A recently-developed experimental technique based on the sublimation of naphthalene, which enables imaging of the dispersion of a passive scalar using planar laser-induced fluorescence (PLIF), is applied to a Mach 5 turbulent boundary layer and a NASA Orion capsule flowfield. To enable the quantification of naphthalene PLIF images, quantitative fluorescence and quenching measurements were made in a temperature- and pressure-regulated test cell. The test cell measurements were of the naphthalene fluorescence lifetime and integrated fluorescence signal over the temperature range of 100 K to 525 K and pressure range of 1 kPa to 40 kPa in air. These data enabled the calculation of naphthalene fluorescence yield and absorption cross section over the range of temperatures and pressures tested, which were then fit to simple functional forms for use in the calibration of the PLIF images. Quantitative naphthalene PLIF images in the Mach 5 boundary layer revealed large-scale naphthalene vapor structures that were regularly ejected out to wall distances of approximately y/δ = 0.6 for a field of view that spanned 3δ to 5δ downstream of the trailing edge of the naphthalene insert. The magnitude of the calculated naphthalene mole fraction in these structures at y/δ = 0.2 ranged from approximately 1-6% of the saturation mole fraction at the wind tunnel recovery temperature and static pressure. An uncertainty analysis showed that the uncertainty in the inferred naphthalene mole fraction measurements was ± 20%. Mean mole fraction profiles collected at different streamwise locations were normalized by the mole fraction measured at the wall and a characteristic height of the scalar boundary layer, causing the profiles to collapse into one “universal” mole fraction profile. Two-dimensional fields of naphthalene mole fraction were also obtained simultaneously with velocity by using particle image velocimetry (PIV) and PLIF. The images show large-scale naphthalene vapor structures that coincide with regions of relatively low streamwise velocity. The covariance of naphthalene mole fraction with velocity indicates that an ejection mechanism is transporting low-momentum, high-scalar-concentration fluid away from the wall, resulting in the protrusions of naphthalene vapor evident in the instantaneous PLIF images. Lastly, naphthalene PLIF was used to visualize the dispersion of gas-phase ablation products on a scaled Orion capsule model at four different angles of attack at Mach 5. High concentrations of scalar were imaged in the capsule recirculation region. Additionally, intermittent turbulent structures were visualized on the heat shield surface, particularly for the 12° and 52° AoA cases.

Not available

In this thesis, I focus on scalar implicatures, presuppositions and their connections. In chapter 2, I propose a scalar implicature-based account of neg-raising inferences, standardly analyzed as a presuppositional phenomenon (Gajewski 2005, 2007). I show that an approach based on scalar implicatures can straightforwardly account for the differences and similarities between neg-raising predicates and presuppositional triggers. In chapters 3 and 4, I extend this account to “soft” presuppositions, a class of presuppositions that are easily suspendable (Abusch 2002, 2010). I show how such account can explain the differences and similarities between this class of presuppositions and other presuppositions on the one hand, and scalar implicatures on the other. Furthermore, I discuss various consequences that it has with respect to the behavior of soft presuppositions in quantificational sentences, their interactions with scalar implicatures, and their effects on the licensing of negative polarity items. In chapter 5, I show that by looking at the interaction between presuppositions and scalar implicatures we can solve a notorious problem which arises with conditional sentences like (1) (Soames 1982, Karttunen and Peters 1979). The main issue with (1) is that it is intuitively not presuppositional and this is not predicted by any major theory of presupposition projection. (1) I’ll go, if you go too. Finally, I explore in more detail the question of which alternatives should we consider in the computation of scalar implicatures (chapter 6). Traditionally, the answer has been to consider the subset of logically stronger alternatives than the assertion. Recently, however, arguments have been put forward in the literature for including also logically independent alternatives. I support this move by presenting some novel arguments in its favor and I show that while allowing new alternatives makes the right predictions in various cases, it also causes an under- and an over-generation problem. I propose a solution to each problem, based on a novel recursive algorithm for checking which alternatives are to be considered in the computation of scalar implicatures and the role of focus (Rooth 1992, Fox and Katzir 2011). / Linguistics

