays and mapped out the orientation- and-position-specific movements during the displays. With such display paths, I was able to then recreate each shuttle display in the field by moving plucked feathers from each male in space and time, as if they were naturally displaying, in order to measure each male’s color appearance during their display (i.e. the interactions between male hummingbird plumage, shuttle displays, and environment) from full-spectrum photographs. I tested how these interactions varied intra- and inter-specifically, and which of these originating traits might explain that variation. I first found that the solar-positional environment played a significant role in explaining variation in male color appearance within two species (Selasphorus platycercus and Calypte costae), and that different combinations of color-behavior-environment interactions made some males (in both species) appear bright, colorful, and flashy (i.e. their color appearance changes throughout a display), while other males maintained a consistent (non-flashing) color display. Among species, I found that plumage flashiness positively co-varied with male display behaviors, while another measure of male color appearance (average brightness/colorfulness) co-varied with the feather reflectance characteristics themselves. Additionally, species that had more exaggerated plumage features had less exaggerated shuttle displays. Altogether, my dissertation work illustrates the complexity of multiple signal evolution and how color-behavior-environment interactions are vital to understanding the evolution of colorful and behavioral display traits in animals. / Dissertation/Thesis / Doctoral Dissertation Biology 2018

Heart rate can say a lot about a person's health. While most conventional methods for heart rate measurement require contact with the subject, these are not always applicable. In this thesis, a non-invasive method for pulse detection is implemented and analyzed. Different signals from the color of the forehead—including the green channel, the hue channel and different ICA and PCA components—are inspected, and their resulted heart rates are weighted together according to the significance of their FFT peaks. The system is tested on videos with different difficulties regarding the amount of movement and setting of the scene. The results show that the approach of weighting measurements from different signals together has great potential. The system in this thesis, however, does not perform very well on videos with a lot of movement because of motion noise. Though, with better, less noisy signals, good results can be expected. / En människas puls säger en hel del om dennes hälsa. För att mäta pulsenanvänds vanligtvis metoder som vidrör människan, vilket iblandär en nackdel. I det här examensarbetet tas en metod för pulsmätningpå avstånd fram, som endast använder klipp från en vanlig videokamera. Färgen i pannan mäts och utifrån den genereras flera signalersom analyseras, vilket resulterar i olika mätvärden för pulsen. Genomatt värdera dessa mätvärden med avseende på hur tydliga signalernaär, beräknas ett viktat medelvärde som ett slutgiltigt estimat på medelpulsen. Metoden testas på videoklipp med varierande svårighetsgrad,beroende på hur mycket rörelser som förekommer och på vilketavstånd från kameran försökspersonen står. Resultaten visar att metodenhar mycket god potential och att man kan man förvänta sig finaresultat med bättre, mindre brusiga signaler.

Dans les réseaux de capteurs urbains, les nœuds émettent des signaux en utilisant plusieurs protocoles de communication qui coexistent. Ces protocoles étant en évolution permanente, une approche orientée radio logicielle semble être la meilleure manière d’intégrer tous les protocoles sur la passerelle collectant les données. Tous les signaux sont donc numérisés en une fois. La grande plage dynamique des signaux reçus est alors le principal problème : ceux-ci peuvent être reçus avec une puissance très variable selon les conditions de propagation. Dans le cas d’une réception simultanée, le Convertisseur Analogique-Numérique (CAN) doit être capable d’absorber une telle dynamique. Une première étude est menée afin d’établir les caractéristiques requises du CAN sur une passerelle d’un tel réseau de capteurs. La résolution minimale de 21 bits obtenue s’avérant trop importante pour être atteinte au vu de l’état de l’art actuel, deux approches différentes sont explorées pour réduire la plage dynamique des signaux avant la numérisation. La première approche s’appuie sur la technique du companding. Des lois de compression connues sont explorées afin d’étudier leur viabilité dans le cas de la numérisation de signaux multiples, et deux nouvelles implémentations sont proposées pour la plus performante d’entre elles. La deuxième technique proposée consiste en une nouvelle architecture de réception utilisant deux voies de réception. La première d’entre elles est dédiée au signal le plus fort sur la bande : celui-ci est démodulé et sa fréquence d’émission est mesurée. À partir de cette mesure, la seconde branche est reconfigurée de manière à atténuer ce signal fort, en réduisant ainsi la plage dynamique. Les autres signaux sont ensuite numérisés sur cette branche avec une résolution du CAN réduite. Cette deuxième approche semblant plus prometteuse, elle est testée en expérimentation. Sa viabilité est démontrée avec des scénarios de réception de signaux prédéfinis représentant les pires cas possibles. / In this thesis, a receiver architecture for a gateway in a urban sensors network was designed. To embed the multiple protocols coexisting in this environment, the best approach seems to use a reconfigurable architecture, following the scheme of the Software-Defined Radio (SDR). All the received signals should be digitized at once by the Analog-to-Digital Converter (ADC) in order to sustain the reconfigurability of the architecture: then all the signal processing will be able to be digitally performed. The main complication comes from the heterogeneity of the propagation conditions: from the urban environment and from the diversity of the covered applications, the signals can be received on the gateway with widely varying powers. Then the gateway must be able to deal with the high dynamic range of these signals. This constraint applies strongly on the ADC whose resolution usually depends on the reachable digitized frequency band. A first study is led to evaluate the required ADC resolution to cope with the dynamic range. For this the dynamic range of the signals is first evaluated, then the required resolution to digitize the signals is found theoretically and with simulations. For a 100~dB power ratio between strong and weak signals, we showed that the ADC resolution needed 21 bits which is far too high to be reached with existing ADCs. Two different approaches are explored to reduce analogically the signals' dynamic range. The first one uses the companding technique, this technique being commonly used in analog dynamic range reduction in practice (\emph{e.g.} in audio signals acquisition), its relevance in multiple signal digitization is studied. Three existing compression laws are explored and two implementations are proposed for the most efficient of them. The feasibility of these implementations is also discussed. In the second approach we propose to use a two-antennas receiver architecture to decrease the dynamic range. In this architecture two digitization paths are employed: the first one digitizes only the strongest signal on the band. Using the information we get on this signal we reconfigure the second branch of the architecture in order to attenuate the strong signal. The dynamic range being reduced, the signals can be digitized with an ADC with a lower resolution. We show in this work that the ADC resolution can de decreased from 21 to 16 bits using this receiver architecture. Finally, the promising two-antennas architecture is tested in experimentation to demonstrate its efficiency with dynamic signals (\emph{i.e.} with appearing and disappearing signals).