In this study, a progressive failure analysis is used to investigate leakage in internally pressurized non-circular composite cylinders. This type of approach accounts for the localized loss of stiffness when material failure occurs at some location in a structure by degrading the local material elastic properties by a certain factor. The manner in which this degradation of material properties takes place depends on the failure modes, which are determined by the application of a failure criterion. The finite-element code STAGS, which has the capability to perform progressive failure analysis using different degradation schemes and failure criteria, is utilized to analyze laboratory scale, graphite-epoxy, elliptical cylinders with quasi-isotropic, circumferentially-stiff, and axially-stiff material orthotropies. The results are divided into two parts. The first part shows that leakage, which is assumed to develop if there is material failure in every layer at some axial and circumferential location within the cylinder, does not occur without failure of fibers. Moreover before fibers begin to fail, only matrix tensile failures, or matrix cracking, takes place, and at least one layer in all three cylinders studied remain uncracked, preventing the formation of a leakage path. That determination is corroborated by the use of different degradation schemes and various failure criteria. Among the degradation schemes investigated are the degradation of different engineering properties, the use of various degradation factors, the recursive or non-recursive degradation of the engineering properties, and the degradation of material properties using different computational approaches. The failure criteria used in the analysis include the noninteractive maximum stress criterion and the interactive Hashin and Tsai-Wu criteria. The second part of the results shows that leakage occurs due to a combination of matrix tensile and compressive, fiber tensile and compressive, and inplane shear failure modes in all three cylinders. Leakage develops after a relatively low amount of fiber damage, at about the same pressure for three material orthotropies, and at approximately the same location. / Master of Science

In broadband antenna applications, the antenna's cavity is usually loaded with absorbers to eliminate the backward radiation, but in doing so the radiation efficiency of the antenna is decreased. To enhance the radiation efficiency of the antennas EBG structures are used, but they operate over a narrow band. Uniform electromagnetic band gap (EBG) structures are usually periodic structures consisting of metal patches that are separated by small gaps and vias that connect the patches to the ground plane. The electrical equivalent circuit consists of a resonant tank circuit, whose capacitance is represented by the gap between the patches and inductance represented by the via. EBG structures are equivalent to a magnetic surface at the frequency of resonance and thus have very high surface impedance; this makes the EBG structures useful when mounting an antenna close to conducting ground plane, provided the antenna's currents are parallel to the EBG structure. Because EBG structures are known to operate over a very narrow band, they are not useful when used with a broadband antenna. Mushroom-like uniform EBG structures (that use vias) are compact in size have low loss, can be integrated into an antenna to minimize coupling effects of ground planes and increase radiation efficiency of the antenna. The bandwidth of an EBG structure is defined as the band where the reflection-phase from the structure is between +900 to -900. In this dissertation analysis of EBG structures is established using circuit analysis and transmission line analysis. Methods of increasing the bandwidth of EBG structures are explored, by cascading uniform EBG structures of different sizes progressively and vertically (stacked), and applications with different types of antennas are presented. Analyses in this dissertation are compared with previously published results and with simulated results using 3D electromagnetic tools. Validation of applications with antennas is carried by manufacturing prototypes and comparing measured performance with analysis and 3D electromagnetic simulations. The improvements in performance by using wideband progressive EBG and wideband stacked EBG structures are noted. / Ph. D.

In recent years, the people of Latin America have organized and elected political leaders traditionally excluded from their nation's established political systems. In Venezuela and Bolivia, the shifts to the left may have been the most drastic. This research will look to what extent United States Foreign Policy led to a radical restructuring in the Venezuelan and Bolivian political systems. Additionally the research will examine the effect of America' War on Drugs and other misguided policies that led to a rejection of the old era of American cooperation and in turn an embrace of a new vision. Utilizing the Dependency Theory as a framework and applying the Blowback Theory, the research synthesizes the contemporary history of the two nations and popular opinion of cooperation with the US. Specifically, research will also focus on the effect undemocratic policies have had on fostering an environment of solidarity among people to come together and link their struggles against hegemonic American policies. Cooperation with the US has often led to the adoption of market-centered economic policies that left the two countries in states of severe poverty where the only way for the people to survive was to collectively organize.

