A measurement of solar neutrinos below 1 MeV of energy will further our knowledge of the neutrino's mass and mixing properties and will provide a probe to possible physics beyond the standard model of particle physics, as well as advance our understanding of energy production in the Sun. Borexino is a liquid scintillator detector that will measure the neutrino energy spectrum to the lowest energy threshold to date. It has been designed to measure the flux of the mono-energetic neutrinos produced by electron capture on 7Be in the Sun's core, which will produce a Compton-like edge in the energy spectrum. Because of the low count rate, Borexino requires extremely low backgrounds, and a good understanding of the backgrounds that do exist. Although the purification techniques used for the scintillator lowered the radioactive contaminates to levels never before achieved, cuts must still be made to the data. At Virginia Tech, we have developed an internal source calibration program that will be able to give us a thorough understanding of both the pulse shape discrimination efficiency and the energy and time response of Borexino. Energy calibration for alphas, betas, and gammas (energy scales) can be accomplished with such sources. When the calibration source is used in conjunction with an accurate source location system any spatial dependencies can be found. The system will use different types of sources at various energies to give the required information to make the cuts needed to extract believable physics from the detector. / Ph. D.

The purpose of this research is to determine the feasibility of creating an affordable and durable neutron detector for usage in the field surveys, site inspections, and transportation hub monitoring. Currently, organic scintillating detectors are an established method of detecting neutrons but are either costly, fragile solids like stilbene, or flammable liquids like benzene. In this work, several scintillation mixtures were tested with a PuBe source, which emits both neutrons and gamma rays. The pulse shape discrimination method was utilized to separate the signal pulses created from the mixed radiation field of the PuBe source. Two candidate mixtures were selected for solidification with elastomers for their verified neutron detection capabilities. The solid detectors measured high energy neutrons and gamma rays from the PuBe source. The solidified detectors have a Figure of Merit for separating neutrons of 0.859 ±0.419 and cost $0.13 per gram, while commercially available stilbene separates neutrons from gammas with a Figure of Merit of 4.70 and costs $64.36 per gram. This research shows that it is feasible to create affordable solid organic scintillators sensitive to high energy neutrons.

Astronomical and cosmological observations reveal that the majority of the matter in our universe is made of an unknown, non-luminous substance called dark matter. Many experimental attempts are underway to directly detect particle dark matter, which is very difficult to measure due to the expected low interaction rate with normal matter. DEAP-3600 is a direct dark matter search experiment located two kilometres underground at SNOLAB, in Sudbury, Ontario. DEAP-3600 will make use of liquid argon as the detector material, which scintillates as charged particles pass through. The work presented here is an investigation of expected background sources in the DEAP detector. Because DEAP-3600 is a noble liquid-based experiment, a thin film of [1,1,4,4]-tetraphenyl-[1,3]-butadiene (TPB) is coated on the detector walls to shift the scintillation peak from the UV to visible regime for detection. However, alphas passing through TPB produce scintillation signals which can mimic recoil events. Because scintillation properties can change with temperature, we have conducted an investigation of alpha-induced TPB scintillation at temperatures ranging from 300 K to 3.4 K. We were able to characterize the light yield and decay times, and demonstrated that these background events should be distinguishable from true recoil events in liquid argon, thus enabling DEAP-3600 to achieve higher dark matter sensitivity. Additionally, we investigate the performance of the liquid argon purification systems, specifically the activated charcoal used for radon filtration. Previous measurements with the DEAP prototype experiment have demonstrated the necessity of removing radon from the argon prior to filling the detector, due to the release of contaminates from the argon storage systems. Charcoal radon filters are extremely efficient, however, if the emanation rate of the charcoal is too high, there is the possibility of re-contamination. We performed a measurement of the radon emanation rate of a charcoal sample using a radon emanation and extraction system at Queens University. We demonstrated that the emanation rate of the charcoal was consistent with zero. We also show that the number of residual radon atoms which reach the detector would not be an issue for DEAP-3600. / Thesis (Master, Physics, Engineering Physics and Astronomy) -- Queen's University, 2013-10-10 18:36:40.2

