Not available / text

As freshwater resources are limited and stressed, and as the cost of conventional drinking water treatment continues to increase, interest in the development of non-traditional water resources such as desalination and water reuse increases. Reverse osmosis (RO) is the predominant technology employed in inland brackish groundwater desalination in the United States, but the potential for membrane fouling and scaling generally limits the system recovery. The general hypothesis of this research is that electrodialysis (ED) technology can be employed to minimize the volume of concentrate waste from RO treatment of brackish water (BW) and thereby improve the environmental and economic feasibility of inland brackish water desalination. The objective of this research was to investigate the performance sensitivity and limitations of ED for treating BWRO concentrate waste through careful experimental and mathematical analysis of selected electrical, hydraulic, and chemical ED variables. Experimental evaluation was performed using a laboratory-scale batch-recycle ED system in which the effects of electrical, hydraulic, and chemical variations were observed. The ED stack voltage showed the greatest control over the rate of ionic separation, and the specific energy invested in the separation was approximately proportional to the applied voltage and equivalent concentration separated. An increase in the superficial velocity showed marginal improvements in the rate of separation by decreasing the thickness of the membrane diffusion boundary layers. A small decrease in the nominal recovery was observed because of water transport by osmosis and electroosmosis. Successive concentration of the concentrate by multiple ED stages demonstrated that the recovery of BWRO concentrate could significantly improve the overall recovery of inland BWRO systems. A mathematical model for the steady-state performance of an ED stack was developed to simulate the treatment of BWRO concentrates by accounting for variation of supersaturated multicomponent solution properties. A time-dependent model was developed that incorporated the steady-state ED model to simulate the batch-recycle experimentation. Comparison of the electrical losses revealed that the electrical resistance of the ion exchange membranes becomes more significant with increasing solution salinity. Also, a simple economic model demonstrated that ED could feasibly be employed, especially for zero-liquid discharge. / text

10 pp. / Arsenic levels are often above drinking water standards in Arizona groundwater, at levels that may affect health. Private well owners are responsible for testing and treating they own water. This publication gives an overview of arsenic well water and discusses home water treatment options, including detailed descriptions of distillation, reverse osmosis, and iron filters to lower arsenic and other common water constituents in drinking water.

No description available.

Osmosis is a phenomenon of critical importance in a variety of processes ranging from the transport of ions across cell membranes and the regulation of blood salt levels by the kidneys to the desalination of water and the production of clean energy using potential osmotic power plants. However, despite its importance and over one hundred years of study, there is an ongoing confusion concerning the nature of the microscopic dynamics of the solvent particles in their transfer across the membrane. In this thesis the microscopic dynamical processes underlying osmotic pressure and concentration gradients are investigated using molecular dynamics (MD) simulations. I first present a new derivation for the local pressure that can be used for determining osmotic pressure gradients. Using this result, the steady-state osmotic pressure is studied in a minimal model for an osmotic system and the steady-state density gradients are explained using a simple mechanistic hopping model for the solvent particles. The simulation setup is then modified, allowing us to explore the timescales involved in the relaxation dynamics of the system in the period preceding the steady state. Further consideration is also given to the relative roles of diffusive and non-diffusive solvent transport in this period. Finally, in a novel modi cation to the classic osmosis experiment, the solute particles are driven out-of-equilibrium by the input of energy. The effect of this modi cation on the osmotic pressure and the osmotic ow is studied and we find that active solute particles can cause reverse osmosis to occur. The possibility of defining a new "osmotic effective temperature" is also considered and compared to the results of diffusive and kinetic temperatures.

No description available.