The purpose of the proposed research is to evaluate the mechanical response of stitched T-joints under tension, bending, and combined tensile-flexure loading. The use of fiber-reinforced polymer matrix composites has increased in primary load-bearing structures due to their many attributes, such as their high strength and stiffness-to-weight ratio, and tailorability. Composite T-joints are often used in aerospace, marine, and wind turbine structures to provide load connectivity between orthogonal components, such as stiffeners to skins. However, one of the main drawbacks of polymer matrix composites is their low interlaminar strength, which can lead to delamination when subjected to out-of-plane loads. Techniques such as braiding, knitting, stitching, tufting, and z-pinning have been used to reinforce T-joints in the through-thickness direction. Most research has been focused on the tensile or bending behavior of T-joints, although these joints are often subjected to a combination of tensile and bending loads in service. A few experimental and analytical studies have been conducted on the mechanical response under combined tensile-flexure loading conditions, but no studies have been conducted on stitched T-joints. In this study, mechanical tests of 3D stitched and unstitched T-joints under tension, bending, and combined tensile-flexure were conducted, and the ultimate load, displacement, and absorbed energy were obtained. The average displacement at total failure under tension, bending, and combined tensile-flexure loading conditions for the stitched specimens were found to be 34%, 51%, and 24% greater, respectively, when compared to their unstitched counterparts. Similarly, the average absorbed energy for stitched specimens is 58%, 82%, and 51% greater under tension, bending, and combined tensile-flexure loading conditions. The failure surfaces of stitched and unstitched T-joints were analyzed using an optical microscope, and areas of interest, such as resin-rich regions, stitches, and different damage types, were identified. Furthermore, the skin-flange interface fracture surface of the combined loading T-joint specimens were analyzed using a scanning electron microscope. Significant differences in the fracture surface indicated varying degrees of mixed-mode loading conditions within a specimen for all specimen types. A numerical analysis of a stitched double cantilever beam specimen was conducted to evaluate smeared cohesive laws to represent stitched regions. Overall, stitching results in improved damage tolerance in T-joints subjected to various loading conditions.

Yes / Over the last few decades, progressive collapse disasters have drawn the attention of codified bodies around the globe; as a consequence, there has been a renewed research interest. Structural engineering systems are prone to progressive collapse when subjected to abnormal loads beyond the ultimate capacity of critical structural members. Sudden loss of critical structural member(s) triggers failure mechanisms which may result in a total or partial collapse of the structure proportionate or disproportionate to the triggering event. Currently, researchers adopt different modelling techniques to simulate the loss of critical load bearing members for progressive collapse assessment. GSA guidelines recommend a column removal time less than a tenth of the period of the structure in the vertical vibration mode. Consequently, this recommendation allows a wide range of column removal time which produces inconsistent results satisfying GSA recommendation. A choice of a load time history function assumed for gravity and the internal column force interaction affects the response of the structure. This paper compares different alternative numerical approaches to simulate the sudden column removal in frame buildings and to investigate the effect of rising time on the structural response.

Yes / The development of the patchwise Partial Di erential Equation (PDE) framework a few years a- go has paved the way for the PDE method to be used in mesh signal processing. In this paper we, for the rst time, extend the use of the PDE method to progressive mesh compression and mesh denoising. We, meanwhile, upgrade the existing patchwise PDE method in patch merging, mesh partitioning, and boundary extraction to accommodate mesh signal processing. In our new method an arbitrary mesh model is partitioned into patches, each of which can be represented by a small set of coe cients of its PDE spectral solution. Since low- frequency components contribute more to the recon- structed mesh than high-frequency ones, we can achieve progressive mesh compression and mesh denoising by manipulating the frequency terms of the PDE solution. Experimental results demonstrate the feasibility of our method in both progressive mesh compression and mesh denoising.

Yes / A recent randomised controlled trial indicated that providing long-term multifocal wearers with a pair of distance single-vision spectacles for use outside the home reduced falls risk in active older people. However, it also found that participants disliked continually switching between using two pairs of glasses and adherence to the intervention was poor. In this study we determined whether intermediate addition multifocals (which could be worn most of the time inside and outside the home and thus avoid continual switching) could provide similar gait safety on stairs to distance single vision spectacles whilst also providing adequate ‘short-term’ reading and near vision. Methods: Fourteen healthy long-term multifocal wearers completed stair ascent and descent trials over a 3-step staircase wearing intermediate and full addition bifocals and progression-addition lenses (PALs) and single-vision distance spectacles. Gait safety/caution was assessed using foot clearance measurements (toe on ascent, heel on descent) over the step edges and ascent and descent duration. Binocular near visual acuity, critical print size and reading speed were measured using Bailey-Lovie near charts and MNRead charts at 40 cm. Results: Gait safety/caution measures were worse with full addition bifocals and PALs compared to intermediate bifocals and PALs. The intermediate PALs provided similar gait ascent/descent measures to those with distance single- vision spectacles. The intermediate addition PALs also provided good reading ability: Near word acuity and MNRead critical print size were better with the intermediate addition PALs than with the single-vision lenses (p < 0.0001), with a mean near visual acuity of 0.24 0.13 logMAR (~N5.5) which is satisfactory for most near vision tasks when performed for a short period of time. Conclusions: The better ability to ‘spot read’ with the intermediate addition PALs compared to single-vision spectacles suggests that elderly individuals might better comply with the use of intermediate addition PALs outside the home. A lack of difference in gait parameters for the intermediate addition PALs compared to distance single-vision spectacles suggests they could be usefully used to help prevent falls in older well-adapted full addition PAL wearers. A randomised controlled trial to investigate the usefulness of intermediate multifocals in preventing falls seems warranted.

