The deformation mechanism of an ultrafine grained (UFG) Al-Zn alloy has been studied. In this work, Al-15wt%Zn alloy was processed by equal channel angular extrusion (ECAE) route A at 100oC to achieve UFG structure. The deformation mechanism was studied by performing tensile test with various strain rates. Scanning electron microscopy and transmission electron microscopy were used to investigate the microstructure evolution in Al-15wt%Zn alloy with increasing ECAE passes. The observation indicated that the super saturated Al-Zn alloy would decompose and precipitate Zn particles during ECAE process. Increasing ECAE passes, the aluminum grain size was reduced, but the size of Zn particles was increased. However, the net effect of increasing ECAE passes is softening of this Al-Zn alloy. The tensile properties of the UFG Al-Zn alloy can be summarized as follows. (1)The UFG Al-Zn alloy possesses higher tensile strength and elongation as compared to commercial purity Al (AA1050). (2)The strain rate sensitivity of the UFG Al-Zn alloy increases significantly with increasing number of ECAE pass, which might be related to the refined aluminum grain size. After processed by 4-16 ECAE passes, the activation volume of the UFG Al-Zn alloy falls in the range of 25 b3~40 b3, which remains nearly constant value with increasing tensile strain. It is suggested that the controlling mechanism responsible for the tensile deformation of the UFG Al-Zn alloy might be related to a grain boundary mediated mechanism. (3)With increasing ECAE passes, the total tensile elongation of the UFG Al-Zn alloy increases but the uniform elongation show little change. This indicates that the increase in total elongation is mainly due to the contribution from an enhanced post-uniform elongation (PUE). It is suggested that the enhanced PUE might be related to the increase in strain rate sensitivity, which is resulted from the refinement of grain size. More detailed studies are needed to understand the deformation mechanism.

In this work, ultrafine-grained (UFG) Al-5wt%Zn alloy was produced by equal channel angular extrusion (ECAE). The microstructure evolution during ECAE and the mechanical properties of the UFG Al-Zn alloy were investigated. In order to identify the effect of Zn in the Al-Zn alloy, pure aluminum (4N, 99.99%) was also studied for comparison. The grains of the Al-Zn alloy could be refined effectively by increasing the ECAE passes. However, as the ECAE passes increased, the microhardness increased initially but maintained constant after 4 ECAE passes. The dislocation density within grain interior was decreased gradually with increasing ECAE passes. After being processed to twelve ECAE passes, the UFG Al-Zn alloy exhibited 53.7% of the grain boundaries being high angle grain boundaries (HAGBs). The UFG Al-5wt%Zn alloy exhibits superior tensile strength and elongation as compared with pure aluminum fabricated by the same ECAE process. Experimental results indicated that adding Zn in aluminum alloy could provide solid-solution strengthening and considerable enhancement in tensile ductility which might be related to an improved post-uniform elongation (PUE). The strain rate sensitivity (SRS) of the UFG Al-Zn alloy also increased with increasing the ECAE passes, which might be related to the fine grain size and the contribution of grain boundary sliding. The activation volume of the UFG Al-Zn alloy was in the range of 32b3~76b3, and the pure aluminum was in the range of 57b3~122b3. Because of the small value of the activation volume, it is suggested that the controlling mechanism for dislocation glide in the UFG Al-Zn alloy might be related to the generation and absorption of dislocations in grain boundary, as well as the interaction between dislocations and solute Zn atoms in the grain boundary.