This work introduces a systematic seawater reverse osmosis (SWRO) membrane network synthesis approach, based on the coordinated use of process superstructure representations and global optimization. The approach makes use of superstructure formulations that are capable of extracting a globally optimal design as a performance target, by taking into consideration desired process conditions and constraints that are typically associated with reverse osmosis systems. Thermodynamic insights are employed to develop lean network representations so that any underperforming solutions can be eliminated a priori. This essentially results in considerable improvement of the overall search speed, compared to previously reported attempts. In addition, the approach enables the extraction of structurally different design alternatives. In doing so, distinct membrane network design classes were established by partitioning the search space, based on network size and connectivity. As a result, corresponding lean superstructures were then systematically generated, which capture all structural and operational variants within each design class. The overall purpose is thus to enable the extraction of multiple distinct optimal designs, through global optimization. This mainly helps provide design engineers with a better understanding of the design space and trade-offs between performance and complexity. The approach is illustrated by means of a numerical example, and the results obtained were compared to previously related work. As anticipated, the proposed approach consistently delivered the globally optimal solutions, as well as alternative efficient design candidates attributed to different design classes, with reduced CPU times. This work further capitalizes on the developed representation, by accounting for detailed water quality information, within the SWRO desalination network optimization problem. The superstructures were modified to incorporate models that capture the performance of common membrane elements, as predicted by commercially available simulator tools, e.g. ROSA (Dow) and IMSDesign (Hydranautics). These models allow tracing of individual components throughout the system. Design decisions that are supported by superstructure optimization include network size and connectivity, flow rates, pressures, and post treatment requirements. Moreover, a detailed economic assessment capturing all the significant capital and operating costs associated in SWRO processes, including intake, pre and post treatment has also been accounted for. These modifications were then illustrated using a case study involving four seawater qualities, with salinities ranging from 35 to 45 ppt. The results highlight the dependency of optimal designs on the feed water quality involved, as well as on specified permeate requirements.

Deposition of calcium carbonate (CaCO3) and calcium sulfate (CaSO4) causes serious processing problems and limits the productivity of seawater reverse osmosis (RO) desalination. The interactions between CaSO4 and CaCO3 in the dynamic seawater RO systems have been neglected previously because conventional studies mainly focused on individual compounds or mixed compounds in batch systems. The present work evaluates composite fouling behavior of CaSO4 and CaCO3 in a dynamic RO unit. The fouling experiments were performed at constant pressure and velocity by a partial recycling mode which permeate was withdrawn from the system during the recirculation of retentate to simulate the increasing of water recovery level. The fouling phenomena were monitored by the decline of flux. Scanning electron microscopy (SEM) with a combination of elemental dispersive x-ray microanalysis (EDS), and x-ray powder diffraction (XRD) was used to identify the morphological features, chemical compositions and crystalline phases of foulants. The interactions of CaSO4 and CaCO3 were investigated by the comparison between individual CaSO4 or CaCO3 fouling and composite fouling, and by varying SO42-/HCO3- molar ratio of the feed. A recently developed approach, Scaling Potential Index (SPI) incorporated with measured concentration polarization modulus (CP), for assessing the fouling tendency of inorganic salts on the membrane surface was validated in the dynamic tests. In addition, the effectiveness of two generic scale inhibitors, polyacrylic acid (molecular weight =2100, PA) and sodium hexametaphosphate (SHMP) were evaluated. Some of the highlights of the obtained results are as follows: ??????The precipitation kinetics, morphology and adhesive strength of composite scales were different from pure precipitates ??????CaSO4 precipitated as gypsum while CaCO3 precipitated as two crystalline phases: calcite and aragonite ??????The crystalline phases as well as precipitation kinetics were affected by SO42-/HCO3- ratio ??????Scaling Potential Index was able to predict the fouling tendency of CaSO4 and CaCO3 accurately ??????The dosage of PA and SHMP was effective to mitigate fouling Results of this work are significant, not only because they have made contribution to the fundamental understanding of composite inorganic fouling in RO membrane systems which was ignored previously, but also because they may play a key role in the development of scale control.

Diss. (sammanfattning) Stockholm : Karol. inst., 2005. / Härtill 5 uppsatser.

Thesis (MSc.(Hons)) -- University of Western Sydney, 2002. / "A thesis submitted as fulfilment of the requirements for the Degree of Master of Science ( Honours)'' Bibliography: leaves 171-179.