This thesis presents an independent analysis of the data from 3-He-filled proportional counters from the third phase of the Sudbury Neutrino Observatory (SNO) data. These counters were deployed in SNO's heavy water to independently detect neutrons produced by the neutral current interaction of 8-B solar neutrinos with deuterium. Previously published results from this phase were based on a spectral analysis of the energy deposited in the proportional counters. The work in this thesis introduces a new observable based on the time-profile of the ionization in the counters. The inclusion of this observable in a maximum-likelihood fit increases the potential to distinguish neutrons from backgrounds which are primarily due to alpha-decays. The combination of this new observable with the energy deposited in the counters results in a more accurate determination of the number of neutrons. The analysis presented in this thesis was limited to one third of the data from the proportional counters, uniformly distributed in time. This limitation was imposed to reconcile different time-lines between the submission of this thesis, a thorough review of this work by the SNO Collaboration and results from an independent analysis that is still underway. Analysis of this reduced data set determined that 398 +/- 29 (stat.) +/- 9 (sys.) neutrons were detected in this reduced data-set. The number compares well to the previous analysis of the data, based only on a spectral analysis of the deposited energy, which determined that 410 +/- 44 (stat.) +/- 9 (sys.) were detected in the same time period. The analysis presented here has led to a substantial increase in the statistical accuracy. Assuming that the statistical accuracy will increase when the full data set is analyzed, the results from this thesis would bring the uncertainty in the 8-B solar neutrino flux to down 6.8% from 8.5% in the previously published results. The work from the thesis is intended to be included in a future analysis of the SNO data and will result in a more accurate measurement of the total flux of solar neutrinos from 8-B as well as reduce the uncertainty in the $\theta_{12}$ neutrino oscillation mixing angle. / Thesis (Ph.D, Physics, Engineering Physics and Astronomy) -- Queen's University, 2009-09-16 15:56:28.195

In this report the neutron-gamma discrimination capabilities of the new type of solid organic scintillator, EJ-299-33, was investigated using several pulse-shape discrimination (PSD) techniques. Among others, the analog zero-crossing method andthe digital charge-comparison and integrated-rise-time method were tested. The parameters of the digital PSD methods were optimised individually and the figure-of-merit was measured for each method and compared in different energy windows. The photoelectron yield of the setup was measured using two different photomultiplier tubes (PMT), a 3 inch diameter ET 9821 and a 5 inch diameter ET 9390KB. The highest photoelectron yield was measured with the ET 9390KB, which was the PMT used for the neutron-gamma discrimination capability measurements. In this work, four decay constants were found for the scintillator decay times. These were found by fitting average neutron and gamma-ray waveforms with the convolution of severeal exponential functions, that describes the light emission intensity of the scintillator, with an approximation of the PMT response function. Thebest agreement was found for the assumption that the scintillator light emission intensity is governed by four decay constants. The intensity of the two slowest components contain information about the incident particle.

This report describes investigations of the NE213-detector and the possibility to utilize pulse shape analysis to separate neutrons and gammas in a mixed emission field. Neutron fluxes are often contaminated with gammas, to which the detectors are sensitive. Sorting out the unwanted gamma pulses from the interesting neutrons is therefore crucial in many situations, for instance in fusion reactor diagnostics, such as for neutron cameras. This can be done based on pulse shapes, which differ for gammas and neutrons interacting in the NE213-detector. By analyzing the pulse shapes from a digital transient recorder, neutrons can be distinguished from gammas. An experiment with a Cf-252 neutron source was set up and provided data. The separation algorithm was based on charge comparison and gave good results. Furthermore the results of the pulse shape analysis were verified by TOF-measurements. The lowest permissible energy for a reasonable separation was found to be around 0.5 MeV. Some conclusions on the limitations of the equipment were also made.

>Magister Scientiae - MSc / A (5 cm × 5 cm) cylindrical NE213 liquid organic scintillator and a (2.5 cm × 2.5 cm)cylindrical NE230 liquid organic scintillator were used as spectrometers. A series of measurements was made with both the NE213 and NE230 spectrometers, with the time-of- flight technique used for neutron energy selection. Pulse height spectra for quasi- monoenergetic neutron beams of ~5-64 MeV produced by bombarding either a (1 mm) lithium metal target, or a (10 mm) beryllium target, or a (10 mm) graphite target with 66 MeV proton beam were measured with both spectrometers. Deuteron events identified by pulse shape discrimination were selected for measurements with the NE230 spectrometer while proton events were selected for measurements with the NE213 spectrometer. Response of the scintillator to protons using NE213 and deuterons using NE230 were obtained from the measured pulse height spectra. Detector efficiency of the NE213 spectrometer as a function of neutron energy was determined for n-p elastic scattering. The detector efficiency of the NE230 was determined relative to the well-known efficiency of the NE213 spectrometer, selecting either all or n-d elastic events in the pulse height spectra measured with the NE230 spectrometer. The detection efficiency of the NE230 spectrometer was also determined from the available cross-section for n-d elastic scattering as exploratory work. Neutron fluence spectra could be determined using the appropriate neutron detection efficiency for each spectrometer and were compared with each other. The results showed good comparison and encouragement demonstrating the reliability of neutron fluence spectral measurements withthe NE230 spectrometer using the time-of-flight technique.

