Spelling suggestions: "subject:"microsatellite"" "subject:"nanosatellite""
1 |
BASELINE COMMUNICATIONS SYSTEM FOR A SMALL SATELLITEOrozco, Gina 10 1900 (has links)
International Telemetering Conference Proceedings / October 20-23, 2003 / Riviera Hotel and Convention Center, Las Vegas, Nevada / The NMSUSat is part of the AFRL/NASA University Nanosatellite program. The constellation will
consist of a main microsatellite that will have a command link from ground and a telemetry link to
ground while a picosatellite will act as a sensor reporting data to the microsatellite. Innovative
command and data handling will be incorporated at low cost and greater accessibility. In this paper
we present the necessary communications and control architecture for the space segment and the
ground segment of the nanosatellite.
|
2 |
Calibration and Characterization of Cubesat Magnetic Sensors Using a Helmholtz CageFoley, Justin Dean 01 December 2012 (has links) (PDF)
Small satellites, and CubeSats in particular, have quickly become a hot topic in the aerospace industry. Attitude determination is currently one of the most intense areas of development for these miniaturized systems and future Cal Poly satellite missions will depend heavily on magnetometers. In order to utilize magnetometers as a viable source of attitude knowledge, precise calibration is required to ensure the greatest accuracy achievable. This paper outlines a procedure for calibrating and testing magnetometers on the next generation of Cal Poly CubeSates, utilizing a Helmholtz cage to simulate any desired orbital magnetic field that would be experienced by a spacecraft around Earth, as well as investigation of magnetic interference as a result of on-board electrical activity.
|
3 |
Store and Forward Routing for Sparse Pico-Satellite Sensor Networks with Data-MulesKoritza, Trevor Joseph 01 June 2009 (has links) (PDF)
Satellites are playing an increasingly important role in collecting scientific information, providing communication services, and revolutionizing navigation. Until recently satellites were large and very expensive, creating a high barrier to entry that only large corporations and government agencies could overcome. In the past few years the CubeSat project at California Polytechnic University in San Luis Obispo (Cal Poly) has worked to refine the design and launching of small, lightweight, and less expensive satellites called pico-satellites, opening space up to a wider audience. Now that Cal Poly has the launch logistics and hardware under control, a new problem has arisen. These pico-satellites are within communication range of a ground station only 40 minutes a day. This, combined with their 1200 bps communication speed, limits the usefulness of the satellite missions to those only transmitting small amounts of data back to Earth. This thesis proposes a novel protocol that allows a sparse network of pico-satellites to communicate among one another and to larger satellites called data mules, which relay the information back to the ground station at much higher speeds. The data mules are able to provide higher speeds because they are larger satellites with less power constraints. This protocol makes it possible for a pico-satellite to send more data over a given amount of time with less end-to-end delay. When every satellite has large amounts of data almost three times as much aggregate data can be sent through the network, and almost five times more data can be sent if only a single satellite has large amounts of data to send. The end-to-end delay is cut almost in half when sending 1 MB of data per day per satellite and is decreased by a factor of at least three when sending large amounts of data from only one satellite.
|
4 |
Development of an Active Magnetic Attitude Determination and Control System for Picosatellites on highly inclined circular Low Earth OrbitsGiesselmann, Jens Uwe Michael, jens.giesselmann@gmx.net January 2006 (has links)
Small satellites are becoming increasingly important to the aerospace industry mainly due to their significantly reduced development and launch cost as well as shorter development time frames. In order to meet the requirements imposed by critically limited resources of very small satellites, e.g. picosatellites, innovative approaches have to be taken in the design of effective subsystem technologies. This thesis presents the design of an active attitude determination and control system for flight testing on-board the picosatellite 'Compass-1' of the University of Applied Sciences Aachen, Germany. The spacecraft of the CubeSat class with a net spacecraft mass of only 1kg uses magnetic coils as the only means of actuation in order to satisfy operational requirements imposed by its imagery payload placed on a circular and polar Low Earth Orbit. The control system is capable of autonomously dissipating the tumbling rates of the spacecraft after launch interface separ ation and aligning the boresight of the payload into the desired nadir direction within a pointing error of approximately 10°. This nadir-pointing control is achieved by a full-state feedback Linear Quadratic Regulator which drives the attitude quaternion and their respective rates of change into the desired reference. The state of the spacecraft is determined by a static statistical QUEST attitude estimator processing readings of a three-axis magnetometer and a set of five sun sensors. Linear Floquet theory is applied to quantify the stability of the controller and a non-linear dynamics simulation is used to confirm that the attitude asymptotically converges to the reference in the absence of environmental disturbances. In the presence of disturbances the system under control suffers from fundamental underactuaction typical for purely magnetic attitude control but maintains satisfactory alignment accuracies within operational boundaries.
