The behavior during dissolution of edge and basal surfaces of the mica phlogopite were examined using in situ atomic force microscopy (AFM), x-ray photoelectron spectroscopy (XPS) and low-energy electron diffraction (LEED) in an attempt to characterize the reactive surface area during dissolution. Mica minerals are the ideal material for this study because they offer a high degree of structural anisotropy. Therefore surfaces with different structures are easily identified. Dissolution is shown to proceed preferentially by removal of material from {hk0} edges. Dissolution rates were calculated by measuring the volume of material removed from etch pits, and normalizing to either the "reactive" surface area of {hk0} edges exposed at pit walls, or to a total "BET-equivalent" surface area. Rates normalized to total surface area are in the range of dissolution rates reported in the literature. Edge surface normalized rates are about 100 times faster. Long-term in situ AFM observations of phlogopite dissolution reveal that exposed (001) surfaces also display a distinct reactivity, though it operates on a different time scale. The top layer is shown to expand between 39 and 63 hours in contact with pH 2 HCl solution. Subsequent LEED analysis shows that the (001) surface becomes amorphous upon reacting with pH 2 HCl. Compositional characterization of the phlogopite after reaction shows that for pitted phlogopite surfaces, dissolution is characterized by leaching of octahedral cations and polymerization of the silica-enriched residual layer. No chemical changes or polymerization are observed for freshly cleaved unpitted phlogopite after reaction with pH 2 HCl for 24 hours. This suggests a gallery access mechanism is facilitated by edge attack, and is only significant on exposed (001) surfaces after a certain amount of dissolution by edge attack. / Master of Science

L’objectif de cette thèse est de quantifier l’évolution de la surface réactive d’un silicate modèle (orthose) lors de son altération hydrothermale et estimer son impact sur la cinétique réactionnelle. L’étude porte sur : (1) l’influence de la présence de couverture de phases secondaires à même la surface de l’orthose, (2) l’impact de l’anisotropie de la structure cristalline de l’orthose et (3) l’effet de la formation de puits de corrosion en surface. Les résultats expérimentaux et numériques mettent en évidence que la vitesse de dissolution de l’orthose et son évolution au cours du temps dépendent essentiellement de sa morphologie.Certaines faces cristallines se dissolvent 10 fois plus rapidement que d’autres, entraînant une augmentation de la proportion de faces rapides au cours du processus et une élévation, jusqu’à un ordre de grandeur, de la vitesse de dissolution globale de l’orthose. Ces résultats ouvrent d’importantes pistes de réflexion sur la méthode adéquate pour rendre compte des cinétiques des interactions fluide/roche sur le terrain ainsi que sur la signification des lois de vitesse et des mécanismes réactionnels déterminés à partir d’expériences sur poudre. / This thesis aims at quantifying the reactive surface area evolution of dissolving K- feldspar, and evaluating the impact on the dissolution kinetics during its alteration in geothermal context. The study focuses on : (1) the influence of secondary coatings on the orthoclase surface, (2) the impact of the anisotropic crystalline structure of orthoclase and (3) the effect of etch pit formation on the mineral surface. Experimental and numerical results highlight that the orthoclase dissolution rate and its evolution over time mainly depends onits morphology. Some orthoclase faces dissolve 10 times faster than others, resulting in an increase of the surface proportion of rapid vs. slow dissolving faces during the process and the increase of up to an order of magnitude of the overall orthoclase dissolution rate. These results question the significance of rate laws and reaction mechanisms determined from powder experiments and the pave to new approaches for investigating mineral reactivity.