No description available.

This dissertation investigates CsI(Tl) pulse shape discrimination (PSD) as a novel experimental technique to improve challenging areas of particle identification at high energy $e^+ e^-$ colliders using CsI(Tl) calorimeters. In this work CsI(Tl) PSD is implemented and studied at the Belle II experiment operating at the SuperKEKB $e^+ e^-$ collider, representing the first application of CsI(Tl) PSD at a $B$ factory experiment. Results are presented from Belle II as well as a testbeam completed at the TRIUMF proton and neutron irradiation facility. From the analysis of the testbeam data, energy deposits from highly ionizing particles are shown to produce a CsI(Tl) scintillation component with decay time of $630\pm10$ ns, referred to as the hadron scintillation component, and not present in energy deposits from electromagnetic showers or minimum ionizing particles. By measuring the fraction of hadron scintillation emission relative to the total scintillation emission, a new method for CsI(Tl) pulse shape characterization is developed and implemented at the Belle II experiment's electromagnetic calorimeter, constructed from 8736 CsI(Tl) crystals. A theoretical model is formulated to allow for simulations of the particle dependent CsI(Tl) scintillation response. This model is incorporated into GEANT4 simulations of the testbeam apparatus and the Belle II detector, allowing for accurate simulations of the observed particle dependent scintillation response of CsI(Tl). With $e^\pm$, $\mu^\pm$, $\pi^\pm$, $K^\pm$ and $p/\bar{p}$ control samples selected from Belle II collision data the performance of this new simulation technique is evaluated. In addition the performance of hadronic interaction modelling by GEANT4 particle interactions in matter simulation libraries is studied and using PSD potential sources of data vs. simulation disagreement are identified. A PSD-based multivariate classifier trained for $K_L^0$ vs. photon identification is also presented. With $K_L^0$ and photon control samples selected from Belle II collision data, pulse shape discrimination is shown to allow for high efficiency $K_L^0$ identification with low photon backgrounds as well as improved $\pi^0$ identification compared to shower-shape based methods. / Graduate

This thesis describes the development of electronic modules for fusion neutron spectroscopy as well as several implementations of artificial neural networks (NN) for neutron diagnostics for the Joint European Torus (JET) experimental reactor in England. The electronics projects include the development of two fast light pulser modules based on Light Emitting Diodes (LEDs) for the calibration and stability monitoring of two neutron spectrometers (MPRu and TOFOR) at JET. The particular electronic implementation of the pulsers allowed for operation of the LEDs in the nanosecond time scale, which is typically not well accessible with simpler circuits. Another electronic project consisted of the the development and implementation at JET of 32 high frequency analog signal amplifiers for MPRu. The circuit board layout adopted and the choice of components permitted to achieve bandwidth above 0.5 GHz and low distortion for a wide range of input signals. The successful and continued use of all electronic modules since 2005 until the present day is an indication of their good performance and reliability. The NN applications include pulse shape discrimination (PSD), deconvolution of experimental data and tomographic reconstruction of neutron emissivity profiles for JET. The first study showed that NN can perform neutron/gamma PSD in liquid scintillators significantly better than other conventional techniques, especially for low deposited energy in the detector. The second study demonstrated that NN can be used for statistically efficient deconvolution of neutron energy spectra, with and without parametric neutron spectroscopic models, especially in the region of low counts in the data. The work on tomography provided a simple but effective parametric model for describing neutron emissivity at JET. This was then successfully implemented with NN for fast and automatic tomographic reconstruction of the JET camera data. The fast execution time of NN, i.e. usually in the microsecond time scale, makes the NN applications presented here suitable for real-time data analysis and typically orders of magnitudes faster than other commonly used codes. The results and numerical methods described in this thesis can be applied to other diagnostic instruments and are of relevance for future fusion reactors such as ITER, currently under construction in Cadarache, France.