Sophisticated electromagnetic pulse sequences that control spin dynamics have been developed in Nuclear Magnetic Resonance (NMR) over the last few decades. However, due to more and more demanding criteria, such as unknown parameters, larger bandwidths, higher signal to noise ratio (SNR), less power consumption, etc., new pulse sequences are constantly needed. This thesis presents new pulse sequences for several important applications of NMR. / Engineering and Applied Sciences

Η παρούσα διπλωματική εργασία αποτελεί μια μελέτη επί του ελέγχου των κινητήρων επαγωγής που στόχο έχει τη διερεύνηση της επίδασης των διαφορετικών σημάτων ανάδρασης (ανάλογο στροφών και ανάλογο του τετραγώνου στοφών) στην απόκριση του συστήματος κίνησης. Για το σκοπό αυτό αναπτύχθηκε ενδελεχώς η σχετική θεωρία, μελετήθηκε η παθητικότητα ηλεκτρομηχανικών συστημάτων, χρησιμοποιήθηκε συγκεκριμένος ηλεκτρονικός μετατροπέας και κατασκευάστηκε μετατροπέας σήματος συνεχούς ρεύματος ανάλογος του αριθμού των στροφών και του τετραγώνου του. Στα πλαίσια της εργασίας εξετάστηκε PI έλεγχος βασισμένος στον βαθμωτό (Scalar V/f) έλεγχο, με σήμα αρνητικής ανάδρασης ρεύμα ανάλογο του αριθμού και του τετραγώνου του αριθμού των στροφών. Μελετήθηκε η απόκριση του κινητήρα και για τους δύο ελέγχους για διαφορετικές τιμές των παραμέτρων KP και KI, και διερευνήθηκε ποιες είναι αυτές ώστε να έχουμε βέλτιστη απόκριση. Συγκεκριμένα ποιες παρουσιάζουν την μικρότερη υπερύψωση, τον μικρότερο χρόνο αποκατάστασης, το μικρότερο σφάλμα μόνιμης κατάστασης. Επίσης εξετάστηκε η επίδραση της κάθε παραμέτρου στην διαμόρφωση της εσωτερικής ενέργειας του κινητήρα. / This diploma thesis forms a study on control techniques of induction motors which comes with the intention to explore the effets of different signals of feedback (proportional to the number of revolutions and to the square of the number of revolutions) on the output of the motor. For this purpose sedulous analysis of relevant theory was carried out, passivity of electromechanical systems was studied, a specific electronic commutator was used and a converter of constant current signal proportional to the number of revolutionsand to the square of the number of revolutions was developed. In this thesis a PI controller based on the Scalar V/f control with a signal of current of negative feedback was examined. The output of the motor for both the controls aid for different values of the parameters KP and KI was examined, and it was investigated which of them lead to an optimal output of the motor. It was studied more specifically which of them result in the optimal overshoot, settling time and the error of the permanent mode. Furthermore, it was inquired the impact of its parameter on the modulation of the intrinsic power of the motor.

No description available.