Yes / Chronic non-malignant pain is a global condition with a complex biopsychosocial impact on the sufferers. Relaxation skills are commonly included as part of a pain management programme, which is currently the recommended evidence-based intervention for this group of patients. However, there is little evidence behind the choice of relaxation method implemented, or their effectiveness. The aim of this study was to investigate the effectiveness of relaxation skills in the management of chronic non-malignant pain, related to pain intensity and health-related quality of life. A systematic literature review was conducted using MEDLINE, CINAHL, AMED, PEDro and PsycARTICLES. The Cochrane, DARE and Trip databases were also accessed, and searches were carried out using the terms (relaxation OR relaxation therapy OR relaxation training) AND (pain OR chronic pain). Following critical appraisal, ten studies met the inclusion criteria. Three studies reported a decrease in pain intensity as a result of the relaxation intervention, whilst only one study reported an improvement in health-related quality of life. Progressive muscle relaxation was the most commonly implemented method throughout, although its method of delivery differed between studies. There is little evidence for the use of relaxation as a stand-alone intervention for pain intensity and health-related quality of life for patients with musculoskeletal chronic non-malignant pain. More research is needed to determine its effectiveness.

Le vieillissement de la population dans les pays membres de l'Organisation de coopération et de développement économiques (OCDE) constitue un sujet de plus en plus préoccupant. Ce phénomène comprend de nombreuses questions sur la constitution de la population active et la viabilité des systèmes de retraite. L'une des solutions apportées par le gouvernement du Québec a été la mise en place de mécanismes de retraite progressive. Ce mémoire a voulu comprendre la construction de ces mécanismes par l'analyse des politiques publiques de retraite progressive. La littérature portant sur la retraite progressive montre très clairement que le contexte démographique est à la base de l'élaboration de mécanismes de retraite progressive. Malgré les nombreuses études descriptives et normatives, aucune d'entre elles n'analyse l'implication des acteurs sociaux dans ce domaine. L'objet du mémoire est d'analyser l'influence de ces acteurs sur les politiques publiques de retraite progressive en la comparant à l'influence des politiques de retraite progressive déjà en application dans d'autres pays. La recherche mise sur la théorie des conventions afin d'analyser les différentes sources d'influences de la construction des politiques publiques de retraite progressive. Inspiré de cette théorie, un modèle d'analyse de la coordination a été créé dans le but d'étudier les aspects qui sont susceptibles d'avoir influencé le gouvernement dans la mise en place de ces politiques publiques. La nouvelle perspective d'analyse utilisée dans cette étude démontre la contribution du contexte social, économique, historique et institutionnel dans l'élaboration des mécanismes de retraite progressive du Québec.

Les thérapies génique et cellulaire sont à l'avant-garde de la recherche sur le traitement des dystrophies musculaires. La thérapie par transfert de myoblastes a été proposée comme traitement potentiel de ces dystrophies et les transplantations de myoblastes ont donné des résultats significatifs. Dans cette optique, une thérapie cellulaire autologue est à favoriser et cette approche implique une modification génétique ex vivo. Cette méthode nécessite une efficacité exemplaire du transfert, de l'implantation et de l'expression de l'ADN recombinant. Les myoblastes du muscle squelettique humain sont cependant plus ou moins réfractaires à certains vecteurs viraux. Nous avons donc procédé à l'étude de l'efficacité de vecteurs dérivés d'un rétrovirus, d'un lentivirus, d'un adénovirus et de virus adéno-associés, dans la transduction d'un transgène dans les myoblastes humains. Nous établissons que les vecteurs rétroviraux et lentiviraux démontrent un potentiel remarquable dans une perspective de thérapie génique ex vivo, dédiée à la musculature squelettique humaine. / Gene and cell therapies are at the forefront of research for the treatment of muscular dystrophies. Myoblast transfer therapy was proposed as a potential treatment for these diseases and myoblast transplantation experiments yielded significant results. In this approach, an autologous cell therapy would be preferable and this implies ex vivo gene therapy. However, gene delivery and expression must be optimal in this context and human myoblast is refractory to some viral vectors. For that reason, we have studied the transduction capacities, on such cells, of viral vectors derived from retrovirus, lentivirus, adenovirus and adeno-associated virus. We concluded that the retroviral and lentiviral vectors are the best suited for ex vivo gene therapy of human skeletal muscle cells dedicated to cell therapy.