|
5 |
On-Board Orbit Determination and 3-Axis Attitude Determination for Picosatellite ApplicationsBowen, John Arthur 01 July 2009 (has links) (PDF)
This thesis outlines an orbit determination and 3-axis attitude determination system for use on orbit as applicable to 1U CubeSats and other picosatellites. The constraints imposed by the CubeSat form factor led to the need for a simple configuration and relaxed accuracy requirements. To design a system within the tight mass, volume, and power constraints inherent to CubeSats, a balance between hardware complexity, software complexity and accuracy is sought. The proposed solution consists of a simple orbit propagator, magnetometers with a magnetic field look-up table, Sun sensors with an analytic Sun direction model, and the TRIAD method to combine vector observations into attitude information. The orbit propagator is a simple model of a circular trajectory with several frequently updated parameters and can provide orbital position data with average and maximum errors—when compared to SGP4—of less than 3.7km and 10.7km for 14 days. The magnetic field look up table provides useful information from a small memory footprint; only 480 data points provide a mean error of approximately 0.2° and a maximum error of approximately 2°—when compared to the IGRF model. The Sun’s direction is modeled, and as expected, can be modeled simply and accurately. Combining the magnetic field and Sun direction models with inaccurate sensors and the TRIAD method results in useful attitude information from a very simple system. A system with Sun sensor error standard deviation of 1° and magnetometer error standard deviation of 5° yields results with average error of only 2.74°, and 99% of the errors in this case are less than approximately 13°. The system outlined provides crude attitude determination with software and hardware requirements that are well within the capabilities of current 1U CubeSats—something that many other systems, such as Kalman filters or star trackers, cannot do. It also provides an excellent starting point for future ADCS systems, which will significantly increase the ability of CubeSats.
|
6 |
The development of Sun and Nadir sensors for a solar sail CubeSatLoubser, Hanco Evert 03 1900 (has links)
Thesis (MScEng (Electrical and Electronic Engineering))--University of Stellenbosch, 2011. / ENGLISH ABSTRACT: This thesis describes the development of attitude sensors required for the Attitude Determination and
Control System (ADCS) for a Cubesat. The aim is to find the most suitable sensors for use on a small picosatellite
by implementing miniaturised sensors with available commercial-off-the-shelf (COTS) technology.
Specifically, the algorithms, hardware prototypes, software and filters required to create accurate sensors
to determine the 3-axis orientation of a CubeSat are discussed. / AFRIKAANSE OPSOMMING: Hierdie tesis beskryf die ontwikkeling van oriëntasiesensors wat benodig word vir die oriëntasiebepaling
en -beheerstelsel (Engels: ADCS) van ’n CubeSat. Die doelwit is om sensors te vind wat die geskikste is om
in ’n klein picosatelliet te gebruik, deur miniatuursensors met kommersiële maklik verkrygbare tegnologie
(Engels: COTS technology) te implementeer. Daar word in die bespreking veral aandag geskenk aan die
algoritmes, hardewareprototipes, programmatuur en filters wat benodig word om akkurate sensors te
skep wat op hul beurt 3-as oriëntasie van die CubeSat kan bepaal.
|
Page generated in 0.0691 seconds