The present thesis deals with the development and performance analysis ofanisotropy-resolving models for the small, unresolved scales (”sub-grid scales”,SGS) in large eddy simulation (LES). The models are characterised by a descriptionof anisotropy by use of explicit algebraic models for both the subgridscale(SGS) stress tensor (EASSM) and SGS scalar flux vector (EASSFM). Extensiveanalysis of the performance of the explicit algebraic SGS stress model(EASSM) has been performed and comparisons made with the conventionalisotropic dynamic eddy viscosity model (DEVM). The studies include LES ofplane channel flow at relatively high Reynolds numbers and a wide range ofresolutions and LES of separated flow in a channel with streamwise periodichill-shaped constrictions (periodic hill flow) at coarse resolutions. The formersimulations were carried out with a pseudo-spectral Navier–Stokes solver, whilethe latter simulations were computed with a second-order, finite-volume basedsolver for unstructured grids. The LESs of channel flow demonstrate that theEASSM gives a good description of the SGS anisotropy, which in turn gives ahigh degree of resolution independence, contrary to the behaviour of LES predictionsusing the DEVM. LESs of periodic hill flow showed that the EASSMalso for this case gives significantly better flow predictions than the DEVM.In particular, the reattachment point was much better predicted with the EASSMand reasonably well predicted even at very coarse resolutions, where theDEVM is unable to predict a proper flow separation.The explicit algebraic SGS scalar flux model (EASSFM) is developed toimprove LES predictions of complex anisotropic flows with turbulent heat ormass transfer, and can be described as a nonlinear tensor eddy diffusivity model.It was tested in combination with the EASSM for the SGS stresses, and itsperformance was compared to the conventional dynamic eddy diffusivity model(DEDM) in channel flow with and without system rotation in the wall-normaldirection. EASSM and EASSFM gave predictions of high accuracy for meanvelocity and mean scalar fields, as well as stresses and scalar flux components.An extension of the EASSM and EASSFM, based on stochastic differentialequations of Langevin type, gave further improvements. In contrast to conventionalmodels, these extended models are able to describe intermittent transferof energy from the small, unresolved scales, to the resolved large ones.The present study shows that the EASSM/EASSFM gives a clear improvementof LES of wall-bounded flows in simple, as well as in complex geometriesin comparison with simpler SGS models. This is also shown to hold for a widerange of resolutions and is particularly accentuated for coarse resolution. The advantages are also demonstrated both for high-order numerical schemes andfor solvers using low-order finite volume methods. The models therefore havea clear potential for more applied computational fluid mechanics. / <p>QC 20140304</p> / Explicit algebraic sub-grid scale modelling for large-eddy simulations

No description available.

The main objective of this research is the study of the magnetization of ferromagnetic spheres in the presence of external magnetic fields. The exact analytical solutions derived in this thesis are benchmark solutions, valuable in testing the correctness and accuracy of various approximate models and numerical methods. The total scalar magnetic potential outside the spheres, related to the magnetic field intensity, is obtained by the superposition of the potentials due to all spheres and the potential corresponding to the external field. The translational addition theorems for scalar Laplacian functions are used to solve boundary value by imposing exact boundary conditions. The scalar magnetic potential inside each sphere, related to the magnetic flux density, also satisfies the Laplace equation, which is solved by imposing the boundary conditions known from the solution of the outside field. Finally, the expressions derived are used to generate numerical results of controllable accuracy for field quantities.

The thesis examines the economic integration process of refugees in rural Sweden, and its relation to geographical mobility. The mechanisms behind the integration process are explored through the concepts of networks, social bridge, and scalar. It is concluded that having a function that plays the role of a social bridge within networks positively affect the economic integration process for refugees. Factors that provide fundamental conditions for the function of a social bridge is identified to be cultural understanding and trustworthiness. The thesis highlights the spatial aspects of the case study area by considering networks between different scalar of global, national, and local. Through analyzing the positioning of the locality, relations are found with characteristics of refugees coming to the place. Those refugees mismatch with the local labor demand, yet they have positive impacts on the location in terms of a demographic aspect and internationalization opportunities. Under this condition, a social bridge is understood to be vital for overcoming the gap between the labor demands and a welcoming attitude toward refugees. As social bridge fosters interactions between refugees and society, it also has a positive effect on refugees’ mobility and attitude toward a place. Interaction opportunities provide a base for a new identity formation for refugees, which is essential to generate a sense of home. Feeling the place to be one’s home contributes to refugees staying. A critical realistic approach has been chosen as the way of studying integration process. By means of statistical data, employment patterns are explored in this area. A semistructured interview study was used to analyze the networks in depth.